Руководство по эксплуатации Sears FTK-130

Краткое содержание страницы № 1

FTK-127i130 Buitt-in Trim Kit lnstaHtation instructions
For use with the following microwave oven ACM2160A and UMC5200AA
Proper installation is the instailer's responsibility!
Too_s required to perform installation:
Write the model & sedal numbers on the owner's manual,
Phillips Screwdriver
The model number label is }ocated on the oven front=
Saw (Electric or Hand)
Drill with 1/16"and %4" drill bits (Electric or Hand)
UL Listed-For use over electric heat source Tape Measure
Pencil
models
Framing

Краткое содержание страницы № 2

FTK-127!130 Buitt-in Trim Kit installation instructions For use with the following microwave oven ACM2160A and UMC5200AA Electrical rating of this oven: 120 VAC @ 60 Hz WARNING 13A/llOOW If you do not use the microwave oven as instructed, you You need a DEDICATED 120 VAC, 60 Hz, 20 A, could be exposed to excessive microwave energy. fused electrical supply (located in the cabinet with the microwave as close as possible to the Do not expose yourseff to excessive microwave) serving only the microwa

Краткое содержание страницы № 3

FTK-127i130 Buitt-in Trim Kit installation instructions For use with the following microwave oven ACM2160A and UMC5200AA hetallation of Bottom Bracket 3= Remove any oil or dirt on the surface of the microwave oven where ductwork will be secured. 1= Disconnect power from microwave oven before 4= Peel off the protected backing on the double sided proceeding with installation= tape. 2= Remove any loose items from inside the microwave 5= Place the existing screw through the ductwork and oven, start

Краткое содержание страницы № 4

FTK-127/130 Buitt-in Trim Kit installation instructions For use with the following microwave oven ACM2160A and UMC5200AA hstaHing Unit in Cutout Mounting Trim Frame 1. Position trim frame over the microwave oven, 1, Slide microwave oven into cutout verifying alignment of unit is correct, 2. Verify trim frame is level and the microwave oven is centered within the trim frame. 2, Slide unit out to plug the power cord into the outlet, 3, Slide unit into cutout centering the microwave oven in NOTE: C