ページ1に含まれる内容の要旨
REFRIGERATOR MODELS: IF36BNDFSF, IF36INDFSF
INSTALLATION
CUSTOM OVERLAY PANEL
INSTRUCTIONS
WARNING: Individual door panels must not exceed the maximum weight specifications.
Custom decorator panels cover the door trim of Dacor IF36 series refrigerators for an attractive
Inutcortd Ino
seamless look that flows into the overall design of the room. Fabricate the panels first, then slide
them into the door trim frames. The panels are custom designed and installed by your cabinet
maker. Installatio
ページ2に含まれる内容の要旨
IF36 Panel Overlay Installation d roo Panel We Ight SPec If I t ca Ion S Panel Maximum Weight Specifications 1 15 lb. (7 kg) 1 1 2 2 30 lb. (14kg) WARNING: To prevent the unit from tipping forward and to provide a stable 1 1 installation, the refrigerator must be secured in place with an anti-tip device. Model: IF36BNDFSF Model: IF36INDFSF Two Doors Three Doors Plaen SPec If I t ac Ion S Backing Panel A D (Thickness = 1/4”) A* 17 7/8” (45.4 cm) B 42” (106.7 cm) No Trim No Trim C 23 13/16
ページ3に含まれる内容の要旨
IF36 Panel Overlay Installation f In ISh Ing the Inrne r efr I ort egra d oor S e dge S no t ehre d roo Model S See Detail “C” and “D” Top Trim Frame Trim Frame Screw Back of Door Black Finished Refrigerator French Style Refrigerator Door Surface Door Detail Front of Door Decorative 1/4” thick panel - Finish exposed edge Detail “C” Single Panel Method Top Trim Frame Trim Frame Screw Back of Door Black Finished Refrigerator Door Surface Front of Door 1/4” Backing Panel 1/8” Spacer o
ページ4に含まれる内容の要旨
IF36 Panel Overlay Installation h aendl d IMen SIno S and In S t aall t Ion • Before installing a custom panel assembly, you must install the custom handle hardware. • Dacor recommends handles with larger D-style pulls. If using screws with thick heads, they must be countersunk into the Example of panel before installing the handles. Door Handle • Any handle designed for use with an appliance should produce satisfactory results. • Mounting screw length varies with the total thickness o
ページ5に含まれる内容の要旨
IF36 Panel Overlay Installation Panel In S t alla t Ion NOTE: Remove the top door(s) to make panel installation easier. On three door models secure the inner edges of the overlays to the door where there are no trim frames using double sided tape. • With a Phillips screwdriver, remove the trim screws from the top trim frame on the freezer and refrigerator door(s). • Remove the trim. • Lower the overlay panel into the trim frames on the door. • With the panel in position, replace the t
ページ6に含まれる内容の要旨
IF36 Panel Overlay Installation n ote S Page 6
ページ7に含まれる内容の要旨
IF36 Panel Overlay Installation n ote S Page 7
ページ8に含まれる内容の要旨
Specifications subject to change without notice. Dacor assumes no liability for changes to specifications. Dacor Corporation ● 1440 Bridge Gate Drive, Diamond Bar , CA 91765 ● T el: (800) 793-0093 ● F AX: (626) 403-3130 ● www .Dacor .com
