ページ1に含まれる内容の要旨
C491M-D (3/99)
HS4100BH
High-Security Camera Enclosure
®
3500 W. Pelco Way, IMPORTANT SAFEGUARDS AND WARNINGS
300 W. Pontiac Way,
Clovis, CA 93612-5699
Clovis, CA 93612-5699
Prior to installation and use of this product, the following WARNINGS should be observed.
USA
USA
1. Installation and servicing should only be done by qualified service personnel and conform
In North America & Canada
In North America & Canada:
to all local codes.
Tel (800) 289-9100
Tel (800) 289-9100
FAX (800) 289-9150
FAX (
ページ2に含まれる内容の要旨
After incorporating the enclosure into the wall structure, follow the steps below to complete the installation. 1. Remove the appropriate knock-outs and route the required cables to the enclosure. 2. You can access the inside of the enclosure from either the front or rear. Use the supplied Tampruf #10 socket (fits 1/4-inch square drive). • The hinged front swings down after you remove the two Tampruf screws. • The rear plate comes off after you remove the four Tampruf screws. 3. The tamper switc
ページ3に含まれる内容の要旨
GENERAL Construction: Seam-welded 10-gauge (0.134 in. or 0.34 cm) steel Finish: Gray polyester powder coat Dimensions: See Figure 1 Environment: Indoor; 32° to 120°F (0° to 49°C) Weight: Unit Shipping 23 lb (10.35 kg) 27 lb (12.23 kg) Rating: NEMA 1 IP 20 (Design and product specifications subject to change without notice.) NOTE: VALUES IN PARENTHESES ARE CENTIMETERS; ALL OTHERS ARE INCHES Figure 1. HS4100BH Dimension Drawing
ページ4に含まれる内容の要旨
PRODUCT WARRANTY AND RETURN INFORMATION WARRANTY Pelco will repair or replace, without charge, any merchandise proved defective in material or If a warranty repair is required, the Dealer must contact Pelco at (800) 289-9100 or workmanship for a period of one year after the date of shipment. (559) 292-1981 to obtain a Repair Authorization number (RA), and provide the following information: Exceptions to this warranty are as noted below: 1. Model and serial number 2. Date of shipment, P.O. number
