Руководство по эксплуатации Seagate CHEETAH ST336807LW/LC

Краткое содержание страницы № 1

 The host system’s SCSI controller usually uses SCSI ID 7.
 If you have an LC model drive, the hos t normally sets the ID over the I/O
interface, so you don’t need to worry about this step.
 If you have an LW model drive, so me systems provide a cable designed
to connect to the J5 jumper block on the drive to remotely set the ID. You
can connect this cable to J5 and use the host-provided remote switch to
Cheetah 10K.7 36GB SCSI Installation Guide
set the SCSI ID. This J5 connector is not pres

Краткое содержание страницы № 2

necessary to format a drive that previously has been used to J2 Drive with Pin 1 store data, unless your intention is to erase all user data. HDA up, PCB down, viewed ® Seagate is not responsible for lost user data. from front Pin 1 Reserved Positions HDA Cheetah 10K.7 disc drives are designed to operate with a variety of operat- Delay Motor Start option (valid ing systems. Please refer to your system or SCSI controller manual for only if the Enable Motor Start J6 jumper is not connected) L