Résumé du contenu de la page N° 1 
                    
                         
 
 
TL-WR941ND 
Wireless N Router 
 
 
Rev: 1.1.0 
  
1910010567 
                                                                                                                                                                                                                                                                                                                                                                                                                                                
                    
                    Résumé du contenu de la page N° 2 
                    
                          COPYRIGHT & TRADEMARKS  Specifications are subject to change without notice.  is a registered trademark  of TP-LINK TECHNOLOGIES CO., LTD. Other brands and product names are trademarks or  registered trademarks of their respective holders.  No part of the specifications may be reproduced in any form or by any means or used to make any  derivative such as translation, transformation, or adaptation without permission from TP-LINK  TECHNOLOGIES CO., LTD. Copyright © 2012 TP-LINK TECHNOLOGIES CO.,
                    
                    Résumé du contenu de la page N° 3 
                    
                          FCC RF Radiation Exposure Statement  This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled  environment. This device and its antenna must not be co-located or operating in conjunction with  any other antenna or transmitter.  “To comply with FCC RF exposure compliance requirements, this grant is applicable to only  Mobile Configurations. The antennas used for this transmitter must be installed to provide a  separation distance of at least 20 cm from all per
                    
                    Résumé du contenu de la page N° 4 
                    
                          This device has been designed to operate with the antennas listed below, and having a maximum  gain of 3 dBi. Antennas not included in this list or having a gain greater than 3 dBi are strictly  prohibited for use with this device. The required antenna impedance is 50 ohms.   To reduce potential radio interference to other users, the antenna type and its gain should be so  chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that permitted for  successful communi
                    
                    Résumé du contenu de la page N° 5 
                    
                          低功率射頻電機之使用不得影響飛航安全及干擾合法通信;經發現有干擾現象時,應立即停用,並 改善至無干擾時方得繼續使用。前項合法通信,指依電信法規定作業之無線電通信。低功率射頻電 機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。  IV                                                                                                                                                                                                                                                                                                                                                                                       
                    
                    Résumé du contenu de la page N° 6 
                    
                         TP-LINK TECHNOLOGIES CO., LTD  DECLARATION OF CONFORMITY  For the following equipment:  Product Description: Wireless N Router  Model No.: TL-WR941ND  Trademark: TP-LINK    We declare under our own responsibility that the above products satisfy all the technical  regulations applicable to the product within the scope of Council Directives:    Directives 1999/5/EC, Directives 2004/108/EC, Directives 2006/95/EC, Directives 1999/519/EC,  Directives 2011/65/EU  The above product is in conformity wi
                    
                    Résumé du contenu de la page N° 7 
                    
                          CONTENTS  Package Contents ....................................................................................................................................1  Chapter 1. Introduction..........................................................................................................................2  1.1 Overview of the Router .........................................................................................................2  1.2 Conventions .....................................
                    
                    Résumé du contenu de la page N° 8 
                    
                          4.7 DHCP ..................................................................................................................................46  4.7.1 DHCP Settings........................................................................................................46  4.7.2 DHCP Clients List ...................................................................................................48  4.7.3 Address Reservation ...........................................................................
                    
                    Résumé du contenu de la page N° 9 
                    
                          4.15.2 Dyndns.org DDNS ..................................................................................................79  4.15.3 No-ip.com DDNS ....................................................................................................80  4.16 System Tools.......................................................................................................................81  4.16.1 Time Settings.......................................................................................
                    
                    Résumé du contenu de la page N° 10 
                    
                        TL-WR941ND Wireless N Router     Package Contents  The following items should be found in your package:   TL-WR941ND Wireless N Router   DC Power Adapter for TL-WR941ND Wireless N Router   Quick Installation Guide   Resource CD for TL-WR941ND Wireless N Router, including:  • This Guide  • Other Helpful Information  Note:    Make sure that the package contains the above items. If any of the listed items are damaged or  missing, please contact your distributor.                            -1-      
                    
                    Résumé du contenu de la page N° 11 
                    
                        TL-WR941ND Wireless N Router     Chapter 1. Introduction  Thank you for choosing the TL-WR941ND Wireless N Router.  1.1 Overview of the Router  The TL-WR941ND Wireless N Router integrates 4-port Switch, Firewall, NAT-Router and Wireless  AP. The Wireless N Router delivers exceptional range and speed, which can fully meet the need of  Small Office/Home Office (SOHO) networks and the users demanding higher networking  performance.    Incredible Speed  The TL-WR941ND Wireless N Router provides up t
                    
