ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
ND-20292 APRIL, 1990 CHAPTER 1 SYSTEM DESCRIPTION TABLE OF CONTENTS Pulse Code Modulation (PCM) technique and time division switching. SECTION DESCRIPTION PAGE Businesses, both small and large, with single or GENERAL . e....... . . . . . . . loo-1 110 multiple locations, can derive maximum benefit from the Electra MarkII’s port oriented system design. 120 REGULATORY INFORMATION . . + . . . . . . . loo-1 The Electra Mark11 can provide termination for up to 80 stations and up to fo
ページ4に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 jack is provided by the telephone company. Jacks for 120.4 EMITTED RADIO FREQUENCY this type of customer provided equipment will not be INTERFERENCE provided on party lines or coin lines. In compliance with FCC Part 15 rules, the following statement is provided: The telephone company may make changes in its technical operations and procedures. If such changes IMPORTANT NOTE affect the compatibility or use of this telephone system, the telephone company is
ページ5に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 -0. ecu Central Control Unit Other Common Carriers CNF Conference Card (feature and control occ Off-Premises Extension button as well) OPX CPU Central Processing Unit -P- co Central Office co1 Central Office Line Interface PC Portable Computer PCM Pulse Code Modulation -D- PE Primary Extension DID Direct Inward Dialing PSU Power Supply Unit DIR Directory Key PT Power Failure Transfer, Tip Side DIT Direct Inward Termination PR Power Failure Transfer
ページ6に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 part of the call record generated and can be up to ANCILLARY DEVICE CONNECTION: The Electra Mark11 Multiline Terminals have the ability to thirteen digits long. A maximum of 500 recognizable --\ support the additional operation of either a headset codes are possible in a system (must be programmed by ..) jack, automatic dialer, handset amplifier, external / the Attendant). A CPU-EB3 (or higher revision level) speakerphone, or modem. This is made possi
ページ7に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 AUTOMATIC CALLBACK allows users to prompt Electra Mark11 System when an outside party the system to notify them when a busy extension abandons the call (for this feature to function, the becomes available. After calling a busy extension, set outside line must provide a timed disconnect signal). an Automatic Callback by dialing * 1 (as set in default). Automatic Release is normally provided with Ground When both parties are idle, the system signals the Start
ページ8に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 The LCD indicates the number of Callback Messages (a maximum of five, including Message Waiting from an attendant and from the voice mail). The messages can be scanned one at a time. Each message display gives the time the message was left, identifies the caller, and provides a number to call. Callback Messages can be cleared while the terminal is idle, or will be automatically removed when the call is returned. CALL FORWARD - ALL CALLS allows a station
ページ9に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 station in the system or network. The ability to CODE/CALL RESTRICTION aids in the ability to originate or receive Camp-On (a form of Transfer to tailor the station dialing restriction to every busy extensions) is based on the Class of Service customer’s individual needs. The Electra Mark11 offers assignment of both stations. an advanced network of restrictions to control outside calls, based upon area and local office codes. The CENTREX RINGING provides tw
ページ10に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 100-6 ETE-16K-1 Multiline Terminal). Each page Multiple Delay Announcement: First and Second are can contain up to ten frequently called numbers. available with a CPU-EC4 (or higher revision level) .--l, Depressing the directory button causes the pages to .i ETU. / change. Depressing one of the selection buttons, while DELAYED RINGING is provided to Multiline a particular page is being displayed, generates a speed Terminals that are utilized as seconda
ページ11に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 message mode, the associated green LED also provides provided call alerting device (loud bell ringer), this the Attendant with the status of messages left for busy feature provides for wide area coverage or loud ringing or unattended stations. for noisy locations. Up to two DSSIBLF Consoles can be set to function EXTERNAL ZONE PAGING (WITH MEET ME) with an Attendant Position. Up to three Attendant enables system users to quickly, and easily locate and
