Resumo do conteúdo contido na página número 1 
                    
                        PPM608
8-Channel, 2 x 500 W Professional Powered Mixer
O W N E R ’ S M A N U A L                                                                                                                                                                                                                                                                                                                                                                                                                                    
                    
                    Resumo do conteúdo contido na página número 2 
                    
                        Important Safety Instructions 1.	 Read 	 these	 instructions.		 19.NOTE: 	 	 This	 equipment	 has	 been	 tested	 and	 found	 to	 comply	 with	 2.	 Keep 	 these	 instructions. the	 limits	 for	 a	 Class	 B	 digital	 device,	 pursuant	 to	 part	 15	 of	 the	 FCC	 Rules.	 These	 limits	 are	 designed	 to	 provide	 reasonable	 protection	 3.	 Heed 	 all	 warnings. against	 harmful	 interference	 in	 a	 residential	 installation.	 This	 equip- 4.	 Follow 	 all	 instructions. ment	 generates,	 uses,	 
                    
                    Resumo do conteúdo contido na página número 3 
                    
                        Owner’s Manual Ready, steady, go! Read This Page! 1. Turn the channel level, mon 1, and FX/mon 2  We realize that you must be really keen  controls fully down. to try out your new powered mixer, but  2. Turn down the compressor controls (ch. 1–4). please read the safety instructions on  page 2, and this page first.   3. Set all the EQ controls to the center, including  the graphic EQ sliders.  4. Turn down the main level and monitor 1 level  Setup controls, and turn on the powered mixer. The PPM
                    
                    Resumo do conteúdo contido na página número 4 
                    
                        Introduction • 12-segment stereo output meters on main mix,  Thank you for choosing a Mackie professional  and mono meter on monitor 1 powered mixer. These powerful mixers are designed to  meet the needs of almost any small to medium-sized  • Break switch mutes all mono channels club, meeting room, sanctuary, or outdoor gathering. • Speakon and 1/4" power amp outputs  At Mackie, we know what it takes to be roadworthy.  • Precision passive switch for enhanced clarity  After all, our mixers have t
                    
                    Resumo do conteúdo contido na página número 5 
                    
                        Owner’s Manual Contents IMPORTANT SAFETY INSTRUCTIONS ........................ 2   MASTER CONTROLS READ THIS PAGE! .................................................... 3 31. POWER LED ........................................... 20 INTRODUCTION ...................................................... 4 32. MAIN MASTER GRAPHIC EQ ................... 20 HOOKUP DIAGRAMS............................................... 6 33. FX TO MAIN .......................................... 20 REAR PANEL FEATURES ...
                    
                    Resumo do conteúdo contido na página número 6 
                    
                        Hookup Diagrams   Front Panel Power Amp Mode switch set to Rear Panel Stereo Main Microphones press HI-Z button press HI-Z button Adjust Vocal Compression Keyboards Portable Recorder SRM450v2 Powered Stage Monitors (plays mon 1 output) Passive Speakers (plays stereo main mix) Powered Subwoofers (plays main mix below 100 Hz) This diagram shows microphones attached to channels 1 and 2, electric guitars connected directly to  channels 5 and 6 (with hi-z switch pressed in), and a keyboard attached t
                    
                    Resumo do conteúdo contido na página número 7 
                    
                        Owner’s Manual Microphones Acoustic Guitar and Mic Front Panel Power Amp Mode switch set to Mains/Mon 1 Rear Panel press HI-Z button Adjust Vocal Compression Drum Machine Power Amplifier C200 Passive Stage Monitors dual-mono (plays mon 1 output) mode Keyboards SRM150 Powered Monitor (plays mon 1 output) C300z Passive Speakers Passive Subwoofers House System (plays main mix below 100 Hz) (plays mono main mix) This diagram shows microphones attached to the mic inputs of channels 1 to 4, an electri
                    
                    Resumo do conteúdo contido na página número 8 
                    
                        Wireless Microphone Microphones Front Panel Power Amp Mode switch set to Stereo Mains Rear Panel Graphic EQ TM iPod Docking Station Wireless Mic Receiver Mackie d.2 Pro DJ Production Console HD1521 HD1521  Powered Powered Speaker Speaker MAIN OUT BOOTH FX PGM 2 PGM 1 MIC PHONO CD PHONO CD SEND L R L L R L L L L LINE MIC R R R R LIVE RETURN RECORD R L(MONO) R LINE LINE ~100-240 VAC 50-60Hz 20W GND GND L PHONO PHONO R Passive Speakers (plays stereo main mix) Turntables with phono-level output Powe
                    
                    Resumo do conteúdo contido na página número 9 
                    
                        Owner’s Manual Microphones Front Panel Power Amp Mode switch set to Mon 1/Mon 2 Rear Panel press HI-Z buttons Adjust Vocal Compression Send HD1531 HD1531  Return Guitar Processor Powered Powered (connected to INSERT) Speaker Speaker C200 Passive Stage Monitors (plays mon 2 output) Keyboards C300z Passive Stage Monitors (plays mon 1 output) Powered Subwoofer Powered Subwoofer Electronic Drum Kit (plays right main mix) (plays left main mix) This diagram shows microphones attached to the mic inputs
                    
                    Resumo do conteúdo contido na página número 10 
                    
                        Rear Panel Features 4 2 6 3 6 1 5 1. POWER CONNECTION 3. SPEAKER-LEVEL OUTPUTS This jack accepts the supplied 3-prong IEC AC power These output connections provide speaker-level  cord. output power from the internal power amplifiers to your  passive speakers.  The power output of the PPM608 is  Before you plug the AC power cord into the  300 watts rms per channel into 4 ohms. powered mixer, make sure that the voltage of  your unit is the same voltage as your local AC Only passive loudspeakers sh
                    
