Resumen del contenido incluido en la página 1
Phoenix Axial Air Mover
TS-285
PO Box 8680 • Madison, WI 53708
Owner’s Manual — Phoenix Axial Air Mover
Installation, Operation & Service Instructions
Read and Save These Instructions
The Phoenix Axial Air Mover is the industry’s only Air Mover specifically engineered with patent pending
TM TM
FOCUS Technology. FOCUS Technology revolutionizes evaporative drying by producing air velocities
greater than competitive product offerings. This highly focused air flow is directed towards the resto
Resumen del contenido incluido en la página 2
Table of Contents 1 Safety Information Introduction ............................................................... • Do not operate the unit with a cut or frayed power cord. TM FOCUS Technology Features and Benefits .................... Replace cord if it becomes damaged. 1. Safety Information .................................................2 • Do not unplug the unit by pulling on the cord. Grasp the 2. Intended Application ..............................................3 plug firmly and
Resumen del contenido incluido en la página 3
• Vérifier la protection du différentiel avant chaque 5 Power Requirements utilisation en appuyant sur le bouton “ test “. Si 5.1 Daisy Chaining l’appareil fonctionne correctement, le bouton “ reset “ ressort. The Phoenix Axial Air Mover draws 2.5 amps. The 2 amp, on-board circuit breaker will allow four (4) Phoenix Axial Air • Avant de laisser un appareil aéraulique axial sans Movers on one circuit. When daisy-chaining the Phoenix surveillance, s’assurer que les enfants n’ont pas accè
Resumen del contenido incluido en la página 4
the FOCUS Technology corner. 55.3 Integrated Cord Wrap The Axial Air Mover sustains The Phoenix Axial Air Mover features integrated cord this air flow for more than 20 management. Wrap the cord around the cord wrap as feet and maximizes the air shown and secure the cord with the clasp on the plug. velocity across the floor and along the wall when placed the at 4.5° angle from the wall. By touching the front edge of the output side of the axial air mover against the wall and rotating
Resumen del contenido incluido en la página 5
Making use of factory installed feet (4) Making use of user installed feet (2) 7 Operating Instructions The Phoenix Axial Air Mover as packaged is ready to be put into service. Inspect the unit completely for any shipping damage. Place the unit on the ground. Check the GFCI to Counter Clockwise ensure it is not tripped. Orient the unit so the desired air clockwise airflow airflow flow direction is the same as the arrow indicator sticker in pattern pattern the FOCUS Technology corner on
Resumen del contenido incluido en la página 6
the device’s power cord. Should an over-current condition 8.5 GFCI Protection and the On-Board Duplex occur, the Axial Air Movers’ on-board circuit breaker VAC Outlet prevents nuisance visits to a remote power junction box. The standard AC voltage outlet GFCI (Ground Fault Circuit Interrupter) protection promotes operator safety in wet applications. GFCI devices trip when a fault to electrical “ground” is sensed. IMPORTANT: Total amperage of the Axial Air Mover plus all devices plugged i
Resumen del contenido incluido en la página 7
9.2 Motor Lubrication 11 Wiring Diagram Oil the unit every six months with 3 - 4 drops of SAE 20 weight non-detergent oil. Lubricate the motor with a drop of oil after each washing. IMPORTANT: The approved oil for lubrication is SAE 20 weight non-detergent oil, specifically designated for use with electric motors. 9.3 Cleaning The housing is made of a durable and washable polyethylene. When cleaning, the use of solvents is NOT recommended. When washing inside the unit, disconnect the unit
Resumen del contenido incluido en la página 8
This page intentionally left blank. Toll-Free 1-800-533-7533 8 www.thermastor.com • sales@thermastor.com
Resumen del contenido incluido en la página 9
Phoenix Axial Air Mover Limited Warranty Warrantor: Therma-Stor LLC PO Box 8680 Madison, WI 53708 Telephone: -800-533-7533 Who Is Covered: This warranty covers Phoenix Axial Air Movers. First Year Warranty: 00% parts and labor (all components) Second Year Warranty: 00% par ts only (all components) Years Three through Seven: Only materials and workmanship of the housing are covered. If a defect in materials or workmanship occurs within the warranty period, Therma-Stor LLC will repair or repl
