QSC Audio DDI-11 دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

DDI-11
DataPort Accessory Card
INSTALLATION GUIDE
*TD-000181-00*
▼ DDI-11
*TD-000181-00*
Preliminary
1

ملخص المحتوى في الصفحة رقم 2

Instructions for the DDI-11 DataPort Accessory Card I. INTRODUCTION 300mA VM1 +15V The DDI-11 DataPort Accessory Card is designed for use with QSC amplifiers equipped with a IM1 CGND DataPort connector. It provide an easy way to exploit the features of the DataPort without using QSControl or an accessory. STBY IN 2+ Through a terminal block with eight screw clamps on the DDI-11, the DataPort offers these IN 2- connections: AGND • Balanced input to Channel 1. IN 1- IM2  Balanced input to Channel

ملخص المحتوى في الصفحة رقم 3

III. INSTALLATION The DDI-11 kit (QSC part # SG-000515-00) includes these items: DDI-11 board Two #4-40 × ¼” black screws Installation guide Use this procedure to install the DDI-11: 1. Turn off the amplifier. 2. Plug the card into the amplifier’s DataPort. Use the two screws on each side of the DataPort to secure it; do not overtighten them. 3. To attach wires to the DDI-11 terminal strip, strip about 5 mm (0.2”) of insulation from the wire. Twist the exposed wire strands together and make sure

ملخص المحتوى في الصفحة رقم 4

QSC Audio Products, Inc., 1675 MacArthur Boulevard Costa Mesa, California 92626 USA PH: (714) 754-6175 FAX: (714) 754-6174 QSControl is a trademark of QSC Audio Products, Inc. “QSC” and the QSC logo are registered with the U.S. Patent and Trademark Office. 4