Краткое содержание страницы № 1
BP68-00493D-00Eng(cover) 9/9/05 8:54 AM Page 3
Owner’s Instructions
HL-R4262W
HL-R4662W
HL-R5062W
HL-R5662W
HL-R6162W
This device is a Class B digital apparatus.
Register your product at www.samsung.com/global/register
Краткое содержание страницы № 2
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 2 Table of Contents Your New Wide TV ............................................................................................6 Replacing the Lamp................................................................................................6 List of Features.......................................................................................................8 Accessories ........................................................................
Краткое содержание страницы № 3
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 3 Special Features ...............................................................................................46 Customizing Your Remote Control ..........................................................................46 Remote Control Codes..........................................................................................47 Fine Tuning Channels ...........................................................................................4
Краткое содержание страницы № 4
SAMSUNG BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 4
Краткое содержание страницы № 5
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 5 Your New Wide TV
Краткое содержание страницы № 6
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 6 Your New Wide TV Replacing the Lamp •Why do I need to replace the lamp? The lamp used in a projection TV has a limited lifespan. For the best screen quality it needs to be replaced periodically. After replacing the lamp, the screen quality will be bright and clear as new. • When do I need to replace it? It should be replaced when the screen becomes darker, less clear or when all three LEDs on the front (Timer, Lamp, & Temp.) are flashing. • Check
Краткое содержание страницы № 7
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 7 • For replacement, you will need a 5.91 Inches-long Phillips screwdriver and a pair of gloves. Unplug TV, then use a 1 screwdriver to remove the screw. Remove the Lamp cover. 2 Remove the screws securing 3 the Lamp by using a screwdriver. Separate the Lamp from the 4 engine by holding the handle and pulling it out. To reinstall the Lamp, follow 5 these steps in reverse order. NOTES • Be sure the replacement Lamp is the same type. • After replacin
Краткое содержание страницы № 8
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 8 Your New Wide TV List of Features Your TV was designed and engineered using the latest technology. It is a full-featured, high-performance unit that exceeds industry standards. In addition, it has these special features: • Easy-to-operate remote control • Easy-to-use on-screen menu system you can access from the side panel or remote control • Automatic timer to turn the TV on and off at any time you choose • Adjustable picture and sound settings
Краткое содержание страницы № 9
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 9 Side Panel Buttons The buttons on the right side panel control your TV’s basic features, including the on-screen menu system. To use the more advanced features, you must use the remote control. Press to switch between viewing TV programs and signals from connected components. Press to see the on-screen menu. Press to lower or raise the volume and to select items when using the on-screen menu. Press to change channels and move between items on the
Краткое содержание страницы № 10
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 10 Your New Wide TV Front Panel LED Indicators The three lights on the front panel indicate the status of your TV. POWER Press to turn the TV on and off. Remote Control Sensor Aim the remote control towards this spot on the TV. : Light is On : Light is Blinking : Light is Off TIMER LAMP STAND BY/TEMP Indication Standby state. The picture will automatically appear in about 15 seconds. Auto Timer ON/OFF has been set and the set will automatically
Краткое содержание страницы № 11
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 11 Rear Panel Jacks Use the rear panel jacks to connect components such as a VCR. You can connect different components such as VCRs, Set-Top Box and a DVD player etc., because there are two sets of video input jacks and three set of component video input jacks on the rear panel of your TV. For more information, please see “Connections”. Œ ANTENNA terminals Ø PC AUDIO INPUT jacks Two independent cables or antennas can be connected to these terminals
Краткое содержание страницы № 12
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 12 Your New Wide TV Remote Control You can use the remote control up to about 23 feet from the TV. When using the remote control, always point it directly at the TV. You can also use your remote control to operate your VCR, Cable box, DVD player or some Samsung Set-top boxes. See pages 46~47 for details. 1. POWER 17. ▲, ▼, œ, √, ENTER Turns the TV on and off. Press to select highlight up, down, left, or right. While using the on-screen menus, press
Краткое содержание страницы № 13
BP68-00493D-00Eng(02~13) 9/9/05 8:55 AM Page 13 Installing Batteries in the Remote Control With normal use, the batteries in the remote control should last about a year. If you notice a performance degradation while using the remote, the batteries may need to be replaced. Make sure you replace both batteries and do not mix old and new batteries in the remote control. If you won’t be using the remote control for a long time, remove the batteries and store them in a cool dry place. Slide the ba
Краткое содержание страницы № 14
SAMSUNG BP68-00493D-00Eng(14~23) 9/9/05 8:55 AM Page 14
Краткое содержание страницы № 15
BP68-00493D-00Eng(14~23) 9/9/05 8:55 AM Page 15 Connections
Краткое содержание страницы № 16
BP68-00493D-00Eng(14~23) 9/9/05 8:55 AM Page 16 Connections Connecting VHF and UHF Antennas If you do not have a cable system, you will need to connect an antenna to your TV. Antennas with 300-ohm Flat Twin Leads If your antenna looks like this: it has 300-ohm flat twin leads. Place the wires from the twin leads under the screws on the 1 300-75 ohm adaptor (not supplied). Use a screwdriver to tighten the screws. Plug the adapter into the “ANT 1 IN” terminal on the
Краткое содержание страницы № 17
BP68-00493D-00Eng(14~23) 9/9/05 8:55 AM Page 17 Separate VHF and UHF Antennas If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before connecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics shops). Connect both antenna leads to the combiner. 1 Plug the combiner into the “ANT 1 IN” terminal on 2 the rear panel. English - 17
Краткое содержание страницы № 18
BP68-00493D-00Eng(14~23) 9/9/05 8:55 AM Page 18 Connections Connecting Cable TV and VCR You can connect different cable systems to your TV, including cable without a cable box, and cable with a cable box that descrambles some or all channels. Cable without a Cable Box If you want to connect cable, and you do not need to use a cable box: Plug the incoming cable into the “ANT 1 IN” 1 terminal on the rear panel. Cable with a Cable Box that Descrambles All Channels Find the cable that is connecte
Краткое содержание страницы № 19
BP68-00493D-00Eng(14~23) 9/9/05 8:55 AM Page 19 Connecting a Cable Converter Box This connection allows you to watch cable and premium channels. You should keep your TV selected to “ANT 1 IN” so that you can use the TV features. When viewing premium channels, select “ANT 2 IN” and tune the TV to channel 3 or 4 (whichever channel is vacant in your area), then use the converter box to change channels. You will need two coaxial cables. NOTES • When you use a converter box with your TV, there may
Краткое содержание страницы № 20
BP68-00493D-00Eng(14~23) 9/9/05 8:55 AM Page 20 Connections Connecting a Camcorder The side panel jacks on your TV make it easy to connect a camcorder to your TV. You can use your camcorder to view tapes without using a VCR. Locate the A/V output jacks on the camcorder. They are 1 usually found on the side or Camcorder Output Jacks back of the camcorder. Connect a set of audio cables between the AUDIO 2 IN jacks on the TV and the AUDIO OUT jacks on the TV Side Panel Camcorder camcorder. If
