Resumo do conteúdo contido na página número 1 
                    
                        INSTRUCTION MANUAL
FM741B
VACUUM CLEANER
Contents
IMPORTANT SAFETY INSTRUCTIONS
1
NAME OF EACH PART
3
PREPARATION BEFORE USE
4
USING THE VACUUM CLEANER
6
USING THE ATTACHMENTS
8
EMPTYING THE DUST COMPARTMENT 9
CLEANING THE FILTERS 10
CLEARING BLOCKAGES IN THE
    
11
SUCTIONHOSEANDCLEANINGTHE
    
AGITATORASSEMBLY
 
REPLACEMENTINSTRUCTIONS
12
 
TROUBLESHOOTING
16
REPLACEMENTPARTS 16
 
LIMITEDWARRANTY 17
 
HOUSEHOLD USE ONLY                                                                         
                    
                    Resumo do conteúdo contido na página número 2 
                    
                        IMPORTANT  SAFETY  INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following.                                          READ ALL INSTRUCTIONS                         BEFORE USING THIS VACUUM CLEANER WARNING - To reduce the risk of fire, electric shock or injury: 1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet     when not in use and before servicing. 2. Do not use outdoors or on wet surfaces. 3. Do not allow
                    
                    Resumo do conteúdo contido na página número 3 
                    
                        16. Do not touch the agitator while it is spinning. 17. Do not place any heavy items on top of the vacuum cleaner. 18. Do not step on the hose or pull it too strongly. 19. Do not pick up items such as pieces of waste paper or cloth which look as     though they may cause the hose to become blocked. 20. Do not clean or store the vacuum cleaner in places where there are high     temperatures. 21. Store the vacuum cleaner away from excessive humidity. 22. When carrying the vacuum cleaner, hold it b
                    
                    Resumo do conteúdo contido na página número 4 
                    
                        NAMES OF EACH PART FRONT REAR Handle  Suction  Power Cord  Release Hose A Plug Button C Release  Plug shown in figure Button A Power Cord may differ from actual Release  plug attached to unit Carrying Handle Button B for your area. Duster  Knob    ON/OFF Switch  Cord Storage Hooks Dust Crevice Tool Compartment Hose Holder Wand Filter  Suction  Cover Hose B Upholstery Tool  & Dusting Brush Handle Release  Holder  Headlight Lever Rug/Floor (Tools) Mount SELECTOR Set the ON/OFF switch to " ON " to 
                    
                    Resumo do conteúdo contido na página número 5 
                    
                        PREPARATIONS BEFORE USE Caution:  Do not connect the power cord plug to the wall outlet until assembly                    is completed. Attaching the handle Set the vacuum cleaner lnsert the handle 1 2 to the upright position. as shown in the illustration. Handle Attaching the suction hose A & attachments Suction Hose A Wand Hose Cuff Suction Inlet Crevice Tool Upholstery Tool & Dusting Brush 4                                                                                                       
                    
                    Resumo do conteúdo contido na página número 6 
                    
                        PREPARATIONS BEFORE USE  WINDING THE POWER CORD Wind the power cord around the cord  Hook the  power cord over 1 2 the clip which is located on storage hooks. the upper  cord storage hook as shown. Secure  the  power cord plug on the  Plug Side power cord.  Cord  Storage Hooks Clip RELEASING THE POWER CORD Return the hook to the  Rotate the upper cord  storage  hook 1 2 upright position before downward. attempting to rewind the  power cord. Upper Cord Storage Hook INSERTING THE POWER CORD PLUG W
                    
                    Resumo do conteúdo contido na página número 7 
                    
                        USING THE VACUUM CLEANER ON/OFF SWITCH Start or stop vacuum cleaner by pushing  on the switch. ON/OFF Switch OFF ON ADJUSTING THE HANDLE The handle of this vacuum cleaner can be set to one of  three positions -Upright, Normal, Parallel. Place your foot on handle release lever as shown and pull back on the handle  until it releases from its upright position. Handle Release Lever Normal position Upright position This position is used for normal cleaning. The handle is normally locked in this posit
                    
                    Resumo do conteúdo contido na página número 8 
                    
                        USING  THE  VACUUM CLEANER  RUG/FLOOR (TOOLS)SELECTOR The RUG/FLOOR(TOOLS)selector should only be adjusted while the vacuum cleaner is turned on and in the upright position. When cleaning a rug or carpet,first  RUG 1 turn the ON/OFF switch to the ON  position,and then set the RUG/ FLOOR(TOOLS)selector to the  RUG position. Rug/Floor (Tools) SELECTOR When cleaning a bare floor or when using FLOOR 2 one of the attachments,set the RUG/FLOOR (TOOLS)selector to the FLOOR position. Caution: Do not cha
                    
