Краткое содержание страницы № 1
Generators
GENERATOR SET
5.5 HP - RECOIL START - 2200W/2400W RATED
Model 92455
OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
TO PREVENT SERIOUS INJURY OR DEATH,
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.
© ®
Copyright 2004 by Harbor Freight Tools . All rights reserved. No
portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of
Краткое содержание страницы № 2
PRODUCT SPECIFICATIONS Item Description VAC Electrical 115 Volts @ 19 Amps Current Output Specifications 60 Hz Continuous/Rated Wattage: 2,200 Peak Wattage: 2,400 Two 115 VAC, 3-Prong Grounding Outlets One 19 AMP Circuit Breaker VDC Electrical 12 VDC @ 10 Amps Current Output Specifications Voltmeter Equipped 0-150 Volts / 50 Volt Increments Display Lights Red (Run) Generator Type Brushless / Revolving Field / Self Exciting Two Pole / Single Phase Gasoline Engine 5.5 HP / Unleaded G
Краткое содержание страницы № 3
UNPACKING When unpacking, check to make sure all the parts shown on the Parts Lists on pages 18 and 20 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. GENERAL SAFETY RULES WARNING! READ AND UNDERSTAND ALL INSTRUCTIONS Failure to follow all instructions listed below may result in electric shock, fire, and/or serious injury. SAVE THESE INSTRUCTIONS WORK AREA 1. Keep your work area clean and we
Краткое содержание страницы № 4
6. Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and refrigerators. There is an increased risk of electric shock if your body is grounded. 7. Do not expose power tools to rain or wet conditions. Water entering a generator will increase the risk of electric shock. 8. Do not abuse the Power Cords. Never use a Power Cord to carry tools or pull the Plug from an outlet. Keep Power Cords away from heat, oil, sharp edges, or moving parts. Replace damaged Power Cords i
Краткое содержание страницы № 5
17. Do not use the generator if the Power Switch does not turn it on or off. Any generator that cannot be controlled with the Power Switch is dangerous and must be replaced. GENERATOR USE AND CARE 18. Make sure the Power Switch is in its “OFF” position and disconnect the spark plug wire before making any adjustments, changing accessories, or storing the generator. Such preventive safety measures reduce the risk of starting the generator accidentally. 19. Store idle generators out of reach of c
Краткое содержание страницы № 6
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS HEART PACEMAKER PRECAUTION 1. WARNING! People with pacemakers should consult their physician(s) before using this product. Electromagnetic fields in close proximity to a heart pacemaker could cause interference to or failure of the pacemaker. INSTALLATION PRECAUTIONS 1. Ensure installation meets all applicable safety, and local and national electrical codes. Have installation performed by a qualified, licensed electrician and build- ing contrac
Краткое содержание страницы № 7
10. For trailer installation, the Generator should be mounted on the center point of the trailer, over the wheels. 11. Install sound and weather proofing only when it is not raining or snowing to avoid trapping moisture within the Generator’s area. FIRE AND EXPLOSION PRECAUTIONS 1. Gasoline fuel and fumes are flammable, and potentially explosive. Use proper fuel storage and handling procedures. Always have multiple ABC class fire extinguishers nearby. 2. Keep the Generator and surrounding area
Краткое содержание страницы № 8
MECHANICAL PRECAUTIONS 1. ALWAYS make sure the Power Switch is in its “OFF” position. Disconnect the spark plug wire, and allow the Engine to completely cool before carrying out maintenance. 2. Check for damaged parts. Before using the Generator, any part that appears damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment and binding of moving parts, any broken parts or mounting fixtures, and any other condition th
Краткое содержание страницы № 9
NOISE PRECAUTIONS 1. Prolonged exposure to noise levels above 85 dBA is hazardous to hearing. Always wear ANSI approved ear protection when operating or working around the Generator when it is running. ELECTRICAL PRECAUTIONS 1. All connections and conduits from the Generator to the load must only be in- stalled by trained and licensed electricians, and in compliance with all relevant local, state, and federal electrical codes and standards, and other regulations where applicable. 2. The Generato
Краткое содержание страницы № 10
8. Keep all electrical equipment clean and dry. Replace any wiring where the insu- lation is cracked, cut, abraded or otherwise degraded. Replace terminals that are worn, discolored, or corroded. Keep terminals clean and tight. 9. Insulate all connections and disconnected wires. 10. Guard against electric shock. Prevent body contact with grounded surfaces such as pipes, radiators, ranges, and refrigerator enclosures. 11. Use only Class BC or Class ABC fire extinguishers on electrical fires.
