Краткое содержание страницы № 1
Portable Projector
LT265/LT245
User’s Manual
Краткое содержание страницы № 2
Important Information Safety Cautions Precautions Please read this manual carefully before using your NEC LT265/LT245 Projector and keep the manual handy for future reference. Your serial number is located on the bottom of your projector. Record it here: CAUTION To turn off main power, be sure to remove the plug from power outlet. The power outlet socket should be installed as near to the equipment as possible, and should be easily accessible. CAUTION TO PREVENT SHOCK, DO NOT OPEN THE CABINET. N
Краткое содержание страницы № 3
Important Information RF Interference (for USA only) WARNING The Federal Communications Commission does not allow any modifications or changes to the unit EXCEPT those specified by NEC Solutions (America), Inc. in this manual. Failure to comply with this government regulation could void your right to operate this equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide re
Краткое содержание страницы № 4
Important Information Fire and Shock Precautions 1. Ensure that there is sufficient ventilation and that vents are unobstructed to prevent the build-up of heat inside your projector. Allow at least 4 inches (10 cm) of space between your projector and a wall. 2. Prevent foreign objects such as paper clips and bits of paper from falling into your projector. Do not attempt to retrieve any objects that might fall into your projector. Do not insert any metal objects such as a wire or screwdriver into
Краткое содержание страницы № 5
Important Information Lamp Replacement •To replace the lamp, follow all instructions provided on page 119. • Be sure to replace the lamp when the message “The lamp has reached the end of its usable life. Please replace the lamp.” appears. If you continue to use the lamp after the lamp has reached the end of its usable life, the lamp bulb may shatter, and pieces of glass may be scattered in the lamp case. Do not touch them as the pieces of glass may cause injury. If this happens, contact your NEC
Краткое содержание страницы № 6
Table of Contents Important Information......................................................................... i 1. Introduction ...................................................................................... 1 What's in the Box? ........................................................................................................ 2 Introduction to the Projector ......................................................................................... 3 Part Names of the Projecto
Краткое содержание страницы № 7
Table of Contents Correcting Horizontal and Vertical Keystone Distortion (Cornerstone) ....................... 43 Making Freehand Drawings on a Projected Image (ChalkBoard) .............................. 46 Storing Images Displayed on the Projector on the PC card or USB Memory (Capture) .......... 47 Preventing Unauthorized Use of the Projector ........................................................... 48
Using a USB Memory Device or USB Memory Card Reader ............................
Краткое содержание страницы № 8
1 Introduction ○○○○○○○○○○○○○○○○○○○○○○○○○○○ ○○○○○○○○○○○○○ What's in the Box? ....................................................... 2 Introduction to the Projector ........................................ 3 Part Names of the Projector ........................................ 5 Carrying the Projector ............................................................................................ 5 Top Features .....................................................................................
Краткое содержание страницы № 9
Quick Connect Guide NEC Software Utility Installation Guide Important Information 1. Introduction What's in the Box? Make sure your box contains everything listed. If any pieces are missing, contact your dealer. Please save the original box and packing materials if you ever need to ship your Projector. Projector Soft carrying case (24BS7114) Lens cap (24FT9351) Remote control Batteries (AAA 2) Remote mouse receiver (7N900491) (7N900561) Power cable RGB/VGA signal cable (7N080204) US (7N52003
Краткое содержание страницы № 10
1. Introduction Introduction to the Projector This section introduces you to the LT265/LT245 Projector and describes key features and controls. Congratulations on Your Purchase of the LT265/LT245 Projector The LT265/LT245 is a sophisticated XGA projector that produces an enhanced display. With the LT265/LT245 you will be able to project images up to 500” (measured diagonally). Enjoy crisp and sharp large screen display from your PC, workstation or Macintosh computer, DVD player, VCR, satellite
Краткое содержание страницы № 11
