Instruction d'utilisation Casio Ana-Digi Sport Men's- Stainless Steel AQ164WD-1AV

Résumé du contenu de la page N° 1

l
l
l
l
l
l
l
l
l
l
l




l


l
l
l
l
l
l
l
l
l
l
l
MO0804-EA
Operation Guide 4380 4396 5048
About This Manual
Module 4380 Module 4396 Module 5048
• The operational procedures for Modules 4380 , 4396 and 5048 are identical. All of
the illustrations in this manual show Module 4380.
• Button operations are indicated using the letters shown in the illustration.
• For the sake of simplicity, the sample displays in this manual do not show the analog
hands of the watch.
• Depending on the model of you

Résumé du contenu de la page N° 2

Operation Guide 4380 4396 5048 • The stopwatch continues to run, restarting from zero after it reaches its limit, until To time first and second place finishes you stop it. 1. When the stopwatch display shows all zeros, press A to display the split time • The stopwatch measurement operation continues even if you exit the Stopwatch screen (indicated by /SPL). Mode. 2. Press D to start a time measurement. • For information about how stopwatch times are stored in memory, see “Memory 3. Pr

Résumé du contenu de la page N° 3

Operation Guide 4380 4396 5048 Countdown Timer You can set the countdown timer within a range of one Timekeeping Mode time 4. While a setting is flashing, use D (+) and B (–) to change it. minute to 24 hours. An alarm sounds when the countdown • To set an alarm that does not include a month (daily alarm, monthly alarm), set x reaches zero. for the month. Use D and B until the x mark appears (between 12 and 1) while • You also can select auto-repeat, which automatically month setting is flashing.

Résumé du contenu de la page N° 4

Operation Guide 4380 4396 5048 Illumination This watch has an EL (electro-luminescent) panel that cause the face of watch to glow for easy reading in the dark. • See “Illumination Precautions” for other important information about using illumination. To illuminate the face of the watch In any mode (except when a setting screen is on the display), press B to illuminate the face of the watch. • You can use the procedure below to select either 1.5 seconds or 3 seconds as the illumination duration.