Краткое содержание страницы № 1
DV354
Owner’s Manual
Thank You!
Thank you for choosing a JENSEN product. We’ve tried to make the instructions in this owner’s
manual clear and easy to follow. If you take a few minutes to look through it, you’ll learn how to use
all of the features of your new JENSEN DV354 Mobile Multimedia DVD/CD/MP3 Player for
MODE
maximum enjoyment.
VOL
VIDEO IN 2 L AUDIO IN 2 R
Introduction ....................................................................................................................
Краткое содержание страницы № 2
DV354 CAUTION: This mobile DVD player is a Class I laser product that uses a visible/invisible Introduction laser beam which could cause hazardous radiation exposure if improperly directed. Be Congratulations on your purchase of the JENSEN DV354 Mobile Multimedia DVD/CD/MP3 Player. sure to operate the mobile DVD player as instructed. Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous Features radiation exposure. Do not open c
Краткое содержание страницы № 3
DVD / CD / MP3 PLAYER IR MODE VOL VIDEO IN 2 L AUDIO IN 2 R SEL MUTE DVD / CD / MP3 PLAYER IR MODE VOL VIDEO IN 2 L AUDIO IN 2 R SEL MUTE DV354 CAUTION! Be careful not to damage the vehicle’s wiring. Installation 3. Place the unit in front of the dashboard opening so the wiring can be brought through the DIN Front-Mount Installation mounting sleeve. 1. Use the supplied release keys to remove the half-sleeve from the unit. 4. Complete wiring connections (see “Wiring” on page 5). 5. After comple
Краткое содержание страницы № 4
DVD / CD / MP3 PLAYER IR MODE VOL VIDEO IN 2 L AUDIO IN 2 R SEL MUTE DVD / CD / MP3 PLAYER IR MODE VOL VIDEO IN 2 L AUDIO IN 2 R SEL MUTE DV354 DIN Rear-Mount Installation Removing the Unit With some vehicles, you can use the screw holes located on both sides of the unit to fasten the 1. Make sure the ignition is turned off, then disconnect the cable from the vehicle battery’s unit to the factory radio mounting brackets supplied with your vehicle. To install this unit using negative (-) termina
Краткое содержание страницы № 5
DV354 Wiring Power/Accessory Connections 1. P.A. – Connect to PADIN4. 2. REMOTE CONTROL EXTENDER – Position extender where you are likely to use the remote control. Point remote at eye to control the unit. 3. CONSTANT POWER WIRE (yellow) – Connect the 12V PLUS constant 1 power wire to a live 12 volt wire in the vehicle. Before making a connection, check that the wire you intend to connect it to is always live, even when the car’s ignition is turned off. If a live wire is not found, route the w
Краткое содержание страницы № 6
YELLOW YELLOW RED WHITE RED WHITE YELLOW DV354 Audio/Video Connections NOTE: When replacing a fuse, be sure to use correct type and amperage to avoid damaging the DVD player. The DV354 uses one 3 amp and one 0.5 amp ATC fuse, located in the black filter boxes in-line with the power wires. 6
Краткое содержание страницы № 7
DV354 Controls and Indicators The buttons located on the unit and the remote controls that perform the same function are Remote Control Operation assigned the same number for reference on the diagrams and in the text. 18 Front Panel Operation POWER EJECT 1 3 11 1 16 12 2 3 17 6 DISPLAY PROGRAM MUTE MODE 11 21 REPEAT ANGLE 22 SHUFFLE A-B SUBTITLE 19 23 MODE 25 20 MENU SETUP ZOOM VOL VIDEO IN 2 L AUDIO IN 2 R 5 26 24 RESUME SEL MUTE OK 27 29 30 AUDIO TITLE EQ SEL 10 31 32 33 10 9 8 7 6 5 4 13 14
Краткое содержание страницы № 8
DV354 Remote Control Functions Changing the Battery The remote control uses a CR2025 3V button cell lithium battery. The battery compartment is Ref # Button Function located on the back of the remote control near the bottom edge. To replace the battery: 1 Turn the unit ON or OFF /POWER 1. Open the battery compartment cover. 3 Eject the disc 2. Insert the new battery. Make sure that the positive and negative terminals of the battery are /EJECT oriented as indicated. 4 Skip to the next track/cha
Краткое содержание страницы № 9
