ページ1に含まれる内容の要旨
Docking System for iPod® and iPhone™
Owner’s Manual
JiMS-520i
(iPod and iPhone Not Included)
Please read this Instruction Manual carefully before
using the unit and retain it for future reference
ページ2に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET REFER SERVICING TO QUALIFIED PERSONNEL ONLY. The Caution marking is located at the bottom of the unit The rating plate is located at the bottom of the unit CAUTION: PLEASE READ AND OBSERVE ALL WARNINGS AND INSTRUCTIONS GIVEN IN THIS OWNER’S MANUAL AND THOSE MARKED
ページ3に含まれる内容の要旨
7. Do not block any of the ventilation openings. Install in accordance with the manufacturer’s instructions. IMPORTANT SAFETY INSTRUCTIONS (Continued) 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose of the polarized or grounding – type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third ground
ページ4に含まれる内容の要旨
This Class B digital apparatus complies with Canadian ICES-003. FCC NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful inte
ページ5に含まれる内容の要旨
TABLE OF CONTENTS WELCOME! ........................................................................................................................................... 5 PROTECT YOUR FURNITURE............................................................................................................. 5 ABOUT THIS MANUAL ......................................................................................................................... 5 LOCATION OF CONTROLS.........................
ページ6に含まれる内容の要旨
WELCOME Thank you for purchasing the JENSEN JiMS-520i Docking System. Before operating the unit, please read this manual thoroughly and retain it for future reference. PROTECT YOUR FURNITURE!! This system is equipped with non-skid rubber ‘feet’ to prevent the product from moving when you operate the controls. These ‘feet’ are made from non-migrating rubber material specially formulated to avoid leaving any marks or stains on your furniture. However certain types of oil based furnit
ページ7に含まれる内容の要旨
8. SNOOZE/LIGHT Button 17. Display 9. Play/Pause Button Rear View 1. AC INPUT SOCKET 5. HEADPHONE Jack 2. FM Antenna Wire 6. RESET Button 3. S-VIDEO OUT (iPod/iPhone) 7. AM LOOP Antenna Connector 4. AUX IN Jack Display Unit 1. SLEEP Indicator 7. iPod Mode Indicator 2. ALARM 1 Wakeup Mode Indicator 8. PM Indicator 3. ALARM 2 Wakeup Mode Indicator 9
ページ8に含まれる内容の要旨
Remote Control Unit POWER Turns the System On/Off BAND Selects AM or FM Band FUNCTION Selects Radio, iPod or Aux Mode 0 – 9 Numeric Buttons PRESET STATIONS ▲ Set & Access Stored Stations Up PRESET STATIONS▼ Set & Access Stored Stations Down EQ Equalizer Options MEMORY Programs Preset Stations +, – Adjusts Volume Up and Down Activates Play/Pause Function ! Skips Forward/Tuning Up/Sleep
ページ9に含まれる内容の要旨
GETTING STARTED Unpacking the JiMS-520i Docking System Please save all the original packaging. It provides the safest way to transport your unit. NOTE: The JiMS-520i is not magnetically shielded and may cause color distortion on the screen of some TVs or video monitors. To avoid this, you may need to move JiMS-520i further away from the TV or monitor if unnatural color shifts or image distortion occurs. Using the FM and AM Antenna Before using your docking system please make su
ページ10に含まれる内容の要旨
i. To activate the Remote Control, remove the protective film. ii. Point the remote control toward the front of the main unit. The effective range of the remote is about 15~19 ft from the remote sensor and within an angle of about 45° from the front of the unit. Remote Control Battery Replacement Please replace your battery if the operating distance of the Remote Control drops drastically. 1. Remove the battery cover. 2. Install one new CR2025 Lithium battery into the battery compartment a
ページ11に含まれる内容の要旨
the Volume Level and then the frequency reading for about 1 minute and then revert to current time. Note: 1. When listening to an FM station, fully extend the antenna wire to insure maximum reception. 2. Automatic tuning operation may vary depending on the broadcast signal strength and also your distance from the broadcast tower, so weaker stations may be skipped. Tune manually to find the weaker stations. With stronger stations, the tuner may stop before it reaches the