ページ12に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 Either method allows a Multiline Terminal user to The RECALL to a station is controlled by a timer that initiate or receive a call (outside or internal) and can be preprogrammed by the installer. converse without lifting the handset. .::; The LED at the holding station will flutter green (the .‘J GROUND START TRUNKS minimize the ETE-6-( ) LED is red), while at other stations it will possibility of incoming and outgoing calls colliding on remain steadily Ii
ページ13に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 INTERNAL ZONE PAGING (WITH MEET-ME) dialed, the Message Waiting indicator changes; i.e., allows anyone (if allowed by Class of Service) within LCD may have shown MSGJ, after call to the calling station, LCD shows MSGB. The red LED (MW) on the the Electra Mark11 System to generate a voice page via ETE-64 ), the ETE-16-( ) or Single Line Telephone station speakers to a selected zone or to all zones of the with a Message Waiting lamp, is extinguished by the
ページ14に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 NIGHT CHIME(S) control is provided when the Each modem (four maximum) must be able to respond system is equipped with an ECR-E ETU. The ECR-E to Keyboard commands such as the HAYES@ ETU contains ten relays. Three of these relays (one Commandset, provide auto answer, and must be 1 per tenant) can be programmed to provide closures supported by an SLI-E ( ) ETU port, a Multiline Terminal with LCD (equipped with a DTA-E Unit), when incoming CO/PBX calls are re
ページ15に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL,1990 PROGRAMMING from Multiline Terminals of RESTRICTION (INCOMING) allows the system functions is permitted locally at any of up to assignment, on a per station per trunk group basis, of three ETE-16D-( 1 Multiline Terminal positions, or restricting a station’s ability to answer incoming calls. remotely at a PC, using an RAA-E Unit. Most changes to the system program can be entered while the system RESTRICTION (OUTGOING) allows the is in full operation. assig
ページ16に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 3. ETE-16-2, dial access to 20 memories. STATION MESSAGE DETAIL RECORDING; SMDR-E is an optional ETU which provides detailed 4. ETE-16D-( 1, direct selection and/or dial access to call record information about the telephone usage of the 20 memories. the system. Call records are generated for incoming, outgoing, conference, and transferred outside calls. 5. ETE-16&l, direct selection to 110 memories. Station identification, trunk identification, time of ori
ページ17に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 Speed Dial memories, Night Chimes, and Night Call (or higher revision level) ETU is required to support Pickup can be provided. this feature. TONE OVERRIDE allows station users to signal an TRUNK QUEUING allows station users to increase in-use extension they want to talk to. Once alerted, a their call processing efficiency in a high traffic Multiline Terminal user can immediately answer the environment. The system must be supported with a Override by dep
ページ18に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 Voice or Tone Signaling, Ringing Tone selection, VIRTUAL EXTENSIONS are forty eight software Station Speed Dial memories, Background Music extensions available beyond the maximum of eighty channel, Direct Station Selection assignment, and station based extensions. Virtuul Extensions can be direct feature access assignment. assigned to line keys as desired. The system total of extensions cannot be more than 128, which is The ETE-16K-1 Multiline Terminal prov
ページ19に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL,1990 SECTION 150 LCD INDICATIONS DISPLAY LOCATION DEFINITION INITIALIZE All Stations System is Initializing NIGHT All Stations System in Night Mode EXT NUMBER? Originator Prompt in Call Pickun Directed VACANT Originator Speed Dial Memory Buffer Status ACCOUNT CODE ? Originator Prompt for Entering Account Code MUSIC NBR ? Originator Prompt for Station BGM Selection MUSIC 1 SET Originator Confirmation of Station BGM Channel LK15 RECALL Originator Hold Reca
ページ20に含まれる内容の要旨
ND-20292 CHAPTER 1 APRIL, 1990 LCD INDICATIONS (Continued) DISPLAY LOCATION DEFINITION CO LINE Originator On CO Line Key (Before Dialing) CONFERENCE 03:46 Conference Originating CO Conference Elapsed Time Station Called/Calling Station During Internal Call PAUL.A 201 CONFERENCE Conference Party During Conference LK16 TR COCALL Receiving Station Receiving CO Transfer LK16 NE1L.A 201 Cal:;;d Station Receiving Internal Call (from 201) Receiving Station Receiving Internal Transfer LK16
