ページ1に含まれる内容の要旨 
                    
                         
Modulaire AM/FM Component Stereo System 
(120-1469)                 Controls                   Faxback Doc. # 18931 
 
POWER SWITCH 
 
Depressing the white dot on the switch will turn the unit on, at which time 
the dial will illuminate. 
 
SELECTOR SWITCH 
 
This switch will select the program source that will be reproduced by your 
system. 
 
AM 
 
In this position, all standard AM broadcasts are reproduced. 
 
FM MONO 
 
In this position, all FM broadcasts will reproduced monaurally.  If th
                    
                    ページ2に含まれる内容の要旨 
                    
                          BASS AND TREBLE    These controls increase or decrease the bass and treble tones and should  be set in accordance with listening preference, and room acoustics.    TUNING    This control allows selection of stations on either the AM or FM band.  After desired station is found and heard, look at tuning meter and adjust   for maximum deflection (meter hand to the Right).  This tuning position   will provide best separation on FM stereo and minimum noise on MONO FM and  AM reception.    PHONO INP
                    
                    ページ3に含まれる内容の要旨 
                    
                          For AM, all that is usually required is a long piece of wire connected to  the AM terminal.  This may improve reception: however, it may also  increase the noise level being picked up.                                                                                                                                                                                                                                                                                                                          
                    
                    ページ4に含まれる内容の要旨 
                    
                          Modulaire AM/FM Component Stereo System  (120-1469)                 Installation               Faxback Doc. # 18932    POWER REQUIREMENTS    Connect the AC line cord into any outlet furnishing 117 volts 50-60 cycles  AC current.    CONNECTING SPEAKERS    Connect the speakers to the receiver by using the supplied cables.  The  speaker on the right, as you face the unit, should be connected to the  jack marked RIGHT.  Use the same procedure to connect the left speaker.  Speakers may be placed in
                    
                    ページ5に含まれる内容の要旨 
                    
                          Modulaire AM/FM Component Stereo System  (120-1469)                 Specifications             Faxback Doc. # 18933    BANDS     MEDIUM WAVE (MW):........................................535 to 1605 KHz     FM (FM):..................................................88 to 108  MHz  CONTROLS     TUNING CONTROL:.............................Indirect slide rule (Rotary)     VOLUME CONTROL:...................................................Rotary     SELECTOR:.................................AM/FM-MON
                    
                    ページ6に含まれる内容の要旨 
                    
                          Audio Connection Information  (120-Series)               Plug/Male 2 Ch. System     Faxback Doc.# 19994    +----+--------------+---------------+------------+------------------------+  |Pin |              |               |            |                        |  |No. |  WIRE COLOR  |  WIRE SPECS.  |   LABEL    |    REMARK              |  +----+--------------+---------------+------------+------------------------+  | 1  |   WHT/BLK    |   AWG #20     |  FRONT L-  |   STRIP SOLDER         |  |    |
                    
                    ページ7に含まれる内容の要旨 
                    
                                                 (2CH/4CH SWITCHABLE UNIT)  +----+--------------+---------------+------------+------------------------+  |Pin |              |               |            |                        |  |No. |  WIRE COLOR  |  WIRE SPECS.  |   LABEL    |    REMARK              |  +----+--------------+---------------+------------+------------------------+  | 1  |   WHT/BLK    |   AWG #20     |  FRONT L-  |   STRIP SOLDER         |  |    |              |   2P CORD     |            |             
                    
                    ページ8に含まれる内容の要旨 
                    
                        |Pin |              |               |            |                        |  |No. |  WIRE COLOR  |  WIRE SPECS.  |   LABEL    |    REMARK              |  +----+--------------+---------------+------------+------------------------+  | 1  |   WHT/BLK    |   AWG #20     |  FRONT L-  |   STRIP SOLDER         |  |    |              |   2P CORD     |            |                        |  +----+--------------+---------------+------------+------------------------+  | 2  |   GRY/BLK    |      "        | 
                    
                    ページ9に含まれる内容の要旨 
                    
                                  +---------+--------------+            |  White  |  Right (-)   |            +---------+--------------+            |  Brown  |  Left (+)    |            +---------+--------------+            |  Gray   |  Left (-)    |            +---------+--------------+            |  Red    |  +12 V Power |            +---------+--------------+               REAR                         +---------+--------------+            | GRN/BLK | Right (+)    |            +---------+--------------+            |