                    Resumo do conteúdo contido na página número 11 
                    
                        Owner’s Manual • 1/4" TS outputs are wired Tip positive, and  5. VENTILATION and REAR PANEL Sleeve negative. Ventilation holes in the rear panel and the bottom  SLEEVE SLEEVE TIP panel allow the internal fans to flow breezy and minty- fresh cooling air over the internal power amplifiers. Do  TIP TIP not obstruct these holes, or the amplifiers may overheat  and shut down.  SLEEVE Do not remove the feet, as these keep the  1/4" TS Connection powered mixer off the ground for ventilation.  These two
                    
                    Resumo do conteúdo contido na página número 12 
                    
                        Front Panel Features 11  12  14  10  8 9  13  7  Patchbay section 7. MIC INPUTS This is where you plug in things such as: microphones,  We use phantom-powered, balanced microphone  line-level instruments, guitars, and effects, a recorder,  inputs just like the big studio mega-consoles, for exactly  PA system, powered monitors, powered subwoofer etc.  the same reason: This kind of circuit is excellent at  (The speaker-level outputs from the internal power  rejecting hum and noise. You can plug in
                    
                    Resumo do conteúdo contido na página número 13 
                    
                        Owner’s Manual PHANTOM POWER 12. INSERT (CH. 1 to 6) Most modern professional condenser mics are These unbalanced 1/4" jacks on channels 1 to 6 are for  equipped for phantom power, which lets the mixer connecting serial effects processors such as compres- send low-current DC voltage to the mic’s electronics sors, equalizers, de-essers, or filters. The insert point  through the same wires that carry audio. (Semi-pro is after the gain switch [28] and compressor circuits  condenser mics often have 
                    
                    Resumo do conteúdo contido na página número 14 
                    
                        15 17  19 20  16 18  If they want "more me, and less Keith," you can turn  15. FX/MON 2 SEND OUTPUT  up their channel's FX/mon 2 control, and turn down  1 This /4" TRS line-level output can be used to feed an  Keith's. (If you were using monitor 1 to feed the stage  external effects processor (FX) or a second set of stage  monitor, then you would adjust the mon 1 control [21]  monitors (mon 2). The output from here is a copy of  on each channel.) what goes into the internal FX processor, being t
                    
                    Resumo do conteúdo contido na página número 15 
                    
                        Owner’s Manual (The main mix still plays the full frequency range,  EFFECTS: SERIAL OR PARALLEL? this sub output is just a mono copy of the range below  “Serial” means that the entire channel signal  100 Hz for external subwoofers.) leaves the mixer (insert [12] send), is routed  through the effects device, and returns to the  19. MAIN OUTPUTS  mixer (insert return). Examples: compressor,  limiter, graphic equalizer. Line-level sources can also be  These 1/4" balanced TRS outputs supply the ster
                    
                    Resumo do conteúdo contido na página número 16 
                    
                        21  22  23  24  25  26  27  28  29 30 30  Channel Controls “U” like Unity gain Mackie mixers have a “U” symbol on almost every level  The eight vertical channel strips look very similar,  control. It stands for “unity gain,” meaning no change in  with only a few differences between them. Each chan- signal level. The labels on the controls are measured in  nel works independently, and just controls the signals  decibels (dB), so you’ll know what you’re doing level- plugged into the inputs directl
                    
                    Resumo do conteúdo contido na página número 17 
                    
                        Owner’s Manual 21. MON 1 CHANNEL EQUALIZATION (EQ) This control allows you set up a nice monitor mix, The PPM608 channels have 3-band equalization: low  independent of the main mix or the monitor 2 mix. shelving, mid peaking, and high shelving. It’s probably  Adjust these controls on each channel until your band is all the EQ you’ll ever need! Shelving means that the  happy with the stage monitor mix. The controls are off circuitry boosts or cuts all frequencies past the specified  when turned f
                    
                    Resumo do conteúdo contido na página número 18 
                    
                        21  22  23  24  25  26  27  28  29 30 30  26. OVERLOAD (OL) LED 28. GAIN SWITCH This LED will come on when the channel’s input Press this in (low) if you are connecting a line-level  signal is too high. This should be avoided, as distortion input source to channels 1 to 6. will occur. Press this out (high) if you are connecting a micro- If the LED is coming on regularly, check that the gain phone-level signal to channels 1 to 8, or a instrument- switch [28] is set correctly for your input device
                    
                    Resumo do conteúdo contido na página número 19 
                    
                        Owner’s Manual 29. COMPRESSOR +20 Channels 1 to 4 have an in-line compressor circuit  with a variable threshold. This is very useful for com- pression of vocals, for example. +15 When the incoming signals exceed the threshold level  set by this knob, the signal level is automatically com- +10 pressed. This reduces the dynamic range, and reduces  the chance of distortion due to overloading the input  +5 signals. +0 Dynamic range is the difference in level be- tween the quietest part of your song 
                    
                    Resumo do conteúdo contido na página número 20 
                    
                        Master Controls As with the channel EQ, just take it easy.  31  There is a large amount of adjustment, and  if you are not careful, you can upset the  33  delicate balance of nature. Although it may  36  not seem cool to actually turn down controls,  with EQ it is often your best option. Turn  32 down the offending frequency range, rather  34  than boost the wanted range. You can reduce  35  the level of some frequency bands where  feedback occurs. 38 With this constant–Q graphic  41 EQ, the ban