Summary of the content on the page No. 1 
                    
                         
 
 
 
 
 
 
 
OPERATING INSTRUCTIONS 
 
 
 
 
 
 
 
 
- 
 
- 
KEYLESS ENTRY SYSTEM the following features may not be available depending on the type of input used to 
 
• Y RUN MODE  
This device complies with FCC Rules part 15. Operation is subject to the following 
 
two conditions: 1) This device may not cause interference, and (2) this device must 
 
accept any interference that may be received, including interference that may 
 
cause undesired operation.  The manufacturer is not responsi
                    
                    Summary of the content on the page No. 2 
                    
                          WARNINGS         TO:  a) Understand the operation of this system and its safety features.  b) Check for proper operation of these safety features prior to  against accident and theft.    DO NOT remote start the vehicle in a closed garage.  Make sure that the  Failure to observe this rule could result in injury or death from poisonous Carbon Monoxide fumes.    DO NOT install the Remote Engine Starting System on MANUAL TRANSMISSION vehicles or vehicles which ca n not be  vehicle. These vehicles 
                    
                    Summary of the content on the page No. 3 
                    
                                •     -               Engine will remain running for programmed run time until reset with Brake pedal or turned off with remote   SOLID 6 THEN SOLID   - UN SUCCESSFUL START:  In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then  nd rd   nd rd     If Third attempt fails to start engine, the system will turn off and doors will remain locked.  NO FURTHER ATTEMPTS WILL BE MADE AUTOMATICALLY             - lock/re -    arm if applicabl
                    
                    Summary of the content on the page No. 4 
                    
                              IDLE DOWN MODE  the vehicle.  The vehicle is put into a remote running condition before you exit and it will remain running for the      •    •      IDLE DOWN MODE - EXITING THE VEHICLE:                                 Engine will remain running for programmed run time. 6) en remote lock doors if desired. Exit vehicle th 5) Turn Ignition switch OFF.  Engine will remain running. 4) Doors will unlock, or if brake pedal is being depressed doors will unlock when it is released. 3) Parking Ligh
                    
                    Summary of the content on the page No. 5 
                    
                            IDLE DOWN MODE - EXITING THE VEHICLE:    IGN OFF UNLOCK - DOWN” or “INFINITY RUN” MODES:   With engine running in "IDLE DOWN" (parking lights ON), unlo ck door or (Remote unlock or disarm alarm if           START     INDEFINITELY after the programmed run time elapses .  This mode is especially desirable for protecting poli emergency, or work vehicles that need to be left running unattended.  This mode will allow the vehicle to be left                 the ignition key in the switch preventing
                    
                    Summary of the content on the page No. 6 
                    
                              – NG THE VEHICLE:       ll unlock.             IGN OFF 2X             REMOTE LOCK / UNLOCK:         - grind is enabled/disabled  Doors lock automatically when vehicle is Remote Started.  Starter Disable/Anti NOTES: ne is still being controlled by the remote starter. and lights will flash but return to solid indicating engi Parking lights will flash twice for unlock and once for lock.  If vehicle is remote started, engine will remain running 2)  s the Lock or Unlock transmitter button as yo
                    
                    Summary of the content on the page No. 7 
                    
                        - -    REMOTE TRUNK RELEASE:           n valet mode.  In the event of a lost or broken transmitter, the  -   With the key in the ON position, press and hold Program/Valet switch for 6 seconds.  LED will turn on                   - start and keyless entry (if needed).  This feature will maintain the original integrity and security of your vehicle’s      -  Prevents User from accidentally grinding the starter if the Ignition key is turned too far to the start position while        Starter Power Fu
                    
                    Summary of the content on the page No. 8 
                    
                                    TRANSMITTER PROGRAMMING:                         START CRIM ESTOPPER     , INC. 1770 SOUTH TAPO ST. SIMI VALLEY, CA. 93063  CRIMESTOPPER SECURITY PRODUCTS FLASH PRESS 4X's 4 FLASHES WAIT FOR OFF IGN TRANSMITTER PROGRAMMING: locations are learned, the unit will automatically exit code learning mode, otherwise turn key off and close hood. to be coded.  You should get light flashes with each code learned.  If all 4 code Press button #1 of the transmitter 4. Press Programming button 4 ti
                    
                    Summary of the content on the page No. 9 
                    
                          RS900I OP REVA