Turbosound TXD SERIES TXD-115 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Quick Start Guide
TXD series

Models covered by this Quick Start Guide
TXD-081, TXD-121, TXD-151, TXD-252, TXD-12M, TXD-15M, TXD-115, TXD-215, TXD-118, TXD-218.
Thank you for choosing a TURBOSOUND TXD series loudspeaker product for your application. If you would like further
information about this or any other TURBOSOUND product, please contact us. A detailed user manual on this product is
available on our web site at www.turbosound.com
Unpacking the TXD series loudspeaker
After unpack

ملخص المحتوى في الصفحة رقم 2

Quick Start Guide TXD series System Controllers The Turbosound LMS-D24 is a high quality 2-in, 4-out digital crossover designed and pre-configured for use with TXD loudspeakers. This enables you to assemble sound reinforcement systems ranging from a simple two-channel live performance rig or monitor system up to a multi-zone nightclub or entertainment venue. Passive systems without sub-bass FROM MIXER LR L EQ R POWER AMPLIFIER TXD-121 Connect the left and right mixer outputs, via a

ملخص المحتوى في الصفحة رقم 3

Quick Start Guide TXD series Using Passive Speakers with Subwoofers in Bi-amplified Mode TXD series two-way loudspeakers can also be operated in bi-amplified mode together with any of the available subwoofer enclosures. An external 2-in, 4-out crossover such as the LMS-D24 is required with a crossover frequency of 125Hz, 24dB/octave slope, Linkwitz-Riley. To operate TXD systems in bi-amplified mode, it is necessary to by-pass the internal passive crossover in the bass cabinet. To do this

ملخص المحتوى في الصفحة رقم 4

Quick Start Guide TXD series Mounting and Fixing TXD series cabinets are equipped with pole mount sockets to enable use with a range of speaker poles of different lengths. TXD series cabinets can be rigged in permanent installations using optional M10 shoulder eyebolts coupled to the internal rigging points provided on the top and back. Remove the appropriate M10 countersunk screws and replace them with M10 eyebolts, which must have a thread length of at least 18mm. Use the rear rigging