Руководство по эксплуатации Axxess Interface OESWC-7552-RF

Краткое содержание страницы № 1

INSTALLATION INSTRUCTIONS FOR PART OESWC-7552-RF
OESWC-7552-RF
The OESWC-7552-RF is designed to allow you to add steering
wheel control options to 2007 and up Nissan vehicles. The RF
controlled OESWC-7552-RF will allow the customer to adjust their
radio without taking their eyes off the road. The OESWC-7552-RF will
come preprogrammed with your most popular features, volume up,
volume down, seek up, seek down, and source. But with the option of
remapping the buttons to fi t every customer

Краткое содержание страницы № 2

Mounting The RFASWC Transmitter 1 1. Place button pad in the OESWC transmitter with the volume up arrow (^) in the spot where you want volume up to be.(fig. 1) 2. Snap in trim ring to secure keypad in place. (fig. 2) 3. Install the OESWC transmitter in 2 desired place on steering wheel, wrapping the rubber strap around the steering wheel, through the slot, and hook it into the back side of the transmitter. (fig. 3) 4. Cut off the unused portion of the rubber strap and screw in strap 3

Краткое содержание страницы № 3

Wiring The OESWC Interface 1. Connect the red wire to 12 volt accessory 2. Connect the Black wire to ground (you may use the same ground that you use for the aftermarket radio) Setting Up The OESWC Transmitter 1. Press the Red and Green buttons simultaneously for 5 seconds, and then press volume up for two seconds. This will orientate your button direction. 2. Turn on the ignition and press volume up on the OESWC transmitter. This will “marry“ the transmitter to the interface. NOTE: If you

Краткое содержание страницы № 4

for 2 seconds. 5. This is the end of the auto detection stage. If the OESWC TRANSMITTER detected the vehicles radio successfully the led will light up solid red. 6. Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio. So what if the led does not light up solid red? Check out troubleshooting section below. Troubleshooting the Auto Detect Mode So you tried the auto detect feature and at the end the led did not stay on solid r

Краткое содержание страницы № 5

Replacing the battery 1 The battery that is used in the OESWC-RF is a CR2032. To replace it please follow the instructions below. 1. Remove the OESWC-RF from the steering wheel 2 by removing the Phillips screw from the back of the OESWC-RF and undoing the strap. (fig 1) 2. Remove the two Phillips screws that secure the OESWC-RF together. (fig 2) 3 3. Unclip and remove the back cover by sliding the cover towards the outside of the OESWC-RF.(fig 3) 4. Remove the board and replace t

Краткое содержание страницы № 6

NOTES

Краткое содержание страницы № 7

NOTES

Краткое содержание страницы № 8

INSTALLATION INSTRUCTIONS FOR PART OESWC-7552-RF KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.com or call 800-354-6782 for more information and take steps toward a better tomorrow. Metra recommends MECP certified technicians 1-800-221-0932 axxessinterface.com © COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION REV. 3/8/11