Summary of the content on the page No. 1
PS670 Series
P/N 58814
Gas
January 18, 2006
Domestic & Std. Export
ENGLISH
PS670 Series Gas Ovens
Model:
Combinations:
• PS670G Gas
• Single Oven
• Double Oven (Two-Stack)
• Triple Oven (Three-Stack)
OWNER'S OPERATING AND
INSTALLATION MANUAL
for domestic and standard export ovens
©2006 Middleby Marshall Inc.
is a registered trademark of Middleby Marshall, Inc. All rights reserved.
Middleby Cooking Systems Group • 1400 Toastmaster Drive • Elgin, IL 60120 • (847)741-3300 • FAX (847)741-4406
Summary of the content on the page No. 2
2
Summary of the content on the page No. 3
Table of Contents Page Page SECTION 1 IV. ASSEMBLY ...................................................................... 8 DESCRIPTION .................................................................... 4 A. Base Pad, Legs, Casters, and Stacking .................. 8 I. OVEN USES .................................................................... 4 B. Restraint Cable Installation ...................................... 8 II. OVEN COMPONENTS .................................................... 4
Summary of the content on the page No. 4
4
Summary of the content on the page No. 5
5
Summary of the content on the page No. 6
6
Summary of the content on the page No. 7
7
Summary of the content on the page No. 8
8
Summary of the content on the page No. 9
9
Summary of the content on the page No. 10
10
Summary of the content on the page No. 11
11
Summary of the content on the page No. 12
12
Summary of the content on the page No. 13
SECTION 3 - OPERATION C. Temperature Control Display E. Message Bar Increase Decrease A. Main On/Off Button D. TEMP Set B. Conveyor Time Setting Left Right LOCATION AND DESCRIPTION OF CONTROLS A. Main On/Off Button C. Temperature Control/Display Turns all oven functions on or off. If the oven is below the set Displays the set point of both right and left sides of the point, it will rise to the set point and turn the conveyor on. oven. If it is turned off and the oven is above 200° F, the blowers
Summary of the content on the page No. 14
NORMAL OPERATION - STEP-BY-STEP- 2. Push the “ON/OFF” button to start the oven. The A. Main Screen controller will display the screen, as shown in 1. When the unit has been “OFF” for more than 1 minute Figure 3-3. the controller will display the screen saver, as shown in Figure 3-1. To start operation, push the “Enter/ Reset” button. The controller will display the “OFF” screen, as shown in Figure 3-2. ON/OFF button Figure 3-3 Main Screen ON Figure 3-1 Screen Saver 3. To change the temperature,
Summary of the content on the page No. 15
4. To change the conveyor belt speed, push the “TIME” C. Daily Shutdown Procedure button. The controller will display the screen, shown in 1. Make certain there are no products left on the conveyor Figure 3-5. To change the minute setting, push the “← ← ← ← ←” in the oven. arrow button. Then push either the “↑” arrow or “↓” arrow 2. Press the “ON/OFF” button to turn the oven off. buttons to increase or decrease the time accordingly. 3. Open the window to allow the oven to cool faster. To change
Summary of the content on the page No. 16
III. QUICK REFERENCE: TROUBLESHOOTING SYMPTOM PROBLEM SOLUTION Oven will not No electrical power • Check that the circuit breaker/fused disconnect is on. Make turn On. sure the emergenct stop button is on. Oven will not No gas pressure • Make sure main gas is on. heat. Burner did not light • Turn oven off, and restart. If it still does not light, call for service. Oven is operating, but Air fingers may be as- • Turn oven off, and allow to cool. Reassemble fingers little or no air is coming semb
Summary of the content on the page No. 17
17
Summary of the content on the page No. 18
18
Summary of the content on the page No. 19
19
Summary of the content on the page No. 20
20