DV354 Basic Operation Turning the Unit On/Off Reset The RESET button (16) is located on the front of the unit. You should engage the RESET button Press the POWER button (1) on the front panel or remote control to turn the unit on/off. only in the following situations: Inserting a Disc • After initial installation when all wiring is complete Insert a disc, label side up, into the disc slot (12). The player will start playback automatically. • If all function buttons become inoperable Ejecting a
Краткое содержание страницы № 10
DV354 • DVD: PLAY > SF 1/2X > SF 1/3X > SF 1/4X > SF 1/5X > SF 1/6X > SF 1/7X > SR 1/2X > SR • Press the A-B button again once you reach the desired end point (BRPT) of the repeated 1/3X > SR 1/4X > SR 1/5 > SR 1/6X > SR 1/7X > PLAY section. The selected portion of the DVD will now repeat continuously. • Press the A-B button again to cancel the A-B section setting and stop repeat play. • VCD: PLAY > SF 1X > SF 2X > SF 3X > STEP BWD Goto Search Pausing Playback During DVD or VCD playback, perf
Краткое содержание страницы № 11
DV354 Title Number, Total Title Number, Chapter Number, Total Chapter Number of this Title of the disc SINGLE REMAIN currently being played will be shown on the screen, along with the elapsed time. – 00:03:15 2. Press DISPLAY for the second time: TRACK: 01/14 3. Press DISPLAY for the third time: TOTAL ELAPSED 3. Press DISPLAY for the third time: – 00:00:25 CHAPTER ELAPSED TRACK: 01/14 – 00:00:24 4. Press DISPLAY for the fourth time: 4. Press DISPLAY for the fourth time: TOTAL REMAIN TITLE REMAIN
Краткое содержание страницы № 12
DV354 NOTE: During VCD playback you can press the AUDIO button (31) on the remote control during playback to switch the sound between mono and stereo sound in the following order: MONO LEFT > MONO RIGHT > STEREO. Menu Function Press the MENU button (24) on the remote control while the disc is playing to display the disc root menu. You can navigate with the remote control navigation keys and select a feature with the OK button (30) on the remote control. Title Menu Function If the DVD has mul
Краткое содержание страницы № 13
DV354 DVD SETUP MENU During disc play, press the DVD SETUP button (29) on the remote control to access the SYSTEM Table 1: System Setup Menu SETUP menu. RATING 1 KID SAFE Select the appropriate rating level for the intended audi- ence. 2 G SYSTEM LANGUAGE AUDIO You may override higher ratings by using your pass- 3 PG word. 4 PG13 5 PG-R 6 R TV SYSTEM 7 NC-17 SCREEN SAVER 8 ADULT TV TYPE DEFAULT RESTORE Select “Reset” to restore the factory default settings for PASSWORD the Rating system only. R
Краткое содержание страницы № 14
DV354 Table 1: System Setup Menu Disc Symbols and Properties SUBTITLE ENGLISH Choose the language you would like subtitles to appear Table 2: Disc Properties LANG in (if available) GERMAN NOTE: Subtitles are DVD dependent and not all lan- Symbol 12cm Disc Properties Max Play Time SPANISH guages may be supported. (MPEG 2 Method) FRENCH Single side single layer (DVD-5) 133 minutes Single side double layer (DVD-9) 242 minutes PORTUGUESE Double side single layer (DVD-10) 266 minutes Double side dou
Краткое содержание страницы № 15
DV354 TROUBLESHOOTING Problem Cause Corrective Action Unit will not power on Radio Fuse blown Install new fuse with correct rating Car battery fuse blown Install new fuse with correct rating Illegal operation Press the RESET button located in the bottom right corner of the front panel Remote control does not function Battery depleted Replace battery with new one Battery installed incorrectly Remove battery and install correctly Poor sound quality or distortion Pirated disc is in use Use original
Краткое содержание страницы № 16
DV354 Specifications Limited Warranty Supply Voltage: 12V DC (11V-15V), negative ground 90 Day / 12 Month Limited Warranty Current Consumption: Less than 2A AUDIOVOX SPECIALIZED APPLICATIONS, LLC (the Company) warrants to the original retail Signal System: Composite video 1.0Vp-p 75ohms purchaser of this product that should this product or any part thereof, under normal use and Discs Played: conditions, be proven defective in material or workmanship within 90 days from the date of original 1
