Краткое содержание страницы № 1
2
800.967.2346
Краткое содержание страницы № 2
IMPORTANT SAFEGUARDS 11.Grounding or Polarization - Precaution should be taken so that the grounding or polarization means of an appliance is not defeated. 12.Power Cord Protection - Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, receptacles, and the point where they exit from the appliance. 13.Cleaning - The appliance should be cleaned only as recommended by WARNING:
Краткое содержание страницы № 3
TABLE OF CONTENTS Product Introduction..........................................................................................................4-5 Component Guide ST2-XM2 Front Panel...........................................................................................................6 ST2-XM2 Rear Panel............................................................................................................7 ST2-RC Remote Control...........................................................
Краткое содержание страницы № 4
INTRODUCTION DESCRIPTION received through the IR connections on the rear panel from IR repeating system commonly used Thank you for choosing the Russound ST2-XM2 in distributed audio systems. Dual Smart Tuner. Whether you are adding satel- lite radio to an existing system, expanding a CAi If the ST2-XM2 Tuner is part of an RNET-enabled Series system or taking advantage of the system such as the CAV6.6-S2 or CAM6.6, the ® CAV6.6’s robust RNET communication link, the tuner can be controlled throu
Краткое содержание страницы № 5
INTRODUCTION Before using the ST2-XM2 tuner with the RS-232 Controlled System CAV6.6 or CAM6.6, you must assign source The ST2-XM2 Tuner can be controlled using the numbers to Tuner 1 and 2 in the ST2 Setup RNET protocol provided via the RS-232 port on Menu AND complete the CAV6.6 and the rear panel. It can also be controlled by any CAM6.6’s Source Setup procedure to identi- RS-232-enabled control system (e.g., Crestron, fy the tuner as a “Peripheral“ device and AMX). Information on RS-232 opera
Краткое содержание страницы № 6
COMPONENT GUIDE ST2-XM2 FRONT PANEL 1 2 3 XM1 64 : The Groove XM2 4 5 6 7 8 9 10 XM1 64 : The Groove XM2 13 12 11 1 MAIN POWER SWITCH - Turns power on and off 2 POWER ON/OFF LED - Indicates power on or off 3 REMOVABLE COVER LENS - Covers the selection buttons on the tuner 4 BANK SELECT BUTTON - Selects bank 1-6 5 MEMORY SELECT BUTTONS - Sets and selects memory presets 1-6 for each bank 6 IR RECEIVER - Receives IR signal from remote control 7 LCD PANEL - 12-character backlit display shows stati
Краткое содержание страницы № 7
COMPONENT GUIDE ST2-XM2 REAR PANEL 1 2 3 4 5 6 7 8 9 10 Serial# TUNER 2 TUNER 1 ST2 Smart Tuner NEWMARKET, NH U.S.A. AUDIO OUTPUT AUDIO OUTPUT LINK RS-232 KEYPAD PORTS LR LR IR 12VDC 1.25A INTERFACE IR ANTENNA ANTENNA IN OUT XM TUNER 2 XM TUNER 1 1 RNET LINK IN/LINK OUT - Links to other Russound components that are RNET compatible, displays frequency and other information on the UNO keypads 2 RS-232 INTERFACE - The RS-232 Interface allows the tuner to be controlled by PC or other devices that
Краткое содержание страницы № 8
TUNE COMPONENT GUIDE ST2-RC REMOTE CONTROL 1 POWER - Puts the tuner in/out of standby mode 1 2 TUNER CONTROL - Select TUNER 1 (XM1) or TUNER 2 (XM2) and all subsequent button press- es affect that tuner 2 3 NUMERIC INPUT - Number buttons for direct PWR selection of channel, bank, preset 4 BANK SELECT - Used for direct bank selection TUNER 1 TUNER 2 (numeric input 1-6) 3 123 5 TUNE SELECT - Used for direct channel 13 selection (numeric input) 4 56 4 6 TUNE UP/DOWN - Incrementally scrolls through
Краткое содержание страницы № 9
ST2-XM2 SETUP AND CONNECTIONS BASIC CONNECTIONS Power ST2-KP RJ-45 Connection Wiring To power the tuner, connect the 12VDC external power supply by inserting the power supply jack into the power supply connection on the tuner’s rear panel. Audio Output Connect one end of a dual RCA audio cable to the Tuner 1 Audio Output connection. Keep prop- er channel identity. Attach the other end of the RCA cable to the source input of the audio con- trol system. Repeat the same procedure for the Tuner 2 A
Краткое содержание страницы № 10
ST2-XM2 SETUP AND CONNECTIONS CAV6.6 CONNECTIONS UNO-S2 45:XM Cafe keypads 64:The Groove ST2 Tuner 1.25A CAV6.6 RCA Cable Source Connections with CAV6.6 Controller/Amplifier (RNET System) The diagram depicts a typical setup using the ST2-XM2 Tuner with a CAV6.6 amplifier. Each tuner in the ST2 unit must be connected as a separate source for audio inputs. UNO-S2 keypads are connect- ed to the CAV6.6 keypad ports, NOT the ports on the ST2 Tuner. 10
Краткое содержание страницы № 11
ST2-XM2 SETUP AND CONNECTIONS CAi SERIES AND ST2-KP CONNECTIONS Jazz VOLUME SOURCE STORE POWER REMOTE SENSOR ST2-KP CA-LCD2 TUNER 2 TUNER 1 Serial# NEWMARKET, NH U.S.A. ST2 Smart Tuner AUDIO OUTPUT AUDIO OUTPUT LINK RS-232 KEYPAD PORTS LR LR INTERFACE IR IR 12VDC 1.25A ANTENNA ANTENNA IN OUT IR Link Cable RCA Cable RCA Cable CA6.4i NEWMARKET, NH U.S.A. ZONE PREAMP KEYPAD PORTS SOURCE INPUTS OUTPUTS 123456 1 2 1 2 34 ~220-240VAC ~110VAC VARIABLE VARIABLE R R FIXED FIXED L L OUTPUT TO 8 OHM SPEAK