ページ12に含まれる内容の要旨
4. To listen to your desired station, press the ▲ or ▼ Buttons or directly key in the preset channel using the NUMERIC Buttons. For example to receive preset station 5, first press the “0” Button and then the “5” Button. AUX OPERATION You can play other music sources (iPod shuffle, MP3, CD or other digital audio player) through the speakers of JiMS-520i by connecting its AUX IN Jack to your external player’s LINE OUT jack or headphone jack. 1. Plug one end of the included cord into the
ページ13に含まれる内容の要旨
iPod ADAPTORS Below are the iPod Adaptors included in the package. It is always recommended you use the adaptor that comes with your iPod first. This will help maximize a custom fit for your iPod when docked. iTouch & iPhone TABLE 1 12
ページ14に含まれる内容の要旨
DOCKING YOUR iPod 1. Press the Button to turn on the unit. 2. Press the FUNCTION Button to select the iPod mode. 3. According to TABLE 1, select a suitable adaptor for your iPod and insert it into the docking bay. Your iPod can now be inserted onto the docking connector by aligning the connector on the bottom of the iPod onto the connector in the docking bay. Note : Please be careful when seating your iPod onto the dock to avoid damaging the 30-pin connector in the iPod
ページ15に含まれる内容の要旨
DOCKING YOUR iPhone 1. Press the Button to turn on the unit. 2. Press the FUNCTION Button to select the iPod mode. 3. According to TABLE 1, select the 30G adaptor and insert it into the docking area. Your iPhone can now be inserted into the docking port by aligning the connector on the bottom of the iPhone onto the connector in the docking. Note: Please be careful when seating the iPhone onto the dock to avoid damaging the 30-pin connector in the iPhone or the docking system.
ページ16に含まれる内容の要旨
CONNECTING THE S-VIDEO ( for iPod with video output) rd th You are able to view videos and photos stored in your 5th generation iPod, iPod classic, 3 and 4 generation iPod nano and iPod touch on a standard TV screen or video display using the S-VIDEO OUT feature of the JiMS-520i. General Set Up 1. Plug one end of the included S-VIDEO cable into the S-VIDEO OUT Jack located on the back panel and the other end into the VIDEO IN of your TV or video display. 2. Switch on your TV or vi
ページ17に含まれる内容の要旨
7. To remove the iPhone from JiMS-520i, press and hold the Button for few seconds to switch off the device and then gently remove it from the docking connector. 8. To turn JiMS-520i off, press the STANDBY/ON Button again. USING HEADPHONES (NOT INCLUDED) Inserting the plug of your headphones (not included) into the Headphone jack will enable you to listen in private. When using headphones, the speakers will be disconnected automatically. Note: READ THIS IMPORTANT INFORMATION BEFO
ページ18に含まれる内容の要旨
3. To switch to iPod Wakeup mode, when the Alarm Wakeup Mode Indicator is flashing ( ), press the ! Button once, the iPod Wakeup Mode Indicator, , will appear and flash in the Display. 4. To switch to Radio Wakeup Mode, press the ! Button again when the iPod Wakeup Mode Indicator is flashing ( ), in the Display. The Radio Wakeup Mode Indicator, , will appear and flash in the Display. 5. Press the ALARM1 Button to confirm when the desired Wakeup Mode
ページ19に含まれる内容の要旨
i. If you have chosen “Wake to RADIO” alarm mode, make sure that you have tuned to a station and adjusted the volume to a comfortable level. ii. If “Wake to iPod” alarm mode is selected, make sure that there is an iPod docked in the System and the volume is set to a comfortable level. iii. In “Wake to iPod” alarm mode, the alarm will sound if no iPod is inserted in the System. SNOOZE OPERATION 1. When the alarm sounds (alarm, radio or iPod), you can press the SNOOZE Button to extend the
ページ20に含まれる内容の要旨
Display. Deactivating the SLEEP Timer If you want to exit the SLEEP mode simply press either the ALARM 1 or ALARM 2 button once. SLEEP AND WAKE TO ALARM, iPod OR RADIO 1. Refer “SETTING THE ALARMS” in above to set the desired wakeup time (s), wakeup mode, i.e. ALARM, iPod or RADIO and volume level. 2. Follow step 1-3 (shown above) under the “ADJUSTING THE SLEEP PERIOD” section to set the desired SLEEP time. The Radio is now programmed to turn off automatically at the Sleep
