Summary of the content on the page No. 1 
                    
                         
 
 
 
CS-2012TW1 
 
Super Rage™ 
 
2-Way AM/FM Paging Remote Alarm, Keyless Entry System & Engine Starting  
 
System with 1-Way Sidekick Remote Control 
 
 
OPERATING INSTRUCTIONS 
 
CONGRATULATIONS on your choice of a CS-2012TW1 Super Rage™ Alarm & Remote Engine Starter by 
Crimestopper Security Products Inc.  This booklet contains the information necessary for operating your 
system.  If any questions arise, contact your installation dealer or Crimestopper Security Products Inc. 
 
*IMPORTA
                    
                    Summary of the content on the page No. 2 
                    
                        TABLE OF CONTENTS    Operation Cautions & Warnings……..………..………………………………………………………….….………2    2-Way LED Paging Remote………………………………………………………….………..….……….…..……..3    1-Way “SideKick” Non-Paging Remote……………….………..………………………………….……..…..……..4    Paging Tones & LEDs……….………………………………………….………..…………………..….….…..…….5  .  Operating Instructions - Alarm……………………………………………………….………..……………..……..6-9    LED Diagnostics………………..…………………………………………………………………….………..…..….9    Remote Engine Control………………………...……………………………………………………
                    
                    Summary of the content on the page No. 3 
                    
                        2-WAY LED PAGING REMOTE    PAGER / REMOTE TRANSCEIVER:   The hand-held remote transceiver is used to send and receive information from  the vehicle.  The Control Module transmits confirmation signals from the vehicle  to your pager. Your range will vary depending on location, terrain, and local RF  noise/interference.  This system is not guaranteed to page you if you are behind  concrete walls, underground, in a large structure, or in an area with high levels of  electronic interference.  Handle
                    
                    Summary of the content on the page No. 4 
                    
                        1-WAY “SIDEKICK” NON-PAGING REMOTE      The 1-Way sidekick remote adds flexibility  #2 to your CS-2012TW1.  You have the  convenience of operating your system  UNLOCK/ without needing to carry the pager remote.   DISARM The “Sidekick” remote offers all of the same  operation features remote, except the range #1 #5 is lower and it will not receive page-back  LOCK/ FLASHLIGHT confirmations from the vehicle.  See  ARM #6 diagram at right for Sidekick 1-Way remote  operation.  2ND VEHICLE   #3   BUT
                    
                    Summary of the content on the page No. 5 
                    
                            PAGING TONES & LEDs  CS-2012TW1 PAGING LEDs Blue LED: Orange/Green LED: Red LED: Yellow LED: Door Trigger Remote Start, Lock/Unlock,  Shock sensor, Ignition Hood/Trunk Trunk pop        PAGE-BACK:   FEATURE BUTTON ACTION BEEPS LED COLOR & FLASH  LOCK #1 (Lock) Press & Release 1X, then 1X Orange - 1X  UNLOCK #2 (Unlock) Press & Release 1X, then 2X  Green - 2X  AUX #1 #3 (Trunk) Press & Release 1X, then 3 fast Yellow – 1 long  AUX #2 #3 (Trunk) Press & Hold 1X NO PAGE BACK  PANIC #1 (Lock) Pres
                    
                    Summary of the content on the page No. 6 
                    
                        OPERATING INSTRUCTIONS - ALARM    Active Arming / Locking:  Press and release button #1 (Lock symbol) on the transmitter.  The system will arm and confirm with one siren  chirp, one light flash, and the LED will begin to flash.  Power locks will lock (if equipped).  Starter disable circuit  will turn on.  After a short delay to allow the vehicle and electronics to settle, the system is completely armed.    Disarming: / Unlocking   Press and release button #2 (Unlock symbol) on the transmitter.  
                    
                    Summary of the content on the page No. 7 
                    
                        OPERATING INSTRUCTIONS - ALARM    Alarm Triggering  An intrusion into the vehicle or hard impact to the body will sound the alarm and flash the lights for 1 minute.   After 1 minute the trigger cycle will automatically stop and alarm will remain armed to continue protecting the  vehicle.  If a door is left open after an intrusion then the unit will cycle a maximum of 5 minutes and continue to  protect the other un-tampered or unopened zones.    Prior intrusion Alert  This system will notify you 
                    
                    Summary of the content on the page No. 8 
                    
                        OPERATING INSTRUCTIONS - ALARM    Remote AUX. Output 2 (Optional)  This system contains a second auxiliary output to activate other accessories or devices.  To activate the  systems’ Second Auxiliary Output, press and hold Button #3 (Trunk Symbol) on the transmitter for more than 2  seconds.  This is a momentary output that will stay active as long as the remote button is held down.  Remote  output #2 requires programming before operation.  Check with your installer or follow programming option 
                    
                    Summary of the content on the page No. 9 
                    
                        OPERATING INSTRUCTIONS - ALARM    Optional M.A.P. (Mobile Accessories Protection)  This system can be programmed to provide Crimestopper’s unique M.A.P. (Mobile Accessories Protection)  feature that allows you to prevent unauthorized access of your vehicles Audio, Cellular, Navigation, or  Entertainment systems.  This feature is OPTIONAL and will requires extra parts and labor for installation.   Consult your installation dealer about MAP before or during installation.  The CS2012TW1 must be  pr
                    
                    Summary of the content on the page No. 10 
                    
                        REMOTE ENGINE CONTROL    REMOTE ENGINE STARTING - SUCCESSFUL START DIAGRAM:  SOLID FLASH 1X AFTER START IGN 3 STARTER SEC. THEN SOLID   REMOTE ENGINE STARTING - UNSUCCESSFUL START  In the event that the engine does not start on the first attempt, the system shuts down for a few seconds, then  nd rd attempts to restart the engine a 2 and 3 time.  For hard starting engines, the unit will allow a starter crank  time of up to10 seconds maximum.  This should provide ample cranking time for difficult 
                    
