Résumé du contenu de la page N° 1 
                    
                        Important Safety 
Instructions
 
, 
 
 
 
 
 
 
 
 
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT
 
REMOVE COVER (OR BACK). NO USE-SERVICEABLE PARTS
 
 
INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
 
The lightning flash with arrowhead symbol, within an equilateral triangle, is 
 
intended to alert the user to the presence of uninsulated “dangerous voltage”
 
within the product’s enclosure that may be of sufficient magnitude to 
 
constitute a risk of electric to persons. 
 
 
                    
                    Résumé du contenu de la page N° 2 
                    
                        Important Safety  Instructions   NOTES  1) Read these instructions.  2) Keep these instructions.  3) Heed all warnings.  4) Follow all instructions.  5) Do not use this apparatus near water.  6) Clean only with a damp cloth.  7) Do not block any of the ventilation openings.  Install in accordance with the  manufacturer's instructions.  8) Do not install near any heat sources such as radiators, heat registers, stoves, or  other apparatus (including amplifiers) that produce heat.  9) Do not defeat
                    
                    Résumé du contenu de la page N° 3 
                    
                        Important Safety  Instructions   Warning  Failure to avoid the following potentially hazardous situations may result in injury or  property damage.  The unit is designed to provide you with route suggestions. It does not reflect road  closures or road conditions, traffic congestion, weather conditions, or other factors that  may affect safety or timing while driving.  Use the unit only as a navigational aid. Do not attempt to use the unit for any purpose  requiring precise measurement of directi
                    
                    Résumé du contenu de la page N° 4 
                    
                        Important Safety  Instructions   Note: This equipment has been tested and found to comply with limits for Class B digital  device, pursuant to part 15 of the FCC Rules. These limits are designed to provide  reasonable protection against harmful interference in a residential installation. This  equipment generates, uses and can radiate radio frequency energy and, if not installed  and used in accordance with the instructions, may cause harmful interference to radio or  television reception, which
                    
                    Résumé du contenu de la page N° 5 
                    
                            Accessories    Accessories List  ITEM NAME QTY    Owner’s Manual 2    AC Adaptor 1    Car Adaptor 1    Mounting Bracket 1    USB Cable 1    Mounting cradle 1    Touch Pen 1        Dashboard mount disk 1  SD Card 1      Pouch 1    NOTE  Accessories and their part number are subject to modification without prior notice due to  improvements.   5                                                                                                                                                        
                    
                    Résumé du contenu de la page N° 6 
                    
                            Contents          …………………………………..……..…..1 Important Safety Instructions      ……………………………….……….…....5 Accessories       ……………………………….………..…...7 View of Main Unit      ………………………………..…………....8 System Connections      ……………………………….…….….….10 Power Supply Preparation      …………………………….……….….….12   General Setup      ……………………………….……….…..16 MP3 Player      …………………………….……………...18 Photo Viewer      ……………………………….……….…..20 Use of the Mount Accessories       ……………………………….……….…..21 Troubleshooting      ………
                    
                    Résumé du contenu de la page N° 7 
                    
                            View of Main Unit                                1. POWER Button  Press for a longer time to enter or exit the standby mode.  2. Card Port  Insert the SD card into the slot.  3. Earphone Jack  Connect earphone for private listening. When the earphone is connected to this  jack, the speaker will be turned off automatically.  4. USB Port  Connect to the supplied adapter to charge the unit.  Used to connect to the USB device.  5. LCD Screen  Finger touches the screen directly or use the touch p
                    
                    Résumé du contenu de la page N° 8 
                    
                        System  Connections Always ensure that the unit and any other external device connected to the unit are  switched off and unplugged from the power supply before you attempt to connect  the unit to any external device.  Connecting to PC The unit is designed with a USB port which allows you to connect the unit to PC for map  updating. See the below figure for details:   System requirements:  -Windows 98SE, ME, 2000 and XP   (Driver required for Windows 98SE)  -DVD Rom Drive (for map upgrade purpos
                    
                    Résumé du contenu de la page N° 9 
                    
                          System    Connections       Inserting SD Card  The unit is designed with SD Card jack which allows you to insert the SD card into the  unit as shown below:                    To remove the card, gently press the card in with your fingernail. The card unlocks and  protrudes slightly. Then remove the card.      Connecting to Earphones  Connect the earphones to the right side of the unit for private listening.                        When earphone is connected, the speakers will automatically turn
                    
                    Résumé du contenu de la page N° 10 
                    
                          Power Supply    Preparation       Using the AC Adaptor  The unit is supplied with an AC adaptor for powering it and charging its battery.      1. Connect AC adaptor to the right    side of the unit in the USB port, as   shown on the right.    2. Plug the two-prong end of the    power cord into a grounded   electrical outlet.     Note:   Turn unit's power off before unplugging.   In the case of using the adaptor, the LCD screen will be brighter than with the  rechargeable battery.    Using of C
                    
