Руководство по эксплуатации Manitowoc Ice SN12

Краткое содержание страницы № 1

Manitowoc SN12/SN20 Model Nugget Ice Machines
Cutter Head Replacement Instructions


1. Disconnect water supply.
2. Remove front panel.
3. Move toggle switch to CLEAN position after the 5 minute delay expires. The evaporator and float
chamber will drain.
4. Disconnect power at electrical disconnect.
WARNING
Disconnect power to the ice machine at the electrical disconnect, moving
the toggle switch to the off position will not disconnect line voltage.

Краткое содержание страницы № 2

7. Peel evaporator insulation down to expose 3 bolts securing top cutter head - remove 3 bolts. 7. Use puller to remove cutter head from auger shaft. NOTE: If the bearing is destroyed or the auger heavily damaged from bearing wear contact the Manitowoc service department @ 1-800-545-5720. 8. Install new cutter head and secure with three bolts removed in step 7. Use removable loctite on bolt threads. 9. Reassemble chute assembly and test run ice machine. Manitowoc Foodservice