                    Résumé du contenu de la page N° 12 
                    
                        TL-WR941ND Wireless N Router     1.3 Main Features   Complies with IEEE 802.11n to provide a wireless data rate of up to 300Mbps.   One 10/100M Auto-Negotiation RJ45 WAN port, four 10/100M Auto-Negotiation RJ45 LAN  ports, supporting Auto MDI/MDIX.   Provides WPA/WPA2, WPA-PSK/WPA2-PSK authentication, TKIP/AES encryption security.   Shares data and Internet access for users, supporting Dynamic IP/Static IP/PPPoE Internet  access.   Supports Virtual Server, Special Application and DMZ host.   Sup
                    
                    Résumé du contenu de la page N° 13 
                    
                        TL-WR941ND Wireless N Router     1.4 Panel Layout  1.4.1 The Front Panel    Figure 1-1  Front Panel sketch  The Router’s LEDs and the QSS button are located on the front panel (View from left to right).   Name Status Indication  Off Power is off.  PWR  On Power is on.  On The Router is initializing or maybe has a system error.  SYS Flashing The Router is working properly.  Off The Router has a system error.  Off The Wireless function is disabled.  WLAN  Flashing The Wireless function is enabled.
                    
                    Résumé du contenu de la page N° 14 
                    
                        TL-WR941ND Wireless N Router     Note:    After a device is successfully added to the network by QSS function, the QSS LED will keep on for  about 5 minutes and then turn off.  1.4.2 The Rear Panel    Figure 1-2  Rear Panel sketch  The following parts are located on the rear panel (View from left to right).   POWER: The Power socket is where you will connect the power adapter. Please use the  power adapter provided with this TL-WR941ND Wireless N Router.    RESET:  There are two ways to reset to
                    
                    Résumé du contenu de la page N° 15 
                    
                        TL-WR941ND Wireless N Router     Chapter 2. Connecting the Router  2.1 System Requirements   Broadband Internet Access Service (DSL/Cable/Ethernet)   One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the Router is  connected directly to the Ethernet.)   PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors    TCP/IP protocol on each PC   Web browser, such as Microsoft Internet Explorer 5.0 , Netscape Navigator 6.0 or above  2.2 Installation Enviro
                    
                    Résumé du contenu de la page N° 16 
                    
                        TL-WR941ND Wireless N Router       Figure 2-1  Hardware Installation of the TL-WR941ND Wireless N Router  -7-                                                                                                                                                                                                                                                                                                                                                                                                       
                    
                    Résumé du contenu de la page N° 17 
                    
                        TL-WR941ND Wireless N Router     Chapter 3. Quick Installation Guide  This chapter will show you how to configure the basic functions of your TL-WR941ND Wireless N  Router using Quick Setup Wizard within minutes.  3.1 TCP/IP Configuration  The default domain name of the TL-WR941ND Wireless N Router is http://tplinklogin.net, the  default IP address is 192.168.0.1, and the default Subnet Mask is 255.255.255.0. These values  can be changed as you desire. In this guide, we use all the default value
                    
                    Résumé du contenu de la page N° 18 
                    
                        TL-WR941ND Wireless N Router       Figure 3-1  Success result of Ping command   If the result displayed is similar to the Figure 3-2, it means the connection between your PC  and the Router is failed.     Figure 3-2  Failure result of Ping command  Please check the connection following these steps:  1. Is the connection between your PC and the Router correct?  Note:      The 1/2/3/4 LEDs of LAN ports which you link to on the Router and LEDs on your PC's adapter  should be lit.  -9-              
                    
                    Résumé du contenu de la page N° 19 
                    
                        TL-WR941ND Wireless N Router     2. Is the TCP/IP configuration for your PC correct?  Note:     If the Router's IP address is 192.168.0.1, your PC's IP address must be within the range of  192.168.0.2 ~ 192.168.0.254.  3. Is the default LAN IP of the Router correct?   Note:   If the LAN IP of the modem connected with your router is 192.168.0.x, the default LAN IP of the  Router will automatically switch from 192.168.0.1 to 192.168.1.1 to avoid IP conflict. Therefore, in  order to verify the netw
                    
                    Résumé du contenu de la page N° 20 
                    
                        TL-WR941ND Wireless N Router     2. After successfully login, you can click the Quick Setup to quickly configure your Router.     Figure 3-5  Quick Setup  3. Click Next, and then WAN Connection Type page will appear, shown in Figure 3-6.    Figure 3-6  Choose WAN Connection Type  The Router provides Auto-Detect function and supports three popular ways PPPoE,  Dynamic IP and Static IP to connect to the Internet. It’s recommended that you make use of  the Auto-Detect function. If you are sure of w