ページ1に含まれる内容の要旨
®
MICRO-AMP System
MA3 and MA3P Modulated Amplifiers
®
Banner MICRO-AMP modules MA3 and MA3P are modulated amplifiers designed
for use with the miniature SP100 Series remote sensors. Miniature photoelectric
sensors, such as the SP100s, have traditionally been used as non-modulated devices with
very limited response. These specially-engineered amplifiers bring about a dramatic
improvement in the optical performance of miniature remote sensors.
MICRO-AMP modules are powered by 10 to 30 v
ページ2に含まれる内容の要旨
Sensors for use with MA3 and MA3P Modulated Amplifiers Temperature range for all miniature modulated remote sensors is 0 to 70 degrees C (+32 to 158 degrees F). Sensors are epoxy-encapsulated and optics are hermetically sealed. Models/Dimensions Excess Gain Beam Pattern SP100E & OPPOSED Mode Sensors SP100R SP100E and SP100R miniature opposed sensors have a slim right-angle design which allows them to be mounted in very tight locations. The thin, flexible rib- Range: 8 inches (20cm) bon ca
ページ3に含まれる内容の要旨
® MICRO-AMP System Accessories RS8 Socket Beam Pattern The RS8 socket is the most fre- Dimensions, MA3 and MA3P, shown with RS8 quently used means of mount- Wiring Socket ing and wiring a MICRO-AMP module. It consists of a socket with two four-terminal connec- tion strips, all wired together onto a PC board. The PC board assembly slides into a 1 inch (25mm) long PVC track which is used to mount the entire as- sembly. A hold-down screw keys the correct polarity of the module. RS8K So
ページ4に含まれる内容の要旨
MPS-15 and MPS-15-230 Power Supplies The MPS-15 Series power supplies are designed specifically to supply power for the Banner MICRO-AMP series amplifiers and logic modules. They are constructed on small PC boards that are track-mountable for compatibility with other track-mounted MICRO- AMP components. The MPS-15 includes a socket for a MICRO-AMP amplifier or logic module having current sinking (NPN) output*. The combination of an MPS-15 series power supply and a MICRO-AMP module makes a
