ملخص المحتوى في الصفحة رقم 1 
                    
                        LENNOX HEARTH PRODUCTS
KITS AND ACCESSORIES
STYLE VIEW DOOR KITS
750,215M 
REV. B  08/2007
ChARCOAL AND SATIN PEWTER
INSTALLATION INSTRUCTIONS FOR OPTIONAL STYLE VIEW DOOR KITS FOR USE WITh
LENNOx (ELDV) ELITE™ SERIES AND (MPLDV) MERIT™ PLUS SERIES GAS FIREPLACES
STYLE VIEW DOOR KITS STYLE VIEW DOOR KITS
Cat. No. Model Description Model Series Cat. No. Model Description Model Series
ARCH PANE DESIGN KITS ARCH PANE DESIGN KITS
h3970 APDL35C 35” Arch Doors, Charcoal h6104 APDML30C 30” Arch Doors, 
                    
                    ملخص المحتوى في الصفحة رقم 2 
                    
                        * NOTE: The fireplace is equipped with a unit-mounted ON/OFF switch.   GENERAL INFORMATION In most installations this switch is not used.  If you desire to use the  These decorative screen doors are offered in two attractive finishes and  switch and want to install these Style View Doors, you may desire  fit on the face of the appliance over the glass doorframe. If you encounter  to relocate the switch into the bracket provided on the door frame.   any problems, need clarification of these instr
                    
                    ملخص المحتوى في الصفحة رقم 3 
                    
                        Tabs engage into  hook Doorframe  slots (both sides) Over Glass door Slot  Tab Fireplace Doorframe Locate the doorframe  bracket on the lower  Doorframe front of the doorframe and  Figure 5 - MPLDV Models Bracket lock it behind the cabinet bottom  flange as shown here. Detail Showing  Glass Door Clip  Being Put Into  Locate slot on  Place Between  each side Doorframe And  Glass Door Figure 4 - ELDV Models d. ELDV Models - Locate slots on each side of fireplace  (see Figure 4). e. ELDV Models - H
                    
                    ملخص المحتوى في الصفحة رقم 4 
                    
                        7. Remove the left and right side Style View doors from packaging. Install  them by aligning hinge pins on the doors with the hinge holes on the  doorframe and slide down (see Figure 9 ). Ensure the hinge pins are  fully seated onto the shoulders of the hinge holes.  Note:  For MPLDV 30” models, remove single piece facade panel and  mount the four pins into the hinge shoulders. Insert hinge Pins Into  hinge holes as Shown hinge  Pin  Door Figure 7 - Doorframe Installed Figure 9 ON/OFF Switch ON