Краткое содержание страницы № 11
5. Place the Generator as close as possible to the electrical tools and equipment being powered to reduce the length of extension cords. 6. If the Generator in located indoors the Engine exhaust must be ventilated to the outdoors using leakproof, heat resistant, flexible, metal, flex tubing. GENERATOR SUPPORT AND MOUNTING 1. Mount the Generator on a concrete slab capable of supporting the weight of the Generator. The slab must extend on all sides beyond the Frame (41) by at least one foot. Con
Краткое содержание страницы № 12
ENGINE POWER SWITCH (2) GROUND CONNECTOR (8) #6 AWG GROUNDING WIRE (NOT INCLUDED) GROUNDING ROD (NOT INCLUDED) FIGURE B FUEL GAUGE (34) FUEL TANK CAP (33) FUEL TANK (30) OIL DIPSTICK (65A) FIGURE C SKU 92455 For technical questions, please call 1-800-444-3353. Page 12
Краткое содержание страницы № 13
3. Before the first use, remove the Fuel Tank Cap (33) and fill the Fuel Tank (30) with unleaded gasoline. Then, replace the Fuel Tank Cap. Thereafter, check the Engine’s Fuel Gauge (34) for the amount of unleaded gasoline in the Fuel Tank. If necessary, refill the Fuel Tank with unleaded gasoline. (See Figure C.) To Start The Engine: 1. Make sure the electrical powered tools/equipment that will be used is not plugged in to the Generator. 2. Turn the 115 volt AC Circuit Breaker (5) to its “ON”
Краткое содержание страницы № 14
5. Turn the Engine Power Switch (2) to its “ON” position. (See Figure F.) ENGINE POWER SWITCH (2) ON OFF FIGURE F 6. Hold the Start Handle (41A) loosely and pull it slowly several times to allow the gasoline to flow into the Engine’s carburetor. Then hold the Start Handle firmly and pull the rope hard and fast. Pull the rope all the way out, using two hands if FUEL TANK (32) necessary. If necessary pull the rope several times until the Engine starts. (See Figure G.) 7. Allow the Engine to ru
Краткое содержание страницы № 15
Powering 120 Volt AC Tools And Equipment: 1. Prior to powering tools and equipment, make sure the Generator’s rated voltage, and amperage capacity (115 VAC / 20 AMPs) is adequate to supply all electrical loads that the unit will power. If powering exceeds the Generator’s capacity, it may be necessary to group one or more of the tools and/or equipment for con- nection to a separate generator. 2. Once the Generator is running, simply connect the Power Cords of 115 volt AC powered tools and equip
Краткое содержание страницы № 16
4. Start and run the Engine as previously discussed in this manual. 5. When finished using the Generator, turn the Engine Power Switch (2) to its “OFF” position. Turn the Fuel Valve (40) to its “OFF” position. Then, discon- nect the electrical powered tool or equipment from the Generator’s DC Terminals (7). (See Figure H.) 6. After the Engine and Generator have completely cooled, store the Generator in a safe, clean, dry location (if not already installed in one). 7. NOTE: The Generator featu
Краткое содержание страницы № 17
INSPECTION, CLEANING, AND MAINTENANCE 1. CAUTION! Always make sure the Engine Power Switch (2) is in its “OFF” posi- tion. Disconnect the spark plug wire from the engine and allow sufficient time for the Engine and Generator to completely cool before performing any in- spection, maintenance, or cleaning. 2. Before each use, inspect the general condition of the Generator. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, dam- aged electrical wiring, and
Краткое содержание страницы № 18
PARTS LIST Part # Description Qty. Part # Description Qty. 1 Bolt (M6 x 12) w/Lock Washer 9 22 Bolt (M6 x 172) 4 2 Engine Power Switch 1 23 Bolt (M5 x 20) 4 3 Control Panel 1 24 Connection Board 1 4 Voltmeter 1 25 Nut (M5) 4 5 Circuit Breaker 1 26 Stator 1 6 Outlet 2 27 Rotor 1 7 DC Terminal 2 28 Cooling Fan 1 8 Ground Connector 1 29 Heat Insulation Board 1 9 DC Fuse 1 30 Fuel Tank 1 10 Pilot Light 1 31 Fuel Filter 1 11 Shock Absorber 4 32 Seal Ring 1 12 Shock Absorber Foot 4 33 Fuel
Краткое содержание страницы № 19
ASSEMBLY DIAGRAM SKU 92455 For technical questions, please call 1-800-444-3353. Page 19
Краткое содержание страницы № 20
PARTS LIST - CONTINUED Part # Description Qty. Part # Description Qty. 1A Muffler 1 42A Starting Case Assy. 1 2A Cylinder Head Bolt 4 43A Spiral Spring 1 3A Cylinder Head Cover Bolt 4 44A Starting Wheel 1 4A Cylinder Head Cover 1 45A C-clip 1 5A Lock Nut 2 46A Starting Ratchet 2 6A Adjusting Screw 2 47A Friction Plate Screw 1 7A Rocker Arm 3 48A Cover 1 8A Rocker Arm Bolt 2 49A Starter Pulley 1 9A Valve Push Rod Guiding Board 1 50A Cooling Fan 1 10A Valve Push Rod 2 51A Flywheel Magnet
