Manual do usuário Harbor Freight Tools TRAILER JACK 41006

Resumo do conteúdo contido na página número 1

2000 Lb. Ring Mount
Trailer Jack
Model 41006 41006 41006
41006 41006
Assembly & Operating Instructions
www.HarborFreight.com
®
Copyright 1999 by Harbor Freight Tools . All Rights Reserved.
No portion of this manual or any artwork contained herein may be reproduced in any
manner, shape or form without the express written consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.

Resumo do conteúdo contido na página número 2

SPECIFICATIONS MODEL # 41006 TRAILER JACK Weight Capacity: 2000 Lbs. Minimum Height: 9-7/8” Maximum Height: 20-3/4” Lift Distance: 10-7/8” Skid Dimensions: 7-5/8” x 4-1/16” o Swivel Capacity: 360 Material: Zinc-plated Steel Overall Dimensions: 29-7/8”H x 7-5/8”L x 4-3/4”W Net Weight: 13.38 Lbs FEATURES OF THIS TRAILER JACK 1. Strong steel construction, with enclosed gear. 2. Lockable swivel base for convenient towing and jacking. 3. Top crank makes lifting trailer very easy. 4. Skid foot di

Resumo do conteúdo contido na página número 3

SPECIAL WARNINGS WHEN USING THIS TRAILER JACK Using this Jack may create special hazards. Take particular care to safeguard yourself and those around you. 1. Roll Away. Avoid situations which allow the trailer to roll away on the skid and trailer wheels. If using the trailer jack on an incline, be sure to chock the wheels. Never leave the trailer unattended while on the jack if possibility of roll-away exists. 2. Overloading. Never attempt to lift or support loads in excess of the rated stren

Resumo do conteúdo contido na página número 4

INSTALLATION NOTE: Do not drill holes or otherwise damage the trailer tongue when installing this Jack. Failure of the trailer tongue may result. NOTE: Installing this Jack is most easily done with the Trailer mounted on the towing vehicle hitch. 1. Measure the trailer tongue for the best location to mount the Jack. Remember that the Jack must not interfere with the Vehicle or trailer when turning or passing over speed bumps, boat ramps, etc. 2. Adjust the Coupling Tube so the Jack is in the lo

Resumo do conteúdo contido na página número 5

Using the Jack to mount the trailer to the towing vehicle (continued) 5. Turn the Crank Handle (#5) counterclockwise to lower the Jack slightly, transferring the trailer’s weight onto the towing vehicle. 6. Pull out the Locking Pin (#6) and rotate the Jack into its upright position. Reinsert the Locking Pin into the Coupling Tube/Tongue Adapter. 7. Check all connections and remove wheel blocks before driving the vehicle. MODEL # 41006 TRAILER JACK #10 Snap Ring (not shown) #8 Tongue Adapter