Dakota Digital MAN#650277 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

1968-77 Chevy Corvette
Dakota Digital Gauge Installation
This sheet covers the installation of the Dakota Digital gauge kit into the original clusters.





1. Remove the clusters from the vehicle. The procedure for the speedometer
and tachometer clusters are the same, but only one side is shown in the
photos.

2. Remove the three screws holding the bezel on to the gauge can. Two are
indicated by the upper arrows in the photo at right; one is on the bottom side
of the can and

ملخص المحتوى في الصفحة رقم 2

6. Remove the center gauge cluster from the vehicle. From the back side, remove the four screws as indicated by the arrows in the photo at left which hold the stock gauges to the bezel. The stock gauge assembly can be set aside. 7. Leave the clear lens and gauge separator plate in the bezel and install the four provided #6-32 x .625” standoffs in the holes that you removed the screws from in the previous step. Take care not to over tighten as the threaded portio

ملخص المحتوى في الصفحة رقم 3

The Odyssey series clock displays the current time in 12 hour format. The high brightness display matches our other Odyssey, STR, and VFD3 series gauges and has the same night brightness dimming capability. Operation: The gauge needs the red, orange, and black wires connected to operate. The red wire should have switched 12 volt power from an ACC. point on the fuse panel. The orange wire should have constant 12 volt power. The black wire should be connected to a good ground point.

ملخص المحتوى في الصفحة رقم 4

Poor ground connection. Move ground to different location Time is not set. Set time. (see instructions) Clock is damaged. Return clock for repair. (see instructions) Clock will not keep time. Orange wire does not have Connect to a location that has power when constant power. the key is on or off. Loose connection on orange Reconnect orange wire. power wire. Poor ground connection. Move ground to different location Clock will not dim. Blue wire i