ページ1に含まれる内容の要旨 
                    
                        ENGLISH
EN
GUIDEBOOK
HARD DISK CAMCORDER
U
GZ-MG730
Dear Customer
Thank you for purchasing this 
hard disk camera. 
Before use, please read 
the safety information and 
precautions contained in pages 2 
and 3 to ensure safe use of this 
product.
For Future Reference: 
Enter the Model No. (located on 
the bottom of the camera) and 
Serial No. (located on the battery 
pack mount of the camera) 
below.
Model No.
Serial No.                                                                             
                    
                    ページ2に含まれる内容の要旨 
                    
                         Safety Precautions When the equipment is installed in a cabinet or on  CAUTION a shelf, make sure that it has suffi cient space on  RISK OF ELECTRIC SHOCK DO NOT OPEN all sides to allow for ventilation (10 cm (3-15/16 ")  or more on both sides, on top and at the rear). CAUTION:      TO REDUCE THE RISK OF ELECTRIC SHOCK, Do not block the ventilation holes.        DO NOT REMOVE COVER (OR BACK). (If the ventilation holes are blocked by a  NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFI
                    
                    ページ3に含まれる内容の要旨 
                    
                        ENGLISH IMPORTANT SAFETY INSTRUCTIONS Remember that this camera is intended for  private consumer use only. 1. Read these instructions. Any commercial use without proper permission  2. Keep these instructions. is prohibited. (Even if you record an event such  3. Heed all warnings. as a show, performance or exhibition for personal  4. Follow all instructions. enjoyment, it is strongly recommended that you  5. Do not use this apparatus near water. obtain permission beforehand.) 6. Clean only with 
                    
                    ページ4に含まれる内容の要旨 
                    
                        JVC Software License Agreement   JVC SOFTWARE LICENSE AGREEMENT 4 LIMITED WARRANTY JVC warrants that any media in which the  Program is embodied are free from any defects  IMPORTANT in materials and workmanship for a period of  TO CUSTOMERS: PLEASE MAKE SURE TO  thirty (30) days from the date of Your purchasing  READ THIS CAREFULLY BEFORE INSTALLING  any our products accompanying the Program.  OR USING THE SOFTWARE PROGRAM  JVC’s entire liability and your exclusive remedy  NAMED “DIGITAL PHOTO N
                    
                    ページ5に含まれる内容の要旨 
                    
                        ENGLISH NOTE 6 TERM If You acquired the Program in Germany, the  This Agreement will become effective on the date  provisions of Sections 4 (Limited Warranty)  when You install and use the Program on Your  and 5 (Limited Liability) provided above will be  machine, and continue to be in effect until the  replaced with those of the German version of this  termination under the following provision. Agreement. Should You breach any provision of this  Agreement, JVC may terminate this Agreement  with
                    
                    ページ6に含まれる内容の要旨 
                    
                         Read This First! How to Select an Item Using the Touch Sensor An example screen in English is used for the guidance below.  Selecting an item from the menu list  Using on-screen buttons (on the menu screen: p. 64) (e.g. during playback: p. 28) A MENU IMAGE QUALITY IMAGE SIZE  GAIN BASIC SETTINGS B  A   To select an on-screen button appearing    Slide your fi nger up and down on the  on the left side, touch the portion of the  sensor. sensor next to the on-screen button.   Touch the OK button. B 
                    
                    ページ7に含まれる内容の要旨 
                    
                        ENGLISH Make a backup of important Because the camera may be  recorded data used for demonstration in a  shop, the demonstration mode  JVC will not be responsible for any lost  data. It is recommended to copy your  is set to [ON] by default important recorded data to a DVD or other  To deactivate the demonstration mode, set  recording media for storage. (p. 44) [DEMO MODE] to [OFF]. (p. 67) Make a trial recording When connecting the camera  Before the actual recording of important  to other devi
                    
                    ページ8に含まれる内容の要旨 
                    
                         Contents GETTING STARTED EDITING/PRINTING Accessories .......................................... 10 Managing Files ...................................... 33 How to Use the Everio Dock ........................10 Deleting/Protecting Files ..............................33 Attaching the Shoulder Strap .......................11 Viewing File Information ..............................34 Preparing the Remote Control .....................11 Changing the Event Registration of Video  Attaching the Core Fi
                    
                    ページ9に含まれる内容の要旨 
                    
                        ENGLISH PC OPERATION Regarding the Icons in this  ® File Backup on a Windows PC ........... 51 Manual System Requirements .................................51 Software Installation ....................................52 Icon at the top of a page Connecting the Camera to the PC ...............53 File Backup on the PC .................................54 File Backup on the PC without Using  Software ..................................................... 55 ® Other Windows PC Operations .......... 56 
                    
                    ページ10に含まれる内容の要旨 
                    
                         GETTING STARTED  Accessories AC Adapter Battery Pack Audio/Video Cable USB Cable AP-V18U/14U BN-VF808U (p. 42, 44, 53 and 60) Shoulder Strap CD-ROM Remote Control Unit Lithium Battery (p. 11) (p. 52) RM-V751U (p. 11) CR2025 Pre-installed in the  remote control unit. NOTE Make sure to use the provided cables for  Everio Dock Core Filter connections. Do not use any other cables. CU-VC6U (see below) (Large and small) (p. 11) How to Use the  Everio Dock You can connect cables to the connectors of t
                    
