ページ1に含まれる内容の要旨
INSTALLATION MANUAL FOR TFP AIR CLEANER
Model TFP3000
Model TFP3000HEPA
Materials Supplied
ATTENTION
1 TFP
The furnace fan and/or HRV must operate
4 mounting brackets
continuously for Type 1 and Type 2 installations.
4 hanging straps
If they do not operate continuously, then
2 Red, 7” collar connections
interlocking them electrically with the TFP is
4 8/32” X 3/4” sheet metal screws
acceptable. Consult a certified electrician.
8 8/32” X 3/8” sheet metal screws
4 pieces of moun
ページ2に含まれる内容の要旨
TYPE 1 INSTALLATION TFP Directly Connected to Forced Air Heating System 1. Install 7” port collar (provided) on top and NOTE: Do not support the weight of the TFP on the duct. Duct must be open and not pinched. bottom of TFP (Fig. 1). Use (4) 8/32” X 3/8” screws (provided). NOTE: Due to possible noise transfer through the duct system, it may be preferable in some 2. Remove protective backing from pieces of situations to hang the TFP a short distance from foam and stick them to the 4 corners
ページ3に含まれる内容の要旨
TYPE 2 INSTALLATION TFP Connected to Heat Recovery Ventilator LOCATION Type 2 Installation The TFP should be located in the main trunk of * “Breathing T” is designed to assist in neutralizing the fresh air to house line, after the Heat pressure differences which can occur between HRV and TFP when joined together. Recovery Ventilator (HRV) and before any branch lines. (Fig. 3) MOUNTING 1. Locate mounting bolts (4) on side of TFP cabinet FLOOR JOISTS for vertical hanging (Fig. 3) and remove. 2
ページ4に含まれる内容の要旨
TYPE 3 INSTALLATION TFP Independent Installation No HRV, Radiant Heating System LOCATION NOTE: For installations of more than one return or 1. A TFP is usually installed in a basement area supply (greater than .5 e.s.p.) , it is often necessary to where air flow noise will be negligible to the add an inline fan to the system as a booster. occupants. 2. A central location between the clean air supply Type 3 Installation grille and return grille is recommended. MOUNTING Refer to “Mounting” under
