Résumé du contenu de la page N° 1
Inspire Electric Fireplace
Model: ICVCEFP01
Trim Models: ICVCTK01 Black, ICVCTK02 Pewter,
ICVCTK06 Ebony Black w/Brushed Nickel Accent,
ICVCTK07 Burnished Black
IMPORTANT SAFETY INFORMATION
ALWAYS READ THIS MANUAL FIRST BEFORE
ATTEMPTING TO INSTALL OR USE THIS FIREPLACE
ALWAYS COMPLY WITH ALL WARNINGS AND SAFETY
INSTRUCTIONS CONTAINED IN THIS MANUAL, TO
PREVENT PERSONAL INJURY OR PROPERTY DAMAGE
����
FOR YOUR SAFETY
������ ��� � � ��
Always use a qualified technician or service agency to
Résumé du contenu de la page N° 2
Inspire Electric Fireplace Thank you and congratulations on your purchase of a CFM Corporation electric fireplace. IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible electric shock, fire hazard and will void the war- ranty. PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS BEFORE USING THIS APPLIANCE Table of Contents Installation Instructions General ..........................................
Résumé du contenu de la page N° 3
Inspire Electric Fireplace Installation Instructions General 1. Read all instructions before using this appliance. 12. Connect to properly grounded outlets only. 2. This appliance is hot when in use. To avoid burns, do not 13. This appliance, when installed must be electrically let bare skin touch hot surfaces. If provided, use handles grounded in accordance with local codes, with the current when moving this appliance. Keep combustible materials, CSA C22.1 Canadian Electrical codes or for
Résumé du contenu de la page N° 4
Inspire Electric Fireplace Fireplace Dimensions Minimum Shelf Height 36” (To Heater Main body) (914 mm) 24����” 23���" (615 mm ) (594 mm) 5�����” 35 �����” (910 mm) 9���” Minimum (145 mm) [Heater Main Body Width 32���” (832 mm)] (250 mm) From Floor place until it has first been inspected if any portion Electrical Specifications of it has been exposed to water. Always utilize a Voltage 120V ac, 60 Hz qualified service technician to inspect the fireplace Total Amps 7.9 Amps and to replace any el
Résumé du contenu de la page N° 5
Inspire Electric Fireplace Direct (Hard) Wiring Electric Fireplace WARNING • This procedure must be conducted by a qualified elec- by gently pulling them apart. DO NOT use a knife, trician, in accordance with National and local codes. In as this may expose bare conductors. The hot wire the U.S.A., the installation must conform to the National is connected to the main power switch and is termi- Electrical Code, ANSI/NFPA No. 70. In Canada, the nated with a straight terminal connector. The neutr
Résumé du contenu de la page N° 6
Inspire Electric Fireplace Fireplace Assembly Unpack the Appliance 4. Measure half the width [16 ³⁄₈” (416 mm)] of the heater main body and mark a vertical line to cross The Inspire Electric Heater is supplied in two (2) car- the horizontal line. If the heater main body is to be tons. All instructions should be read before beginning centered on the wall area, mark a vertical center line installation. to cross that horizontal line. Where the horizontal Carton 1 contents and vertical marks
Résumé du contenu de la page N° 7
Inspire Electric Fireplace Insert Panel Magnets FP1638 Fig. 3 Place insert panels on either side of trim. FP1637 Magnets 5. Hang the trim to the heater main body’s upper trim Fig. 4 Trim magnet location. ������ support at a slight angle and between the trim insert panels. Slowly, swing the trim down until the mag- �� �������� �������� nets catch to the heater main body. ���� ������ �� ���������� ���� 10009472 7
Résumé du contenu de la page N° 8
Inspire Electric Fireplace Operating Instructions Heater Operation The heater is operated by the remote control handset. A master ON/OFF switch is located under the appliance on the left hand side. This is used to turn the appliance Fire On/Flame completely off. Effect Only Fire Off All further operations are controlled by using the remote control handset. (Fig. 5) 1. Ensure the appliance is plugged in and switched on. Low Heat 2. To turn the fire on, press the fire on/flame effect but- High
Résumé du contenu de la page N° 9
Inspire Electric Fireplace Maintenance WARNING Always disconnect the fireplace from the main power supply before performing any routine main- tenance. Always utilize a qualified technician if assistance is required. Always install genuine CFM Corporation replace- ment parts, which are available from your autho- rized dealer. Removable Panel NOTICE Always use the recommended 20 watt compact fluorescent light bulbs. Never install incandescent light bulbs in this fireplace. It is advisable to use
Résumé du contenu de la page N° 10
Inspire Electric Fireplace 1 3 5 4 6 7 8 9 10 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. Inspire Replacement Parts Unit: EFHI4S0 Ref. Description Part Number 1. 20W Energy Saving Bulb* B-98830 9472 2. Pebble Pack (not shown) B-100510 Inspire parts 3. Colored Filter B-99670 8/06, 4. Ember Lava Rock B-93420 5. Circuit Board B-99610 6. Transmitter B-100830 7. Fan Heater 1097
Résumé du contenu de la page N° 11
Inspire Electric Fireplace 1 YEAR WARRANTY For Vermont Castings Electric Fireplace BASIC WARRANTY: CFM Corporation (hereinafter referred to collectively as 7. All other warranties - expressed or implied - with respect the “Company”) warrants that your new electric fireplace to the product, its components and accessories, or any ob- is free from manufacturing and material defects for a ligations/liabilities on the part of the Company are hereby period of one year from date of installation, su
Résumé du contenu de la page N° 12
CFM Corporation 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 800-668-5323 • www.cfmcorp.com
