ページ1に含まれる内容の要旨
OWNER'S MANUAL
INTEGRATED CAR CASSETTE + CD PLAYER
WITH DSP CONTROL
SUPER POWER OUTPUT
SLIDE-DOWN FACE DETACHABLE PANEL
FM-AM FM-MPX RADIO RECEIVER
WITH REMOTE CONTROL
MODEL:LCDCS92
Page. 1
P / N : 570-111802-03
ページ2に含まれる内容の要旨
BEFORE YOU BEGIN INSTALLATION Before you begin to install the car radio, please follow the below procedure in step by step. Otherwise, the CD Player can not be operated properly. A) Put the detachable panel back to the car radio as shown in Diagram A ( point 1 and 2 ). B) Press the slide down eject button ( Diagram A point 3 ) until the panel is in horizontal position as shown in Diagram B. C) Take out the warning label as shown in Diagram B ( point 4 ). D) Pull out the CD Protection Card in the
ページ3に含まれる内容の要旨
LOCATION OF CONTROLS OPERATING INSTRUCTIONS 1. POWER ON/OFF CONTROL Press this button to turn the power "ON" or "OFF". 2. BAND SELECTOR Each time this button is pressed, the radio band is changed. The indication "FM1", "FM2", "FM3", "MW1" or "MW2" will appear on the display panel according to your selection. 3. LOCAL/DISTANT SELECTOR Press this button to prevent strong local stations from overlapping weaker stations. For normal operation, press this button again for distance. 4. STEREO/MONO CONT
ページ4に含まれる内容の要旨
11. CD EJECT BUTTON Press this eject button will eject the compact disc. Note: If you want to release the compact disc, press the release slide down button (# 24) first until the panel is in horizontal slide position (Diagram B). Then, press the CD eject button and the compact disc will eject automatically. 12. DETACHABLE RELEASE BUTTON Press this button to release the detachable panel. To detach the front panel, press the button so that the left side of the panel is released. Grasp the releas
ページ5に含まれる内容の要旨
23. MODE CONTROL Press this button to select either in CD, TAPE or Radio mode. 24. SLIDE DOWN EJECT BUTTON (Diagram D) Press this button to let the panel slide down from vertical position to horizontal position. The CD slot is shown. To put the panel back to origional position, use your fingers to push up the panel upwards until the panel is locked in vertical position. 25. RESET BUTTON This RESET button is recessed in order to prevent accidental engagement, and can be activated with the t
ページ6に含まれる内容の要旨
BAND SWITCH Use small screw driver to select either in Europe or in USA band stepping by moving the switch left or right. INSTALLATION 1. Install brackets and screws removed from your old radio (not provided with this radio). 2. Slide radio and frame into dash opening. 3. Trim ring has precut grooves on the back of it. The size of the trim ring can be reduced (made small er) for different types of installations. Hold the trim ring firmly in one hand, and using a pair of pliers, grasp the t
