ページ1に含まれる内容の要旨
Quicksilver Audio M135Mono Amplifier
Operating Instructions
Thank you for purchasing the Quicksilver Audio M135 Mono Amplifiers. These amplifiers have been engineered to
have a very wide bandwidth, extremely low distortion and superior dynamic range.
The output transformer used in this amplifier is based on the best designs of the past but uses superior new materials
to achieve a very high level of performance. The high frequency characteristics of this transformer are so stable that
many diffe
ページ2に含まれる内容の要旨
4 AMP SLO-BLO FUSE Standard fuse value must not be exceeded. If a fuse blows, replace and check output tube bias. If there is a large change in any tube, then that tube is probably damaged. If the bias has not changed then the cause of the fuse blowing may be due to other problems, such as poor system grounding, unstable preamp, shorted speaker, etc. Interchanging the amps between channels will help localize the problem to either the system or the amplifier. TUBES The input tubes in this ampl
ページ3に含まれる内容の要旨
Quicksilver Audio M135 Mono Amplifiers SPECIFICATIONS Power Output =135 watts into 4 or 8 ohms from 20Hz to 20 KHz Power Bandwidth =10 Hz to 100 KHz Input Sensitivity =1.33 volts Power Supply Energy Storage =575 joules Dimensions - Chassis = 13“ deep x 17” wide x 8” high - Front panel =19" wide x 8 3/4" high, Rack handles 2" deep Finish - Chassis =Textured black - Front panel =Silver anodize, Rack handles black Weight =70 lbs Tube Complement = 1 - 12FQ7 1 - 12AU7