                    Summary of the content on the page No. 11 
                    
                        REMOTE ENGINE CONTROL    ENTERING YOUR REMOTE STARTED VEHICLE:  1) With engine running, Remote Unlock/Disarm system (If armed) or open door with key.  2) Enter vehicle and be careful not to step on brake pedal!  (Remote Start Reset)  3) Turn Ignition to ON/RUN position, then press brake pedal to reset the Remote Starter & Shift out of park.  4) Remote starter will reset instantly when the brake is pressed.  Parking lights will turn off and the ignition key  is now controlling your vehicle.    ID
                    
                    Summary of the content on the page No. 12 
                    
                        REMOTE ENGINE CONTROL    INFINITY RUN MODE  This mode allows the vehicle’s engine to remain running INDEFINITELY.  This mode can be beneficial to law  enforcement vehicles or commercial vehicles that need to remain running unattended for long periods of time.    INFINITY RUN MODE – EXITING THE VEHICLE:  1) Follow steps on the last page for “IDLE DOWN MODE - EXITING THE VEHICLE”, except press the remote  start button TWO times at STEP #1.  2) Parking Lights will start flashing instead of coming o
                    
                    Summary of the content on the page No. 13 
                    
                        REMOTE ENGINE CONTROL    TIMED SELF START MODE  This mode allows the vehicle to be programmed to self-start every 4 hours and run for the programmed run  time. This can be helpful during extremely cold conditions where engine fluid freeze-up is a concern.  THE  VEHICLE MUST BE OUTDOORS OR IN A WELL VENILATED AREA.      TIMED SELF-START MODE – EXITING THE VEHICLE:  1) Have engine running with the Key, then press and release the Start button.  2) Within the next 10 seconds press the valet/program 
                    
                    Summary of the content on the page No. 14 
                    
                        OPTIONAL TURBO TIMER MODE    OPTIONAL TURBO TIMER MODE:  IMPORTANT NOTE: This mode requires the use of an extra part called a momentary switch or button  that is not included with the kit.  Check with your installer about adding this feature.  The optional  Turbo Timer mode allows the your system to keep your vehicle running for 1 to 5 minutes [selectively]  after you remove the key, exit the vehicle, and lock the doors remotely [if you own a Turbo or Turbo  Diesel].  This is handy for turbo coo
                    
                    Summary of the content on the page No. 15 
                    
                        ANTI CARJACK PROTECTION    REMOTE OPERATED CARJACK PROTECTION  This feature provides Active Carjack protection through the remote control.  When the Ignition is on (vehicle is  running), press and hold the #1 LOCK Button and #3 TRUNK Button for 3 seconds. The parking lights will  flash 2 times and the LED will begin to flash rapidly to confirm the beginning of a Carjack countdown.  30  Seconds later, the unit will begin a Carjack Cycle consisting of 20 seconds of pre-warning chirps turning into 
                    
                    Summary of the content on the page No. 16 
                    
                        TRANSMITTER PROGRAMMING     Note:  Remotes Transmitters come pre-programmed from the Factory.  When re-learning remotes or  adding remotes, ALL your system’s remote codes must be learned at time of programming!!  This  system allows storage of up to 4 different remote codes in memory.    1. Open hood (ground the Blue hood pin wire if no hood pin is installed.)  2. Turn key to the ON position. (Starting the vehicle is not necessary.)  3. Press Program/Valet button 4 times.  After a few seconds, t
                    
                    Summary of the content on the page No. 17 
                    
                        PAGER REMOTE BATTERY REPLACEMENT    CS-2012TW1 PAGER (LOW BATTERY WARNING)  The CS-2012TW1 Pager LED has a low battery warning system.  When the battery voltage is low, the Orange  & Green LEDs flash 6 times with any button that is pressed. We recommend replacing the battery for proper  operation.  To replace the battery, simply unlock and slide open the battery door on the back of the LED  remote.  Carefully remove the low battery, then insert a new battery (AAA) using the outline on the button
                    
                    Summary of the content on the page No. 18 
                    
                        TROUBLESHOOTING: “BEFORE YOU CALL SECTION”    Before calling your dealer or Crimestopper, read the following for tips that may remedy the problem.    RANGE QUESTIONS (2-Way Pager/Remote):  Your CS-2012TW1 system uses Am & FM High-Frequency signals to send/receive data between the pager  and the vehicle and from the vehicle to the remote for state-of-the-art operation.  1) Under normal operation, the distance from the vehicle-paging-the-remote will be greater than that from the  remote-to-the-veh
                    
                    Summary of the content on the page No. 19 
                    
                        TROUBLESHOOTING cont.    UNIT FLASHES THE LIGHTS ONCE AND WILL NOT ATTEMPT A REMOTE START:  The system is in Valet mode.  Check the systems LED light and if it is on solid Red LED (with doors closed)  then the system is in VALET mode.  To exit VALET, turn the Ignition on, press and hold valet/programming  button for about 5 seconds until LED goes out.  Unit is now out of valet mode and should perform a remote  start.    SYSTEM DOES NOT RESPOND TO THE REMOTE CONTROL:  1. Check for proper power/gr
                    
                    Summary of the content on the page No. 20 
                    
                                                                                   www.crimestopper.com     email@crimestopper.com  ONLINE TECHNICAL SUPPORT   Phone (800) 998-6880  www.crimestopper.com/techweb03.html   FAX (805) 581-9500    © 2005 Crimestopper Security Products