Summary of the content on the page No. 1 
                    
                         
 
 
 
 
 
 
 
 
 
 
 
 
 
Instructions for the use of  
              
®
 E-A-RTONE    3A 
 
Insert Earphones  
 
 
 
 
 
 
 
Revised 1997 per ANSI S3.6-1996 and ISO 389-2:1994 
 12/99 
 
 
      
 
 
 
 
 
 
 
 
 
 
 
 
 
 
                                                                                                                                                                                                                                                                                 
                    
                    Summary of the content on the page No. 2 
                    
                          INTRODUCTION    ® Congratulations on the purchase of your new E-A-RTONE 3A Insert Earphones.  Whether you are performing hearing screening in  an educational or industrial setting, testing related to the fitting or evaluation of amplification, audiological research, or  ® comprehensive diagnostic assessment, E-A-RTONE 3A Insert Earphones provide many advantages that can enhance test reliability  and minimize or eliminate problems frequently encountered with supra-aural headphones.    ® Because
                    
                    Summary of the content on the page No. 3 
                    
                                ® 1.  Preliminary Procedures for Use of the E-A-RTONE 3A  ® Initially examine the ear canal for obstruction(s) and evaluate the proper size  E-A-RLINK disposable foam eartip needed to fit the  ® particular ear canal.  Although the standard E-A-RLINK 3A fits most ear canals, for smaller ear canals, the smaller diameter  ® E-A-RLINK 3B eartips are available.  It is important to obtain a good seal and achieve the proper insertion depth.  Insertion  ® ® procedures are the same for the E-A-RL
                    
                    Summary of the content on the page No. 4 
                    
                        Hz 125 250 500 1000 2000 4000 8000 -10 0 dB 10 20 30 40 50 60 70 80 90 100 110 Obtained Interaural Attenuation Full E-A-RLINK insertion in both ears Shallow insertion in dead ear only Shallow insertion in both ears   2.  Background Noise Reduction  ® ® A major benefit of the E-A-RTONE Insert Earphone in combination with the E-A-RLINK disposable foam eartips is the reduction  of background noise that might interact with the presented pure tones and influence the threshold determinations. When hea
                    
                    Summary of the content on the page No. 5 
                    
                          ® 3.  Positioning of the E-A-RTONE  ® When positioning the E-A-RTONE unit on the subject, avoid sound tube contact with the subject’s clothing.  Always use E-A- ® ® RLINK tips in both ears, or block the opposite ear with an E-A-R foam earplug.      4.  Cord Assembly and Unit Placement  The cord assembly is zip-cord constructed.  If more distance is needed between transducer cases carefully cut the insulation bridge  between the two cords and separate them to the desired distance.  The proper l
                    
                    Summary of the content on the page No. 6 
                    
                                ANSI S3.6-1996 and ISO 389-2:1994 Calibration Values  Frequency in Hz Coupler 2cc DB-0138 Coupler IEC 711 Coupler 2cc HA-1  125 96.0 98.0 96.5  250 84.0 87.5 84.5  500 75.5 79.5 76.0  750 72.0 76.0 72.0  1000 70.0 75.5 70.0  1500 72.0 79.5 70.0  2000 73.0 81.5 72.5  3000 73.5 83.0 72.5  4000 75.5 85.0 70.0  6000 72.0 86.0 67.5  8000 70.0 85.5 66.5    8. Correction Factors  Providers who need to switch between insert and supra-aural earphones may do so with properly calibrated equipment. 
                    
                    Summary of the content on the page No. 7 
                    
                                  ® 10.  Technical Specifications and Limits for E-A-RTONE 3A    Impedance:  10 Ohm, 50 Ohm or 300 Ohm    1 kHz Sensitivity: 102.5 dB SPL in DB-0138 (HA-2) coupler      @ 0.1 Volt rms. (10 V)      @ 0.2 Volt rms. (50 V)     103.5 dB SPL in DB-0138 (HA-2) coupler      @ 0.49 Volt rms. (300 V)    Limits:   ± 3 dB    Distortion:  < 3% measured @ 500 Hz, 118.5 dB SPL    Maximum output: Meets or exceeds 110 dBHL at standard     audiometric frequencies between     500 and 4000 Hz    Safe opera
                    
                    Summary of the content on the page No. 8 
                    
                          12. Limited Warranty    ® Aearo Company  warrants each insert earphone (sold under the name    E-A-RTONE 3A) it manufactures to be free from defects in  material and workmanship under normal use for a period of twelve (12) months from the date of sale to the original purchaser.   During this warranty period Aearo Company Auditory Systems will repair or replace, at Auditory Systems sole option, free of  charge, any defective part returned with shipping charges prepaid to the Distribution Center
                    
                    Summary of the content on the page No. 9 
                    
                              Aearo Company    Auditory Systems Production  8001 Woodland Drive  Indianapolis,  IN  46278    Customer Service (from the US only): 800/624-5955   Fax: 877/807-7113  International Customer Service Ph: 317/656-5713   Fax: 317/656-5760   Technical  Support  Ph: 317/692-6550   Fax: 317/692-6604       ©1995, 1990, Aearo Company Auditory Systems    ® ® ® E-A-R , E-A-RTONE and E-A-RLINK are all trademarks of Aearo Company   8