Краткое содержание страницы № 1
Connections
Introduction Quick Start Setup Useful Features Appendix
Basic Operation
DATA PROJECTOR
MODEL
XG-C465X
XG-C435X
OPERATION MANUAL
Краткое содержание страницы № 2
IMPORTANT • For your assistance in reporting the loss or theft of your Model No.: Projector, please record the Model and Serial Numbers located on the bottom of the projector and retain this information. Serial No.: • Before recycling the packaging, please ensure that you have checked the contents of the carton thoroughly against the list of “Supplied accessories” on page 10. SPECIAL NOTE FOR USERS IN THE U.K. The mains lead of this product is fitted with a non-rewireable (moulded) plug incorpor
Краткое содержание страницы № 3
Introduction Before using the projector, please read this operation manual carefully. Introduction ENGLISH There are two important reasons for prompt warranty registration of your new SHARP Projector, using the REGISTRATION CARD packed with the projector. 1. WARRANTY This is to assure that you immediately receive the full benefit of the parts, service and labor warranty applicable to your purchase. 2. CONSUMER PRODUCT SAFETY ACT To ensure that you will promptly receive any safety notification of
Краткое содержание страницы № 4
WARNING: The cooling fan in this projector continues to run for about 90 seconds after the projector enters the standby mode. During normal operation, when putting the projector into standby mode always use the STANDBY button on the projector or on the remote control. Ensure the cooling fan has stopped before storing the projector in the storage case. DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD. FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILU
Краткое содержание страницы № 5
Introduction How to Read this Operation Manual ••••• In this operation manual, the illustrations and on-screen displays are simplified for explana- tion. This may differ from the actual on-screen display. Using the Menu Screen Adjustment MOUSE/Adjustment buttons ('/"/\/|) buttons ('/"/\/|) ENTER button MENU button Buttons used in this ENTER MENU button button operation Buttons used in this RETURN button RETURN button operation Menu Selections Example: Adjusting “Bright” • This operation can als
Краткое содержание страницы № 6
Contents Preparing Switching the Eco+Quiet Mode .......................... 36 Introduction Selecting the Picture Mode ............................... 36 Resize Mode ...................................................... 37 How to Read this Operation Manual ............. 3 Using the Remote Control as the Wireless Contents.......................................................... 4 Computer Mouse ........................................ 39 How to Access the PDF Operation Manuals ... 6 IMPORTANT SA
Краткое содержание страницы № 7
Introduction Reference Appendix Maintenance ................................................. 55 Replacing the Air Filter ................................ 56 Replacing the Air Filter ...................................... 56 Maintenance Indicators ............................... 58 Regarding the Lamp .................................... 60 Lamp ................................................................. 60 Caution Concerning the Lamp .......................... 60 Replacing the Lamp .......
Краткое содержание страницы № 8
How to Access the PDF Operation Manuals PDF operation manuals in several languages are included in the CD-ROM, so that you can ® ® work with the projector. To utilize these manuals, you need to install Adobe Reader on your ® ® computer (Windows or Macintosh ). ® ® Please download Adobe Reader from the Internet (http://www.adobe.com). Accessing the PDF Manuals ® ® For Windows : For Macintosh : 1 Insert the CD-ROM in the CD-ROM drive. 1 Insert the CD-ROM in the CD-ROM drive. 2 Double click the “My
Краткое содержание страницы № 9
Introduction IMPORTANT SAFEGUARDS CAUTION: Please read all of these instructions before you operate this product and save these instructions for later use. Electrical energy can perform many useful functions. This product has been engineered and manufactured to assure your personal safety. BUT IMPROPER USE CAN RESULT IN POTENTIAL ELECTRICAL SHOCK OR FIRE HAZARDS. In order not to defeat the safeguards incorporated in this product, observe the following basic rules for its installation, use and se
Краткое содержание страницы № 10
IMPORTANT SAFEGUARDS Ensure that you read the following safeguards when setting up your projector. Caution concerning the lamp unit Warning about placing the projector in a ■ Potential hazard of glass par- high position ticles if lamp ruptures. In case of lamp rupture, contact your ■ When placing the projector in a high posi- nearest Sharp Authorized Pro- tion, make certain it is carefully secured to jector Dealer or Service Cen- avoid personal injury caused by the projec- ter for replacement. t
Краткое содержание страницы № 11