                    ページ11に含まれる内容の要旨 
                    
                        ENGLISH Attaching the Shoulder Strap Peel off the pad and thread Thread the strap through the Position the buckle near the  the end of the strap through buckle, adjust its length, and use eyelet and reattach the pad. the eyelet. the strap guide to fi x it in place. Buckle Strap Guide Eyelet  Preparing the Remote Control A battery is included inside the remote control at the time of purchase. Remove the insulation sheet before use. Effective Beam Distance To Reinsert the Battery Pull out the batte
                    
                    ページ12に含まれる内容の要旨 
                    
                          Index NOTES   The LCD monitor can rotate 270°. �   Power-linked operation •  You can also turn the camera on/off by  opening/closing the LCD monitor during the  recording mode.  Be careful not to cover  ,  ,  and   � during shooting. 12                                                                                                                                                                                                                                                                      
                    
                    ページ13に含まれる内容の要旨 
                    
                        ENGLISH Camera Remote Control  Touch Sensor (p. 6)  Infrared Beam Transmitting Window  OK (DISP) Button [OK/DISP] (p. 15)  ZOOM (T/W) Buttons  Menu Button [MENU] (Zoom in/out during playback.)  Power Button [POWER]  Up Button (You can turn off the camera by pressing Rotate Button (counterclockwise) (p. 28) and holding this button.)  Skip Backward Button  Speaker  Left Button  Playback/Recording Mode Switching  Button [SELECT PLAY/REC] (p. 20)  Back Button  Access Lamp [ACCESS]  PLAYLIST Button (
                    
                    ページ14に含まれる内容の要旨 
                    
                        Indications on LCD Monitor  During both Video and Still Image During Video Recording Only Recording [ ] 5h56m 0:04:01 REC 1/4000 HDD ± 0 200X F5.6  Mode Indicator (p. 20) APR.   8.  2008   12:13PM  ND Filter Indicator (p. 25)  AV/S-Video Input Jack Indicator (p. 65)  Selected Operation Mode Indicator  Picture Quality: (p. 64)  :  Auto Mode    (ULTRA FINE),   (FINE),   :  Manual Mode    (NORMAL),    (ECONOMY)    Effect Mode Indicator (p. 27)  Remaining Time (p. 20, 75)  Tele Macro Mode Indicator 
                    
                    ページ15に含まれる内容の要旨 
                    
                        ENGLISH During Video Playback During Still Image Playback 9:55:01 101-0098 X5   HDD HDD 5 APR.   8.  2008   12:13PM APR.   8.  2008   12:13PM  Mode Indicator  Mode Indicator  Effect Mode Indicator (p. 30)  Effect Mode Indicator (p. 30)    Wipe/Fader Effect Indicator (p. 31)  Folder/File Number   :  Playlist Playback Indicator  Slide Show Playback Indicator (p. 28) (Appears when playing back a playlist.)  Selected Medium Indicator (p. 66) (p. 39)   :  Event Search Playback Indicator  Battery Indi
                    
                    ページ16に含まれる内容の要旨 
                    
                        Necessar y Settings before Use Be sure to confi gure the following three   To detach the battery pack settings before use. Slide and hold BATT. (step 2), then  remove the battery pack.  To check the remaining battery power   Charging the Battery Pack See page 18. NOTES 1 Close the LCD monitor to turn off the   You can also use the camera with just the  � camera. AC adapter.  Please do not pull or bend the AC adapter  � plug and cable. This may damage the AC  2 Attach the  battery pack. adapter. S
                    
                    ページ17に含まれる内容の要旨 
                    
                        ENGLISH   Date/Time Setting  Langua  ge Setting The language on the display can be changed. 1 Open the LCD monitor to turn on the  camera. 1 Open the LCD monitor to turn on the  camera. 2 When [SET DATE/TIME!] appears,  select [YES] within 10 seconds. 2 Touch the MENU button. SET DATE/TIME! 3 Select [BASIC SETTINGS]. YES NO IMAGE QUALITY IMAGE SIZE GAIN If you do not select within 10 seconds, the  BASIC SETTINGS screen disappears. In such case, press  the POWER button and turn the camera  on aga
                    
                    ページ18に含まれる内容の要旨 
                    
                        Other Settings NOTES Grip Adjustment  If “COMMUNICATING ERROR” appears,  � there may be a problem with your battery.  Open the pad and make grip adjustments. In such a case, consult your nearest JVC  dealer.  The recordable time display should only be  � used as a guide. It is displayed in 10 minute  units.  Tripod Mounting Align the camera stud hole with the tripod  stud, and the mounting socket with the screw,   Lens Cover and then rotate the camera clockwise to  mount it to the tripod. When n
                    
                    ページ19に含まれる内容の要旨 
                    
                        ENGLISH NOTES  When Using a microSD Card  Insert and remove the microSD card only  � while the power is turned off. Otherwise,  If you want to record to a microSD card,  data on the card may be corrupted. the following three operations need to be   Do not touch the terminal on the reverse  � performed. side of the label.  Operations are certifi ed on the following  � microSD cards. Video recording: Class 4 or higher  compatible microSDHC card (4 GB)   Change the recording medium Still image recor
                    
                    ページ20に含まれる内容の要旨 
                    
                        RECORDING Recording Files  Video Recording Preparation: Open the LCD monitor to turn on the camera.  Slide the mode switch to select Press the SELECT PLAY/REC   (video) mode. button to select recording mode. Press the START/STOP button to  start recording. [5h56m] REC Approximate remaining time for  recording appears.  To stop recording  To change the aspect ratio of the image  Press the START/STOP button again. (16:9/4:3)  To view the video you just recorded Change the settings in [SELECT ASPEC