Краткое содержание страницы № 1
CH-258
Cyborg
USER MANUAL
th
Chauvet, 3000 N 29 Ct, Hollywood, FL 33020 U.S.A
(800) 762-1084 (954) 929-1115
FAX (954) 929-5560
www.chauvetlighting.com
2006-05-04/23:59
Краткое содержание страницы № 2
TABLE OF CONTENT TABLE OF CONTENT ...................................................................................................................................................... 2 BEFORE YOU BEGIN ...................................................................................................................................................... 3 WHAT IS INCLUDED............................................................................................................................
Краткое содержание страницы № 3
BEFORE YOU BEGIN What is included 1 x Cyborg (CH-258) Power cord with plug 2 x 64514 300w lamp Warranty Card & Manual Unpacking Instructions Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the
Краткое содержание страницы № 4
INTRODUCTION Features 8 Multicolored lenses 16 rotating beams Built-in microphone and sound sensitivity knob Beams rotate and criss - cross to the music Wide area light coverage Fan cooled Product Overview Top View Bottom view Voltage switch Fuse and power connector Sound sensitivity knob Microphone Hanging Bracket Fixture top cover removed for lamp access CH-258 User Manual 4 2006-05-04/23:59
Краткое содержание страницы № 5
SETUP Lamp You will need to install a lamp prior to the initial operation of the fixture. Two 64514 300w halogen lamp are included. This lamp is used on both the 115V and 230V versions of the Cyborg Warning! When replacing the lamp, please wait 15 minutes after powering down to allow the unit to cool down! Always disconnect from main power prior to lamp replacement. For lamp installation in 230V environments please read Lamp (In-Series) Wiring in the Appendix section of this manua
Краткое содержание страницы № 6
OPERATING INSTRUCTIONS The Cyborg is a high output sound activated effect light. It produces an old favored mushroom like light movement but uses a new high polished aluminum reflector for a unique and brilliant beam pattern. The Cyborg is equipped with an internal microphone and a sound sensitivity knob. The user can adjust the sensitivity of the microphone for obtaining optimum sound activated response of its movement. Whether used in a mobile or permanent environment, you may fin
Краткое содержание страницы № 7
APPENDIX General Maintenance To maintain optimum performance and minimize wear fixtures should be cleaned frequently. Usage and environment are contributing factors in determining frequency. As a general rule, fixtures should be cleaned at least twice a month. Dust build up reduces light output performance and can cause overheating. This can lead to reduced lamp life and increased mechanical wear. Be sure to power off fixture before conducting maintenance. Unplug fixture from power. Us
Краткое содержание страницы № 8
Appendix General Troubleshooting Applies to Foggers Dimmers Symptom Solution(s) Lights & Snow Controllers & Chaser Auto shut off Check fan thermal switch reset Beam is very dim or not Clean optical system or replace lamp bright Check 220/110v switch for proper setting Breaker/Fuse keeps Check total load placed on device blowing Chase is too slow Check users manual for speed adjustment Device has no power Check for power on Mains. Check devices fus
Краткое содержание страницы № 9
Appendix Lamp (in-series) Wiring for 230V Operation In prior tests of the 230V version of the 64514 known as the 64516 or 64515, failure of the lamp was common place due to rapid fixture movement during normal operations and penetrating sound waves produced in low frequency based music. Many customers around the world in places where power is served at 230V or 240V have noticed that connecting the 64514 (120V) lamps in series is the most effective and economical method. Tests have