Introduction Caution regarding usage of the projector Info ■ When using the projector, take care not to sub- ject it to hard impact and/or vibration, as this • The cooling fan regulates the internal tem- can result in damage. Take extra care with the perature, and its performance is automati- lens. If you are not to use the projector for a cally controlled. The sound of the fan may long time, make certain you unplug the power change during projector operation due to cord from the wall outlet, an
Краткое содержание страницы № 12
Accessories Supplied accessories Two R-6 batteries (“AA” size, UM/SUM-3, RGB cable DIN-D-sub RS-232C HP-7 or similar) (10' (3.0 m)) adaptor Remote control 57 (5 /64" (15 cm)) Power cord* (1) (4) (2) (3) For U.S., Canada, etc. For Europe, except U.K. For U.K., Hong Kong For Australia, New (6' (1.8 m)) (6' (1.8 m)) and Singapore Zealand and Oceania (6' (1.8 m)) (6' (1.8 m)) *Use the powe
Краткое содержание страницы № 13
Introduction Optional lenses ■ Lens Projection distance for 100" screen size Wide-zoom lens (× 1.5 – 1.9) AN-C12MZ 9'11" – 12'5" (3.0 m – 3.8 m) Tele-zoom lens (× 2.2 – 2.8) AN-C18MZ 14'10" – 18'10" (4.5 m – 5.7 m) Tele-zoom lens (× 3.3 – 5.1) AN-C27MZ 22' – 33'11" (6.7 m – 10.3 m) Tele-zoom lens (× 5.2 – 7.2) AN-C41MZ 34'5" – 48'4" (10.5 m – 14.7 m) The standard zoom lens is attached to the projector. The optional lenses from Sharp are also available for specialized application. Please see your
Краткое содержание страницы № 14
Part Names and Functions Numbers in refer to the main pages in this operation manual where the topic is explained. Projector Top View Power indicator 30·58 30·58 Lamp indicator 30 STANDBY/ON button 58 Temperature warning For turning the power on and indicator putting the projector into standby mode. 46 AUTO SYNC button 32 KEYSTONE button For automatically adjusting For entering the Keystone images when connected to Correction mode. a computer. Adjustment buttons 42 43 ENTER button ('/"/\/
Краткое содержание страницы № 15
Introduction Projector (Rear View) Terminals COMPUTER/COMPONENT 2 input terminal 23·25 25 AUDIO input terminal Terminal for Computer RGB and Component signals. Shared audio input terminal for COMPUTER/COMPONENT 2 and DVI-D. AUDIO input terminal 23·25 24·25 DVI-D input terminal Audio input terminal for Terminal for DVI Digital RGB and Digital Component COMPUTER/COMPONENT 1. signals. 28 LAN terminal Terminal for controlling the projector using a computer COMPUTER/COMPONENT 1 23·25 via network.
Краткое содержание страницы № 16
Part Names and Functions Remote Control STANDBY button 30 WIRED R/C JACK For putting the projector into For controlling the projector by connecting standby mode. the remote control to the projector. ON button 30 KEYSTONE button 32 For turning the power on. For entering the Keystone Correction mode. 42 MENU button For displaying adjustment and ENTER button 43 setting screens. For setting items selected or adjusted on the menu. MOUSE/Adjustment buttons 39·42 ('/"/\/|) • For moving the compute
Краткое содержание страницы № 17
Introduction Using the Remote Control Front View Remote control sensor Usable Range 30° The remote control can be used to control 30° the projector within the ranges shown in the 23' (7 m) illustration. 30° Remote control Note signal transmitters • The signal from the remote control can be re- Remote control flected off a screen for easy operation. How- ever, the effective distance of the signal may Rear View Remote control sensor differ depending on the screen material. 30° When using the remot
Краткое содержание страницы № 18
Quick Start This section shows the basic operation (projector connecting with the computer). For details, see the page described below for each step. Setup and Projection In this section, connection of the projector and the computer is explained using one example. 7 STANDBY 37 STANDBY/ON button button 6 INPUT buttons 3 ON button 6 ENTER button 5 Zoom knob 5 Focus ring 6 COMPUTER 1 button 4 Tilt dial 4 Height Adjustment buttons 1. Place the projector facing a screen Page 18 2. Conne
Краткое содержание страницы № 19
Quick Start 4. Adjust the angle Adjust the projector angle ••••• This projector is equipped with an “Auto Keystone Correction” function that automatically corrects ••••• Adjust the projector angle using the Height any trapezoidal distortion within the projected Adjustment buttons. image. ••••• Rotate the Tilt dial to adjust the horizontal tilt of the projector. Height Adjustment buttons Tilt dial Pages 31, 32 5. Adjust the focus and the zoom Bring the projected image into focus Adjust the proje
Краткое содержание страницы № 20
Setting Up the Projector Setting Up the Projector For optimal image quality, position the projector perpendicular to the screen with the projector’s feet flat and level. Doing so will eliminate the need for Keystone correction and provide the best image quality. (See page 32.) Standard Setup (Front Projection) ■ Place the projector at the required distance from the screen according to the desired picture size. (For details, refer to the “SETUP MANUAL” con- tained on the supplied CD-ROM.) Example
