Inhaltszusammenfassung zur Seite Nr. 1
Tap Master Owners Manual
Advanced Water Filters
®
Tap Master Series
Installation & Service Manual
Tap Master
Tap Master IRON
Tap Master UV
Tap Master ULTRA
Tap Master Artesian
Advanced Water Filters
Where Technology and Water Combine
Perfect Water Technologies, Inc.
Copyright© 2004
Page 16
Customer Service Hotline 1-800-453-4206 Customer Service Hotline 1-800-453-4206
Inhaltszusammenfassung zur Seite Nr. 2
Tap Master Owners Manual Tap Master Owners Manual Page 2 Page 15 Customer Service Hotline 1-800-453-4206 Customer Service Hotline 1-800-453-4206
Inhaltszusammenfassung zur Seite Nr. 3
Tap Master Owners Manual Tap Master Owners Manual system may be discolored due to the presence of carbon from the carbon filters, and a Tap Master Contents: small amount of preservative. This is normal. DO NOT drink the first 6.5 gallons of water. Drinking from un-flushed system may cause gastrointestinal discomfort, colic 1 Instruction book: detailed descriptions, photos and troubleshooting guide. and/or diarrhea. Consult a physician if discomfort persists. Running out the firs
Inhaltszusammenfassung zur Seite Nr. 4
Tap Master Owners Manual Tap Master Owners Manual System Location The Tap Master may be installed under a sink, or in a basement within 20’ feet of the RO sink component and checking for pressure. Have a bowl and towel at hand. faucet as long as the Tap Master is not subjected to freezing temperatures. The Tap Master should be mounted vertically where the drain line out is at the bottom. Mount the reserve tank on No water or ice from refrigerator water center Make sure line from Tap
Inhaltszusammenfassung zur Seite Nr. 5
Tap Master Owners Manual Tap Master Owners Manual while drilling, and while under sink. help slot the membrane into place or press the white nipple against a table so as to push it Using ½” masonry bit and variable speed corded power drill, slowly begin drilling into the housing until it slots into place. Replace and tighten membrane-housing cap. through the porcelain. Drill bit should be perpendicular to sink. Failure to do so may cause the Reinsert the tube end about a ¼” into the m
Inhaltszusammenfassung zur Seite Nr. 6
Tap Master Owners Manual Tap Master Owners Manual allow power drill electrical components to come into contact with water. Use caution – sink may be slippery. ® Tap Master Membrane Change Instructions When ¼” hole is completely drilled through, switch to ½” metal drill bit w/ cobalt tip. Tools Required Begin drilling to enlarge the ¼” hole to ½” all the way through the sink. Use caution when Pliers hole is near completion, because drill may lock-up and cause injury.
Inhaltszusammenfassung zur Seite Nr. 7
Tap Master Owners Manual Tap Master Owners Manual of your system configuration. disconnecting the unit, and enough room for performing general service on the unit. Typical b. To remove the tubing from the filter – push down the seal ring to the filter body locations are on either right or left side, near the back wall. Use supplied mounting clips as a with the thumb and forefinger while simultaneously pulling on the tubing as template to mark mounting screw locations. Tap Master should b
Inhaltszusammenfassung zur Seite Nr. 8
Tap Master Owners Manual Tap Master Owners Manual tank is full when the hissing noise stops. Discoloration of water may be present. for the drain saddle clamp. Place ¼” drill bit inside template hole, and drill a hole into the System must be flushed twice prior to use. Allow another 3 hours for the reserve drainpipe. DO NOT drill the hole clean through both sides of the drainpipe. This will result in tank to refill. Enjoy! a leak, and require a replacement piece of drainpipe. Drill thr
