Руководство по эксплуатации Encore electronic ENH908-NWY

Краткое содержание страницы № 1

ENH908-NWY
8 Port Switch

User Guide
0

Краткое содержание страницы № 2

The ENH908-NWY is a powerful, high-performance Fast Ethernet switch, with all ports capable of 10 or 100Mbps auto-negotiation operation (NWay), which means the switch could automatically negotiate with the connected partners on the network speed and duplex mode. It is ideal for micro-segmenting large networks into smaller, connected subnets for improved performance, enabling the bandwidth demanding multimedia and imaging applications. Compared to the shared 10Mbps or 100Mbps networks

Краткое содержание страницы № 3

Please refer to the following table for LED definition 8port LED Status Operation Power Steady Green Power is on Off Power is off Link/Act Steady Green The port is connected Blinking Green The port is transmitting/receiving data. Off No connection Rear Panel 8port 2

Краткое содержание страницы № 4

Connect each station to the switch by twisted-pair cable. Plug one RJ-45 connector into a RJ-45 port of the switch, and plug the other RJ-45 connector into the station’s network adapter. Power on the switch and then system is ready. For cable selection, refer to the following table. In making a switch interconnection, you could use any port to connect another switch with straight or crossover cable. As all the ports support auto MDI / MDI-X function, using a straight cable to

Краткое содержание страницы № 5

Standard IEEE 802.3 10BASE-T IEEE 802.3u 100BASE-TX IEEE 802.3x full duplex operation and flow control Interface 8* 10/100Mbps RJ-45 Fast Ethernet Ports Uplink Auto MDI/MDI-X （Auto crossover ） Network Speed 10/100Mbps & Full/Half duplex mode auto detection MAC Address 1K MAC address entries Table Memory 768KBytes (8port) Power Supply External Power adapter 5V DC 0.6A EMI CE, FCC 4

Краткое содержание страницы № 6

FCC Certifications This Equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio c