Resumen del contenido incluido en la página 1
COMPACT L.P.& NATURAL
GAS VENT-FREE STOVE
’
OWNER S OPERATION AND INSTALLATION MANUAL
WARNING: If the information in this
manual is not followed exactly,a fire or
explosion may result causing property
damage, personal injury, or loss of life.
QN300RYLA QL300RYLA
Do not store or use gasoline or other flammable
QN300RYLA-W QL300RYLA-W
vapors and liquids in the vicinity of this or any
other appliance.
WHAT TO DO IF YOU SMELL GAS
Do not try t
Resumen del contenido incluido en la página 2
Table of Contents Safety information warnings--------------------3 Air for conbustion & Ventilation----------------5 Installation-------------------------------------------7 Operation Heater---------------------------- -----11 Cleaning and Maintenance-------------------- 13 Specification----------------------------------------15 Troubleshooting---------------------------------- 16 Parts Breakdown & Parts List-----------------18 Log Placing Instructions------------------------22 2
Resumen del contenido incluido en la página 3
SAFETY INFORMATION WARNINGS 1. This appliance is only for use IMPORTANT: Read this WARNING: Do not allow fans to with the type of gas indicated owner’s manual carefully and blow directly into the heater. Avoid any on the rating plate. This completely before trying to drafts that alter burner flame patterns. appliance is not convertible for assemble, operate, or service Ceiling fans can create drafts that use with other gases.
Resumen del contenido incluido en la página 4
SAFETY INFORMATION LOCAL CODES Continued 15. Turn off and unplug heater and let . lnstall and use heater with care. 10. Before using furniture polish, wax, cool before servicing. Only a Follow all local codes. In the carpet cleaner, or similar products, qualified service person should absence of local codes, use the turn heater off. If heated, the service and repair heater. latest edition of The National Fuel vapors from these products may 16. Operating heater above elevations Gas Co
Resumen del contenido incluido en la página 5
AIR FOR COMBUSTION AND VENTILATION Confined and Unconfined Space Unusually Tight Construction WARNING: This heater The National Fuel Gas Code, ANS The air that leaks around doors and shall not be installed in a confined Z223.1 defines a confined space as a windows may provide enough fresh space or unusually tight con- space whose volume is less than 50 air for combustion and ventilation. struction unless provisions are cubic feet per 1,000 Btu per hour H
Resumen del contenido incluido en la página 6
3. Add the Btu/Hr of all fuel burning appliances in the space. Vent-free heater Btu/Hr Example: Gas water heater* Btu/Hr Gas water heater 30,000 Btu/Hr Gas furnace Btu/Hr Vent-free heater + 26,000 Btu/Hr Vented gas heater Btu/
Resumen del contenido incluido en la página 7
INSTALLATION WATER VAPOR:A BY-PRODUCT OF UNVENTED ROOM HEATERS Water vapor is by-product of gas combustion.an unvented room heater prodrces approximately one (1) ounce (30ml) of water for every 1, 000BTU’s (.3kw’s) of gas input per hour. 12 Unvented room heaters are recom- mended as supplemtal heat (a room) rather that a primary heat source(an entire house) in most supplemental heat applications,the water vapor does not create a problem ,in most applications the water vapor enhances the low humi
Resumen del contenido incluido en la página 8
CLEARANCES TO COMBUSTIBLES The installer must supply an external regulator. (Vent-Free Operation Only) The external regulator will reduce incoming gas Carefully follow the instructions below. pressure. You must reduce incoming gas pressure This stove is a freestanding unit to rating inches of water. If you do not reduce designed to set directly on the floor. incoming gas pressure, heater regulator damage IMPORTANT: You must maintain could occur. lnstall ext
Resumen del contenido incluido en la página 9
WARNING: Never connect Pressure Testing Gas CAUTION: Avoid damage to heater to private (non-utility) gas Supply Piping System regulator. Hold gas regulator with wells. This gas is commonly known wrench when connecting into gas as wellhead gas. Test Pressures In Excess Of 1/2 piping and/or fittings. PSIG(3.5kPa) 1. Disconnect heater with its CAUTION: Use only new, black CHECKING GAS appliance main gas valve (control iron or
Resumen del contenido incluido en la página 10
