Руководство по эксплуатации Toyota

Краткое содержание страницы № 1

I. Remove the throttle shaft nut and lock washer from the throttle shaft. Install the Bracket- Throttle Lever
on the throttle shaft. Reinstall the lock washer and hex nut, and torque the nut to 60-72 In/Lbs (5-6Ft./Lbs),
See Figure I.
NOTE: Start nut by hand first to prevent cross threading, DO NOT OVERTIGHTEN HEX NUT .
Loosen This Nut
ONLY
-=c:~
Throttle ~
Body =- -
i~'
~,I-
Pulley = (.
I!
Assembly /h 118" of Cable Housing
~
LL,..
Vi
~(-
~
1ff~:st B.~,-.
T-"--.
~ Snap-In Adaptor
--~
Bracket- Th

Краткое содержание страницы № 2

c-\ 7/16" Box End ~ Wrench ---r: ~L I """' Cruise Control Nut and Washer Cable Assembly 114-20 FIGURE 2 .After Threading Cable 5. To use that Snap-In adaptor, it will be necessary to fonn threads on the end of the Cruise Control Cable. This is accomplished by placing the 1/4"-20 Nut and Washer Assembly on the end of the Cruise Control Cable with your fingers, then use a 7/16" box end wrench and turn clockwise, until the desired amount of threads have been fonned as shown in Figure 2. 6. After th