Краткое содержание страницы № 12
ST2-XM2 SETUP AND CONNECTIONS ANTENNA CONNECTIONS XM Antenna XM Signal Strength Mode Connect the included XM antenna for XM recep- To test the XM reception, turn the unit on. When tion to the back panel of the XM module. The the XM radio is powered for the first time, the antenna comes with 20 feet of cable. If this XM service will start playing XM Channel 1, a length is not sufficient, there are aftermarket preview/promotional channel. Verify that Channel antenna kits available for custom leng
Краткое содержание страницы № 13
ST2-XM2 OPERATION XM RADIO OVERVIEW XM Radio Activation XM Radio is over 100 channels of radio broadcasts with the signal delivered by satellite and (depend- ing on location) transferred by terrestrial antennas. The radio is a subscription-based service with a monthly provider fee and an activation charge. XM radio broadcasts several channels for preview but will not broadcast the full range of channels without activation. Activation and billing are handled solely through XM Radio. To activate
Краткое содержание страницы № 14
ST2-XM2 OPERATION XM RADIO MODES XM Radio Modes There are four user “modes” for selecting music and viewing music information on the XM Tuner: Preset (default or normal) Category Search Now Playing Display Preferences. These modes are accessed through certain button and key presses from the tuner panel, remote controls and keypads. When choosing modes, if no choice is made after 20 seconds, the tuner will time out by showing EXIT and return to tuner display and Preset mode. For all XM Modes T
Краткое содержание страницы № 15
MEM ST2-XM2 OPERATION XM RADIO MODES Preset (default) Mode This is the normal operating mode of the XM tuner. In this mode the XM tuner operates similarly to an AM/FM tuner for channel up and down, bank selection and memory presets. Next Preset This button press accesses the next saved preset (6 presets for each bank) in the chosen bank. Previous Preset This button press accesses the previous saved preset in the chosen bank Next Bank This button press accesses the next bank (total of 6 banks).
Краткое содержание страницы № 16
MEM ST2-XM2 OPERATION XM RADIO MODES Category Search Mode (1 1. .C CA AT T S SE EA AR RC CH H) XM Radio is organized by Channel Category (e.g., Rock, Country, News). Within each category is a series of channels (e.g., Top Tracks, Bluegrass Junction, XM Classics). Channel selection in this mode is refined to scrolling only those channels in the selected category. Next Category This button press accesses the next category from the current category. Previous Category This button press accesses
Краткое содержание страницы № 17
MEM MEM MEM MEM ST2-XM2 OPERATION XM RADIO MODES Now Playing Mode (2 2. .N NO OW W P PL LA AY YN NG G) This mode displays information about the current XM selection. Appropriate button presses access the next or previous information item. N NA AM ME E: : Displays the artist’s name, feature name or program name (news, talk, sports). T TI IT TL LE E: : Displays the song title or program title. C CA AT TE EG GO OR RY Y: : Displays the current category. UNO-S1 ST2-XM ST2-RC ST2-KP UNO-S2 UNO-L
Краткое содержание страницы № 18
ST2-XM2 OPERATION FRONT PANEL CONTROLS 4. Push the desired memory preset (M1 through M6) Front Panel Operation button for more than 2 seconds. When the memory Turning the unit on preset is saved, the appropriate preset number (M1 To turn the unit on, push the On/Off button up on the through M6) and SAVED appears on the LCD. The front panel. Pushing the On/Off button down turns the selected station setting reappears and the sound tuner off. resumes after the button is released. Selecting the desi
Краткое содержание страницы № 19
MEM ST2-XM2 OPERATION ST2-RC REMOTE CONTROL number (1 to 6). The memory presets can also be ST2-RC Remote Control Operation accessed by using and to scroll through all The ST2-RC remote control is the only means of remote operation of the ST2-XM2 in a non--RNET sys- presets for the selected bank. tem. The ST2-XM2 front panel displays information for Saving Favorites the tuner that is receiving commands from the ST2- The remote control stores two “favorites” (similar to RC. However, the ST2-RC
Краткое содержание страницы № 20
ST2-XM2 OPERATION ST2-KP KEYPAD CONTROLS ST2-KP Keypad Operation 4 Recalling a Memory Preset 1 Turning the keypad on/off To recall a memory preset, press and release or To activate the ST2-KP, press . Press to power down the keypad display. The keypad remains to scroll through the presets for the selected powered until the ST2-XM2 Tuner is turned off. bank. (Memory presets must be stored for ST2-KP recall) 1 Selecting the desired tuner 5 ST2-KP Keypad Display To select a different tuner, press