                    Résumé du contenu de la page N° 11 
                    
                          Power Supply    Preparation       About Rechargeable Battery  Your portable GPS device comes with a built-in rechargeable battery. Charge the battery  fully before initial use. Charging time is normally about 3.5 hours. A fully charged battery  delivers about 2.5 hours of use.    Working conditions and precautions for the rechargeable battery   New batteries should be fully charged before initial use.   Battery should only be used and charged when temperatures are between  32 °-100 °F.   Maint
                    
                    Résumé du contenu de la page N° 12 
                    
                            General Setup        System Main Menu  When in navigation mode, Tap MENU button, and then choose SETTINGS.                   In the SETTINGS menu, tap EXIT, a confirmation message appears. Tap Exit in the  confirmation message to return to the system main menu, as shown below.              In the main menu, there are four items for selecting. Touch the corresponding item to  enter.  Tap  to enter navigation mode; tap  to enter the MP3 player; tap  to enter  the Photo Viewer; tap  to enter th
                    
                    Résumé du contenu de la page N° 13 
                    
                            General Setup        Language  Tap  in the settings menu to enter Language settings menu for language selecting,  as shown below:              Tap the   buttons to select language. Then tap  to confirm or tap  to  cancel.     Backlight  Tap  in the settings menu to enter Backlight settings menu for backlight adjusting,  as shown below:              Tap the first group   buttons to adjust the backlight level.   Tap the second group  buttons to adjust the sleep time. There are 6 choices for sl
                    
                    Résumé du contenu de la page N° 14 
                    
                            General Setup        Date & Time  Tap  in the settings menu to enter Date & Time settings menu for changing to the  current time zone, as shown below:              Tap the   buttons to select the proper Time Zone. Tap the   buttons of  Date group to change the corresponding date and tap the   buttons of Time  group to change the corresponding time. Tap  to return.    Power  Tap  in the settings menu to enter Power menu for the current battery status, as  shown below:              The power m
                    
                    Résumé du contenu de la page N° 15 
                    
                            General Setup        Screen  Tap  in the settings menu, the screen will display as below:                This item is used to calibrate the sensitivity of the touch screen. Tap the center of “+” as it  moves around the screen. If you touch the center of “+” every time, it will disappear after  having moved through a cycle (center →top left corner →bottom left corner →bottom right  corner →top right corner). Tap the screen to return to the settings menu.  Note: If “+” doesn’t disappear, you s
                    
                    Résumé du contenu de la page N° 16 
                    
                            Playing Music        The unit is designed with SD card slot. You can insert the SD card with MP3 and WMA  files. It supports MP3, WMA format files playback.    Note: Do not store MP3 and WMA format files in the Flash storage, for the flash  storage is used to store map data, any attempt to open the Flash storage may  result in the map data missing and lost.    Warning: For your own safety, do not use the earphones when driving.    Take the following steps to play:    Loading MP3 and WMA form
                    
                    Résumé du contenu de la page N° 17 
                    
                        Playing Music    When you open the play list, the system will look for audio files on its SD memory card  and create a play list automatically. If the play list consists of more than one screen, tap  the up arrow  for the previous page and the down arrow  for the next page.  In the play list, double tap the songs to start playback.  Tap ; when the button changes to orange, the player will repeat all the songs in the  play list.  Tap ; when the button changes to orange, the player will play the s
                    
                    Résumé du contenu de la page N° 18 
                    
                            Photo Viewer          The unit is designed with SD card slot. You can insert the SD card with JPEG files. It  supports JPEG format files playback.  Note: Do not store JPEG format files in the Flash storage, for the flash storage is  used to store map data, any attempt to open the Flash storage may result in the  map data missing and lost.    It lags when reading high-resolution JPEG files in SD Card. We suggest  low-resolution (within 640*480) pictures playback.    Playing JPEG Files  Insert
                    
                    Résumé du contenu de la page N° 19 
                    
                            Photo Viewer                      If the pictures list consists of more than one screen, tap the up arrow  for the  previous page and the down arrow  for the next page. Tap  to return to previous  menu. Tap a picture to select it and tap  to confirm your selection.    In the pictures list, double tap a picture to play it on screen, as shown below.                On the playback screen, the Photo Viewer has following playback features:  Tap  to rotate the picture.  Tap  to back to previous pi
                    
                    Résumé du contenu de la page N° 20 
                    
                          Use of the Mount    Accessories     When using the unit in vehicle, you can use the supplied mount accessories (mount  bracket, mount cradle and dashboard mount disk) to mount the unit in the vehicle. Take  the following steps to operate:                              1. See Fig. 1 to slide the mount cradle onto the end of the mount bracket.  2. See Fig. 2. Set the bottom edge of the unit onto the mount cradle. Then push the  tap at the top of the mount cradle in arrow 1 direction to mount the