Краткое содержание страницы № 1
ISM 482 & ISM 182
Integration Scaling Matrix Switchers
68-576-01 Rev. C
11 04
Краткое содержание страницы № 2
Precautions Safety Instructions • English Warning Power sources This equipment should be operated only from the power source indicated on the This symbol is intended to alert the user of important operating and maintenance product. This equipment is intended to be used with a main power system with a grounded (servicing) instructions in the literature provided with the equipment. (neutral) conductor. The third (grounding) pin is a safety feature, do not attempt to bypass or This symbol is inte
Краткое содержание страницы № 3
AUDIO AUDIO Quick Start — Integration Scaling Matrix Switcher Tip Sleeve Step 4 Installation Tip Cable the switcher for Sleeve audio input. Each input Step 1 Unbalanced Input (high impedance) has a 3.5 mm, 5-pole Turn off power to the ISM 182 or ISM 482 and the Tip captive screw connector for input and output devices, and remove the power Ring Sleeve (s) balanced or unbalanced cords from them. Tip Ring stereo or mono audio Balanced Input input. Connectors are (high impedance) Step 2 included w
Краткое содержание страницы № 4
Quick Start — Integration Scaling Matrix Switcher, cont’d Step 8 Configure the outputs If desired, connect a network WAN or LAN hub, a 1. Press Menu > Menu > Next. control system, or computer to the Ethernet RJ-45 2. Rotate the Adjust knob to select the output port. For connection to a network hub, router, or rate for the output indicated on the LCD (for switch, wire the network interface cable as a example, output 1). straight-through cable. For connection to a computer or control system, wi
Краткое содержание страницы № 5
Table of Contents Chapter 1 Introduction ....................................................................................................... 1-1 About this Manual ............................................................................................................. 1-2 About the Switcher............................................................................................................ 1-2 Features .............................................................................
Краткое содержание страницы № 6
Table of Contents, cont’d Blanking submenu ............................................................................................ 3-12 RGB Delay submenu .......................................................................................... 3-12 Auto Imaging and Auto Memories submenu .................................................... 3-13 Enhanced Mode submenu ................................................................................ 3-13 Pixel Phase submenu ....................
Краткое содержание страницы № 7
Chapter 5 Switcher Software ......................................................................................... 5-1 ® Control Software for Windows .................................................................................. 5-2 Installing the software ...................................................................................................... 5-2 Software operation via Ethernet ...................................................................................... 5-2 Ethe
Краткое содержание страницы № 8
Table of Contents, cont’d Appendix A Ethernet Connection .............................................................................. A-1 Ethernet Link........................................................................................................................ A-2 Ethernet connection ......................................................................................................... A-2 Default address ..........................................................................
Краткое содержание страницы № 9
Integration Scaling Matrix Switcher Chapter One 1 Introduction About this Manual About the Switcher Features
Краткое содержание страницы № 10
Intr Intr oduction, cont’d oduction About this Manual This manual contains installation, configuration, and operating information for the Extron ISM 182 and ISM 482 Integration Scaling Matrix switchers. The ISM 182 and ISM 482 are similar in function and operation; the differences exist in scaling capabilities. In this manual, the terms “switcher” and “ISM” are used interchangeably to refer to either model, except where differences exist, in which case the specific model is noted. Chapter 1 i
