ページ1に含まれる内容の要旨
InstruCtIons
use. inspector’s electrical
local for Instructions Installation Save
reference. future for Instructions
Installation Keep Homeowner:
homeowner. the with
Instructions Installation Leave Installer:
IMPORTANT:
instructions. these
save and Read
IMPORTANT:
Range
Freestanding
Electric 30”
A Rev 9750520 No. Part
Qn
I
I
KiitchenAPd
ページ2に含まれる内容の要旨
WALL WHERE ~ is oven frame minimum . . 1 . min. I / - l I l I I I I I o I ., ’ 18 \ L e ? . \ \ \ \ \ / \ I . -JY mln. 26 alumlnum mln. B Save l stud: l 3116.Inch l l l 2 x 9 2 A Panel injury. amperes). (40 appliance the personal or shock electrical fire, a in result of rating the with conform must connections anchors plastic could instructions these follow to Failure :ket and ONLY) WIRE (COPPER sizes Wire box). shock. electrical from inj
ページ3に含まれる内容の要旨
I 7 % (12( \ mark mark n l l With l l 1 I I 1 i i mark mark I l l l nuts l B Panel location. new the in reinstalled range. of back the on 181 and removed be must bracket anti-tip located cover block terminal the Remove . the location, new a to moved is range range. the under from hardboard or If Instructions. Installation these Save cardboard base, shipping Remove wall. rear from fermlnal cabinet. a to bracket anti-tip attach Not Do ,I, incGes 2 approximatel
ページ4に含まれる内容の要旨
OFF To most efficient from electric to electric for ding - IW Numbers correspond - - C Panel B. Panel 12, Step at installation Continue cover. block terminal the Replace connector. conduit the of screws clamping and ring locking the or (El screws clamping relief strain the Tighten . tight. installed are nuts the that sure Be terminal. the on already nuts installed factor-y the loosen Not Do range. the to attached strip plastic a on provided are that nuts brass the tighten
ページ5に含まれる内容の要旨
l l 49022 Michigan Harbor, Benton KitchenAid, by Prepared KitchenAid of Trademark Registered 8 KitchenAid. 1996 0 A Rev. 9750520 No. Part bracket. anti-tip in secure is cable that sure Make supply. electrical the Reconnect range. the Level bracket. anti-tip into cable Insert position. operating into back range Move maintenance. or cleaning complete to range remove and bracket anti-tip the from cable the Remove line. supply electric the disconnect to necessary as far as only out ran