2. Open gas supply tank valve. WARNING: Failure to position It is very important to install the logs 3. Make sure control knob of heater is the parts in accordance with these exactly as instructed. Do not modify in the OFF position. diagrams or failure to use only parts logs. Only use logs supplied with 4. Check all joints from equipment specifically approved with this heater heater. shutoff valve to control valve may result in property damage or (LP GAS
Resumen del contenido incluido en la página 11
OPERATING HEATER FOR YOUR SAFETY OPERATING INSTRUTION OF READ BEFORE LIGHTING REMOTE-CONTROLLED BUNER WARNING: If you do not follow these instructions exactly, a LIGHTING INSTRUCTIONS fire or explosion may result causing property damage, personal injury or loss of life. 1. STOP! Read the safety information, A. This appliance has a pilot which page 2. must be lighted by control system, 2. Make sure equipment shutoff When lighting the p
Resumen del contenido incluido en la página 12
(Note: on the auto select of main OPERATING burner, the main burner does not HEATER respond imm-ediately to the set tempera- ture until about one minute later.) Continued b.manual select of main burner: Press BURNER button, the flame is on “MAN” select. At this selection, the Fig16 Control board main burner will keep working no matter what the temperature is set at. If there is OPERATIONS OF a need to shut off the main burner, just BURNER press the “BURNER” button to make the 1
Resumen del contenido incluido en la página 13
3.After completion of the above- sensing bulb from the clip, then disco- mentioned two steps, the transmitter nnect the wires to free to control is kept in a state of readiness. If the module from its mounting location . appliance doesn’t working for a period time, just pull out the plug Note: Do not confuse the mark on from the 110V electrical outlet. the each wire. 2. Remove two screws and hex nuts, OPERATIONS OF take out the control module. When in- Figure 19 -Incorrect Pilot Flame K
Resumen del contenido incluido en la página 14
We also recommend that you keep Burner CABINET the burner tube and pilot assembly Air Passageways clean and free of dust and dirt. To Use a vacuum cleaner or clean these parts we recommend pressurized air to clean. using compressed air no greater Exterior than 30 PSI. Your local computer Use a soft cloth dampened with a store, hardware store, or home center may carry compressed air in mild soap and water mixture. Wipe a can. You can use a vacuum the cabinet to remov
Resumen del contenido incluido en la página 15
ACCESSORIES FLEXILBE HOSE Purchase date Purchase these heater accessories Usually, we will ask you to Flexibe gas hose is used for connect- from your local dealer or Parts return the defective part to the ing the heater to gas supply. Central. This part is not currently factory. available from PRO-COM. the flex hose must approved by CSA . Warranty card. PARTS NOT UNDER WARRANTY Contact authorized dealers of this product or Parts Central. If they
Resumen del contenido incluido en la página 16
TROUBLESHOOTING WARNING:Make sure that power CAUTION: Never use a wire, WARNING: Turn off and let cool is turn off before proceeding.... needle, or similar object to clean before servicing. Only a qualified ODS/pilot. This can damage ODS/ service person should service and pilot unit. repair fireplace. OBSERVED PROBLEM POSSIBLE CAUSE REMEDY 1. No power to heater 1. Check the electric power No spark when press in ignition button 2. No battery in transmitter or battery
Resumen del contenido incluido en la página 17
TROUBLESHOOTING Continued POSSIBLE CAUSE OBSERVED PROBLEM REMEDY Delayed ignition burner 1. Manifold pressure is too low 1. Contact local gas company 2. Clean burner (see Cleaning and 2. Burner orifice clogged Maintenance, page 13) Burner backfiring during combustion 1. Damaged burner 1. Clean burner orifice (see 2. Gas regulator defective Cleaning and Maintenance, page 13) 2. Replace gas regulator 1. Residues from manufacturing Slight smoke
Resumen del contenido incluido en la página 18
ILLUSTRATED PARTS BREAKDOWN QL300RYLA QN300RYLA QL300RYLA-W QN300RYLA-W 18
Resumen del contenido incluido en la página 19
PARTS LIST QL300RYLA QN300RYLA QL300RYLA-W QN300RYLA-W 19
Resumen del contenido incluido en la página 20
ILLUSTRATED PARTS BREAKDOWN QL300RYLA QN300RYLA QL300RYLA-W QN300RYLA-W 20