Краткое содержание страницы № 11
Projector Projector Extron ISM 482 RS-232 DVD Player LAN/WAN Network/ Internet Codec Extron RGB 112xi VCR Laptop Podium PC Figure 1-1— Typical ISM 482 Integration Scaling Matrix Switcher application The ISM receives and outputs the stereo audio on 5-pole captive screw connectors. For upscaling, the ISM 482 converts the horizontal and vertical sync timing and the number of lines of the lower-resolution video input to match the native resolution of the display. This produces an undistorted, brig
Краткое содержание страницы № 12
Introduction, cont’d Features Inputs — Video inputs — The ISM switches among eight fully-configurable RGB, HDTV component video (ISM 482), component video, S-video, and composite video inputs on five BNC connectors per input. Audio inputs — The ISM switches among eight balanced or unbalanced stereo or mono audio inputs on 5-pole captive screw connectors. Outputs — Video outputs — The ISM outputs individually scaled video signals as RGBHV or RGBS. Two sets of BNC connectors and two 15-pin HD con
Краткое содержание страницы № 13
Test patterns — The switcher features built-in test patterns to aid in monitor or projector set-up and evaluation. Blue mode — The switcher can be set to output the blue video signal only, to help installers calibrate the monitor or projector. ™ Triple-Action Switching (RGB delay) — RGB delay mutes the R, G, and B video planes to blank the screen while the scaler locks to the new sync, so that a noise-filled scramble is not shown on the monitor during the transition. The time delay between the
Краткое содержание страницы № 14
Introduction, cont’d 1-6 Integration Scaling Matrix Switcher Introduction
Краткое содержание страницы № 15
Integration Scaling Matrix Switcher Chapter Two 2 Installation Mounting the Switcher Cabling and Rear Panel Views Configuration
Краткое содержание страницы № 16
Installation, cont’d Installation Mounting the Switcher Four uninstalled rubber feet are included with the switcher . If you are going to rack mount the switcher, mount it before you cable it (see Rack mounting, below), and do not install the rubber feet. If you are not rack mounting the switcher, see Tabletop placement below. Tabletop placement For tabletop placement, install the self-adhesive rubber feet/pads (provided) onto the four corners of the bottom of the switcher. Rack mounting To ra
Краткое содержание страницы № 17
LINK ACT Cabling and Rear Panel Views All connectors are on the rear panel (figure 2-2). 2 4 OUTPUTS INPUTS 12 3 4 5 6 7 8 1 2 1 R/R-Y R/R-Y R/R-Y R/R-Y R/R-Y R/R-Y R/R-Y R/R-Y R R 2 G/Y G/Y G/Y G/Y G/Y G/Y G/Y G/Y G G VID VID VID VID VID VID VID VID B/C B/C B/C B/C B/C B/C B/C B/C B B B-Y B-Y B-Y B-Y B-Y B-Y B-Y B-Y RS-232 100- 240 50/60 Hz 1.2A MAX. H/HV H/HV H/HV H/HV H/HV H/HV H/HV H/HV H/HV H/HV V V V V V V V V V V ETHERNET 1 23 4 5 6 7 8 1 3 5 6 7 Figure 2-2 — ISM 482 rear panel connecto
Краткое содержание страницы № 18
Installation, cont’d Input audio connectors — Connect balanced or unbalanced stereo or mono 3 audio to these 3.5 mm, 5-pole captive screw connectors. Connectors are included with the seamless switcher, but you must supply the audio cable. Figure 2-4 shows how to wire a connector for the appropriate input type and impedance level. High impedance is generally over 800 ohms. 600 ohms Tip Tip Tip Ring Ring Sleeve Sleeve (s) Sleeve (s) Tip Tip Tip Ring Ring Sleeve 600 ohms Unbalanced Input Balanced
Краткое содержание страницы № 19
Output connections The two Output 1 outputs, consisting of five BNC connectors and a 15-pin HD connector, output the identical video signal and the same sync format. The two Output 2 outputs are also identical to each other. Video output BNC connectors— Connect RGB video displays to these two 4 sets of female BNC connectors. Figure 2-6 shows how to connect the various video formats. R R G G B B H/HV H/HV V V RGBHV RGBS Video Video Figure 2-6 — BNC output connections for RGBHV and RGBS video Vid
Краткое содержание страницы № 20
Installation, cont’d Ethernet connection 6 Ethernet port — If desired connect the switcher to an Ethernet LAN or WAN via this RJ-45 connector. Ethernet control allows the operator to control the switcher from a remote location. When connected to an Ethernet LAN or WAN , the switcher can be accessed and operated from a computer running a standard Internet browser. Ethernet connection indicators — The Link and Act LEDs indicate the status of the Ethernet connection. The Link LED indicates that t