1. Introduction •Free downloadable Software Geometric Correction Tool 2.0. Corrects the geometry of an image projected onto a cylindrical, spherical or corner screen via serial connection. For additional information visit: US : http://www.necvisualsystems.com Europe : http://www.neceurope.com/ Global : http://www.nec-pj.com/ About this user's manual The fastest way to get started is to take your time and do everything right the first time. Take a few minutes now to review the user's manual. This
Краткое содержание страницы № 12
1. Introduction Part Names of the Projector Controls Zoom Lever (See page 7) (See page 32) Focus Ring (See page 32) Built-in Security Slot ( )* Remote Sensor (See page 12) Ventilation (inlet) Ventilation (outlet) Heated air is exhausted from here. Carrying Handle Adjustable Tilt Foot Lever (See page 31) Lens Adjustable Tilt Foot Lens Cap (See page 31) * This security slot supports the MicroSaver® Security System. MicroSaver® is a registered trademark of Kensington Microware Inc. The logo is t
Краткое содержание страницы № 13
1. Introduction Monaural Speaker (2W) PC Card Eject Button PC Card Slot Lamp cover (See page 119) Ventilation (outlet) Remote Sensor (See page 12) Lamp cover screw Rear Foot Rear Foot Rotate to make the projector level. AC Input (See page 31) Connect the supplied power cable's three-pin plug here, and plug the other end into an active wall outlet. Main Power Switch (See page 26) When you plug the supplied power cable into an active wall outlet and turn on the Main Power switch, the POWER indicat
Краткое содержание страницы № 14
E N T E R U N 1. Introduction Top Features 9 10 4 5 11 SOURCE AUTO ADJUST SELECT LAMP 2 STATUS 3D REFORM ON/STAND BY POWER PC CARD 6 7 8 12 1 3 1. POWER Button (ON / STAND BY) 6. PC CARD Access Indicator Use this button to turn the power on and off when the Lights while accessing a PC card. main power is supplied and the projector is in standby mode. 7. ENTER Button NOTE: To turn on the projector, press and hold this button Executes your menu selection and activates items for a minimum of two se
Краткое содержание страницы № 15
1. Introduction Terminal Panel Features 13 12 11 10 9 3 5 AUDIO OUT PC CARD LAN USB R AUDIO IN L VIDEO IN S-VIDEO IN PC CONTROL COMPUTER 1 IN AUDIO IN COMPUTER 2 IN MONITOR OUT 8 7 6 1 2 4 1. COMPUTER 1 IN / Component Input Connector 6. S-VIDEO IN Connector (Mini DIN 4 Pin) (Mini D-Sub 15 Pin) Here is where you connect the S-Video input from an external source like a VCR. Connect your computer or other analog RGB equip- ment such as IBM compatible or Macintosh comput- NOTE: S-Video provides mo
Краткое содержание страницы № 16
1. Introduction Terminal Panel Features 13 12 11 10 9 3 5 AUDIO OUT PC CARD LAN USB R AUDIO IN L VIDEO IN S-VIDEO IN PC CONTROL COMPUTER 1 IN AUDIO IN COMPUTER 2 IN MONITOR OUT 8 7 6 1 2 4 12. PC CARD Eject Button Press to eject a PC card partially. 13. PC CARD Slot Insert a PC memory card or NEC optional wireless LAN card here. 9
Краткое содержание страницы № 17
1. Introduction Part Names of the Remote Control 1. Infrared Transmitter/Laser Pointer 1 Transmits an infrared signal when any button other than LASER is pressed. 2 OFF ON Direct the remote control toward the remote sensor POWER 3 4 on the projector cabinet. LASER MAGNIFY PAGE 6 Beams a laser light when the Laser button is pressed. UP POINTER 5 8 CAUTION: DOWN * Do not look into the laser pointer while it is on. 7 * Do not point the laser beam at a person. 9 10 2. LED 11 12 Flashes when any bu
Краткое содержание страницы № 18
1. Introduction 23. FREEZE Button 10. Select Button This button will freeze a picture. Press again to re- This button is used for projector’s menu operation and sume motion. See page 39. moving the magnified image. This button also works as a computer mouse when 24. HELP Button the supplied remote mouse receiver is connected with Provides the Information screen. See page 40. your computer. See page 42. 25. ASPECT Button 11. ENTER Button Press this button to display the Aspect Ratio select Execut
Краткое содержание страницы № 19
1. Introduction Battery Installation 1 2 3 Slip the cover back over the bat- Remove the battery cover. Remove both old batteries and teries until it snaps into place. NOTE: Do not pull the battery install new ones (AAA). Ensure that you have the batteries' po- NOTE: Do not mix different types of cover by force. Doing so can larity (+/ –) aligned correctly. batteries or new and old batteries. result in it coming off. 2 2 1 1 Operating Range for Wireless Remote Control 7m/22 feet 7m/22 feet 30° 30
Краткое содержание страницы № 20
2 Installation and Connections ○○○○○○○○○○○○○○○○○○○○○○○○○○○ ○○○○○○○○○○○○○ Setting Up the Screen and the Projector ................... 14 Selecting a Location ............................................................................................. 14 Throw Distance and Screen Size ......................................................................... 15 Making Connections .................................................. 17 Enabling the computer’s external display ....................
