Summary of the content on the page No. 1 
                    
                        E-1
PACKING CONTENTS INTRODUCTION
The package contains: This microprocessor-based, digital control 15-in.
• CRT monitor (M/T 6331) color monitor is a high-performance, easy-to-use
 ac power cord product.  This monitor  uses a mini-neck CRT to
 User manual reduce power consumption  during normal operation.
It also employs the latest on-screen-menu technology.
The microprocessor capability offers 13 most
UNPACKING
commonly used factory-preset VESA timing modes,
and eight modes for the user to ad
                    
                    Summary of the content on the page No. 2 
                    
                        E-2 INSTALL THE POWER CORD  Check first to make sure that the power cord you MONITOR use is the correct type required for your area.  To connect the tilt/swivel base to the monitor, align hooks with the sockets on the bottom side  This monitor has a universal power supply that of the monitor, and gently push the base towards allows operation in a 100/120 V ac or 220/240 V the front of the monitor. ac voltage area. No user-adjustment is required.  The 15-pin D-shell signal connector on the si
                    
                    Summary of the content on the page No. 3 
                    
                        E-3 USER CONTROLS AND INDICATORS ab c 2 1 a. Displays menu & exits menu 1. Power LED b. Scrolls through menu to choose an icon 2. Power ON/OFF switch for adjustment / Adjusts level of selected icon c. Confirms menu selection 113393-0A-E.pm6 3 8/1/00, 6:38 PM                                                                                                                                                                                                                                                  
                    
                    Summary of the content on the page No. 4 
                    
                        E-4 USING THE ON-SCREEN MENU 1 1) Menu screen-press the      button to display the menu below and exit menus Select mark Press the           button to move the selection mark to the desired location. Adjustment icons 2 When the     button is pressed. 1 :     CONTRAST     : 2 The selected adjustment screen appears. The item presently CONTRAST BRIGHTNESS H.SIZE H.POSITION being adjusted is V.SIZE V.POSITION PINCUSHION TRAPEZOID shown. ROTATION COLOR LANGUAGE DISP.FREQ. DEGAUSS RECALL H.MOIRE V.MOI
                    
                    Summary of the content on the page No. 5 
                    
                        E-5 VERTICAL SIZE adjustment INDIVIDUAL Fills the viewable area vertically. ADJUSTMENT Press the     button to make the image smaller, CONTRAST adjustment or press the     button to make it larger. Press Adjust the screen contrast to match your the     key toggles between VERTICAL SIZE 2 personal perference. and VERTICAL POSITION. Press the     button to decrease contrast and press the     button to increase it. VERTICAL POSITION adjustment Direct operation: You can access the Shifts the image o
                    
                    Summary of the content on the page No. 6 
                    
                        E-6 COLOR selection MANUAL DEGAUSSING The white in the image can be adjusted. After moving the selector to the degauss icon, O 1) Use the          button to select: (1)9300 K, press the      button. The degaussing action 2 O (2)6500 K or (3)the user’s preferred color. takes place a few seconds later. 2) If the (3):the user’s color is selected, “2” NOTE: A sharp snap noise may be heard when appears in the lower right of the On-Screen degaussing occurs. This is normal. Menu. Press the front     bu
                    
                    Summary of the content on the page No. 7 
                    
                        E-7 TROUBLESHOOTING SERVICING If your monitor fails to operate functionally, it might Refer all servicing to qualified service personnel. be possible to correct the problem by making simple Serious shock hazards exist within the covers of checks as follows: this monitor. Do not open the covers under any circumstances- Problem Check and Adjust there are no  serviceable parts inside. Blank screen · Monitor power switch, (* NOTE) power cord, signal cable, or connector · computer power switch SIGNAL
                    
                    Summary of the content on the page No. 8 
                    
                        E-8 TECHNICAL SPECIFICATIONS Power Input 1 5- in. visual dia gona l S cree n S ize Viewab le screen size 13.8" Voltage 100 to 240 V AC Anti-Glare Coating** Fre que ncy 50 - 60 Hz Curre nt Dot Pitch 0.28 mm (0.01 in.) 1.8 A Rating Dis play Are a Default 196 x 262 mm Power (7.7 x 10.3 in.), typica l 70 W (maximum) C onsumption Full Scan 211 x 282 mm (H x W) (8.3 x 11.1 in.), de pends on signal timin g 371 x 391 x 399 mm D is play Colors I nfinite Dimension (14.6 x 15.4 x 15.7 in.) Max. R es olutio
                    
                    Summary of the content on the page No. 9 
                    
                        E-9 PRESET MODES Resolution H. Freq. V. Freq. Resolution H. Freq. V. Freq. Mode Mode (H x V) (KHz) (Hz) (H x V) (KHz) (Hz) 1 720 x 400 31.4 70 8 1024 x 768 48.3 60 2 640 x 480 31.4 60 9 800 x 600 53.6 85 3 640 x 480 35.0 66 10 1024 x 768 56.4 70 4 800 x 600 37.8 60 11 1024 x 768 60.0 75 5 640 x 480 37.5 75 12 1280 x 1024 64.3 60 6 640 x 480 43.3 85 13 1024 x 768 68.6 85 7 800 x 600 46.8 75 113393-0A-E.pm6 9 8/1/00, 6:38 PM