Dillard's دليل المستخدم

ملخص المحتوى في الصفحة رقم 1

Dillon Die Instructions, May 2007 5/22/07 1:47 PM Page 1
8009 E. Dillon’s Way
illon
Scottsdale, AZ 85260
recision
Technical Support • (800) 223-4570
Products, Inc.
(480) 948-8009 • FAX (480) 998-2786
Dillon’s New Dynamic Pistol Dies
& Three-Die Rifle Die Sets
Instruction Manual, May 2007
Dillon’s “New Dynamic” Pistol Die Sets
Fig 1. Dillon’s New Dynamic Die Set, cut
Fig 1 away so that you can see how they look and
how they operate. From left to right they
are: Full length sizing and de

ملخص المحتوى في الصفحة رقم 2

Dillon Die Instructions, May 2007 5/22/07 1:47 PM Page 2 Fig 2. Your New Fig 2 Dynamic Dies are Fig 4 equipped with Dillon’s unique “snap spring” decap assembly. The spring on this unit compresses as the decap pin pushes against the spent primer. As the spent primer clears the primer pocket, the spring snaps the pin downward, throwing the spent primer off the A Fig 4. Your Dillon Dynamic seating die is pin. This prevents the a snap-together assembly. spent primer from Fig 5. The being drawn b

ملخص المحتوى في الصفحة رقم 3

Dillon Die Instructions, May 2007 5/22/07 1:47 PM Page 3 Fig 6. The turn the seating die down in 1/8 turn incre- double-ended ments and cycle the handle again. Fig 6 seating stem Repeat the above process until the proper can then be seating depth is achieved. removed for Note: One full turn of the die is approxi- cleaning or mately 0.070 of an inch. As you get closer changing by to your desired length do not turn the die pushing out down in more than 1/8 turn increments. the black cross Whe

ملخص المحتوى في الصفحة رقم 4

Dillon Die Instructions, May 2007 5/22/07 1:47 PM Page 4 Dillon Three-Die Rifle Die Sets Bullet Seating Die Stuck Case Hex adjustments Precise, Remover for wrench Our bullet seating die is Uniform internally designed to keep the Taper Crimp bullet straight throughout the Size Die Carbide seating process. Polished Expander 1. Move the handle down, to to a High Ball Micro-Finish raise the platform. 2. Screw the bullet seating die into the bullet seating station on your reloader. Solid, 3. Put a