Summary of the content on the page No. 1
Table of Contents
Preface ...............................................................................................................................1
Chapter 1 Installation........................................................................................................2
Unpacking ............................................................................................................................................. 2
Viewing Angle Adjustment.................................
Summary of the content on the page No. 2
Important Safety Instructions Please read the following instructions carefully. This manual should be retained for future use. 1. To clean LCD Monitor screen; -- Power off LCD Monitor and unplug the AC Cord. -- Spray a non-solvent cleaning solution onto a rag. -- Gently clean the screen with dampened rag. 2. Do not place the LCD Monitor near a window. Exposing the monitor to rain water, moisture or sunlight can severely damage it. 3. Do not apply pressure to the LCD screen. Exce
Summary of the content on the page No. 3
Interface for Arm Applications Before installing to mounting device, please refer to Fig.1-2. The rear of this LCD display has four integrated 4 mm, 0.7 pitches threaded nuts, as well as four 5 mm access holes in the plastic covering as illustrated in Figure 1-3. These specifications meet the VESA Flat Panel Monitor Physical Mounting Interface Standard (paragraphs 2.1 and 2.1.3, version 1, dated 13 November 1997). Note :Please using Ø 4mm x 8mm (L) screw for this application. Figure
Summary of the content on the page No. 4
Setting Up the LCD Monitor 1. Turn on the LCD monitor’s hard power switch, located on the back of the monitor. (See Fig. 1-8) 2. Turn on the LCD Monitor's soft power switch, located on the bezel of the monitor. Figure 1-8 Power Management System This LCD Monitor complies with the VESA DPMS (version 1.0) Power Management guidelines. The VESA DPMS provides four power saving modes through detecting a horizontal or vertical sync. signal. When the LCD Monitor is in power saving mode, th
Summary of the content on the page No. 5
Function Description Ico Function Function Description n Brightness 101 scales of brightness are available to choose from (0 to 100). Contrast 101 scales of contrast are available to choose from (0 to 100). H. Position This function let's you adjust the display's horizontal position V. Position This function let's you adjust the display's vertical position. This function let's you select the images sharpness. Five selections are Sharpness available. A smoother setting is more suita
Summary of the content on the page No. 6
adjusted from the OSD menu Temperature. 6
Summary of the content on the page No. 7
Chapter 3 Technical Information Specifications LCD Panel Fujitsu Size 19" (48 cm) Display Type Active matrix color TFT LCD Resolution 1280 x 1024 Display Dot 1280 x (RGB) x 1024 Display Area (mm) 376.32 x 301.056 (H x V) Display Color 16.7M 2 Brightness 300 cd/m (typical) Contrast Ratio 700:1 (typical) Response Time Ta=25°C Tr=15ms Tf=10ms Lamp Voltage 750 Vrms (typical) Lamp Current 7.0 mA rms. (typical) Viewing Angle Vertical: -85° ~ +85° Horizontal: -85° ~ +85° Video Inpu
Summary of the content on the page No. 8
Sync Input Signal Separate TTL compatible horizontal and vertical synchronization Polarity Positive and negative Plug & Play Supports VESA DDC2B functions External Connection Power Input (AC input) 1.8M power cord Video Cable 1.8M with 15-pin D-sub connector Audio Cable 1.8M with Stereo Jack Environment Operating Condition: Temperature 5°C to 40°C/41°F to 104°F Relative Humidity 20% to 80% Storage Condition: Temperature -20°C to 60° C/-4°F to140° F Relative Humidity 5% to 85% Power
Summary of the content on the page No. 9
Standard Timing Table If the selected timing is NOT included in table below, this LCD monitor will use the most suitable available timing. H. Freq. V. Freq. Pixel Freq. H/V Sync. Resolution Mode (KHz) (Hz) (MHz) Polarity 640 x 350 31.469 70.087 25.175 +/- VGA-350 640 x 400 24.830 56.420 21.050 -/- NEC PC9801 640 x 400 31.469 70.087 25.175 -/+ VGA-400-GRAPH 640 x 400 31.50 70.15 25.197 -/- NEC PC9821 640 x 480 31.469 59.940 25.175 -/- VGA-480 640 x 480 35.00 66.67 30.24 -/- APPLE MAC
Summary of the content on the page No. 10
Input Signal”. 10