                    Resumo do conteúdo contido na página número 9 
                    
                        USING  THE ATTACHMENTS Caution:  When using one  of  the attachments during cleaning,set the vacuum                   cleaner  to  the  upright position.       Remove the attachments from the   1 vacuum cleaner. Wand  Crevice Tool Press the release button C to  2 disconnect  the handle from the Release  vacuum cleaner. Button C        Caution:             When removing the attachments, pull         them in the directions shown in the          illustration.Pulling them in the wrong        directi
                    
                    Resumo do conteúdo contido na página número 10 
                    
                        EMPTYING THE DUST COMPARTMENT Caution:  Be sure to turn the ON/OFF switch to the "OFF" position and disconnect the                   power cord from the wall outlet before cleaning. Empty  the dust compartment when Press the release button A meanwhile  2 2 1 1 press the release  button B to remove  contents reach the MAX mark. the dust compartment. MAX mark Turn the duster handle several times in the  Press the release lever to open the  3 3 4 4 direction shown to empty the dust trapdoor. compar
                    
                    Resumo do conteúdo contido na página número 11 
                    
                        CLEANING THE FILTERS Remove the dust compartment.(refer to page 9) 1 Set the dust compartment to the parallel  2 position.Open the trapdoor,then push the  release button E and pull out the main filter. Release Button E The main filter and prefilter  will be  removed at the same time. Caution: Do not push the release                   button E at the upright position. 3                  As this may drop or damage the                  main filter and prefilter. Clean the main filter and prefilter 
                    
                    Resumo do conteúdo contido na página número 12 
                    
                        CLEARING BLOCKAGES AND CLEANING  THE AGITATOR ASSEMBLY Caution: Be sure to turn the ON/OFF switch to the "OFF"  position and disconnect                   the  power cord  from the  wall outlet before clearing any blockages in the                   suction hose and cleaning the agitator assembly. Cleaning blockages  Cleaning blockages in the suction hose A, B Suction Hose A Set the vacuum cleaner to the upright position. 1         Hose Cuff Remove the hose cufffrom the suction inlet and        2 
                    
                    Resumo do conteúdo contido na página número 13 
                    
                        REPLACEMENT  INSTRUCTIONS Caution:   Be sure to turn the ON/OFF  switch to the"OFF" position and disconnect  the                    power  cord  from the wall outlet  before  replacing  any  of the parts below.  REPLACING THE HEADLIGHT LAMP Set the vacuum cleaner to the parallel  position. 1             Loosen the screws to remove the lens. Screw 2                      Lens When removing the headlight lamp, be careful 3 not to pull on the headlight lamp wiring.                          Remove th
                    
                    Resumo do conteúdo contido na página número 14 
                    
                        REPLACEMENT  INSTRUCTIONS Caution:  Be sure to turn the  ON/OFF  switch to the"OFF" position and  disconnect  the                   power cord from the wall outlet  before replacing any of the parts below. REPLACING THE FLAT BELT Remove the bottom plate.  1 (refer to page 14) Lift out the agitator assembly,and then remove the flat belt from the motor shaft and                2 theagitatorpulley.      Motor Shaft Flat Belt Agitator Assembly Place  a  new flat belt onto  the  motor shaft and  pull
                    
                    Resumo do conteúdo contido na página número 15 
                    
                        REPLACEMENT  INSTRUCTIONS REMOVING THE BOTTOM PLATE    Set the vacuum cleaner to the  Pull here 1 parallel position and turn it over.         Slidethelatchinthedirection Press Press Latch    2 ofthearrow.   Removethebottomplatebypulling        3 thetabsasillustrated.       Bottom Plate REATTACHING THE BOTTOM PLATE Insert the projection on the bottom plate Push the bottom plate as shown. 1 2  into the groove on the nozzle housing  Press and set the bottom  plate  in place. Press Bottom Plate Proj
                    
                    Resumo do conteúdo contido na página número 16 
                    
                        REPLACEMENT INSTRUCTIONS REPLACING THE FILTER   Under normal usage, the HEPA Filter will require replacement once every     three (3) months, however, vacuuming large amounts of extremely fine dust,               powder or similar material over a long period of time may decrease airflow                              performance through the filter. If this occurs, it may become necessary to                            replace the HEPA Filter more often. Only use genuine FANTOM replacement filters. 
                    
                    Resumo do conteúdo contido na página número 17 
                    
                        TROUBLESHOOTING If there is a problem with the vacuum cleaner, carry out the following checks to find the cause. If the problem still persists after the checks have been made, do not use the vacuum cleaner to prevent the possibility of an accident occurring. Turn the ON/OFF switch to the "OFF" position, disconnect the power cord from the wall outlet, and contact FANTOM Customer Service at 1-800-275-9251. Or visit our website at www.fantom.com Problem                                Cause         
                    
                    Resumo do conteúdo contido na página número 18 
                    
                        ONE (1) YEAR LIMITED WARRANTY FANTOM warrants this product to be free from defects in material and workmanship for a period of one (1) year  from the  date  of the  original purchase,  when  utilized for  normal  household use,  subject  to the  following  conditions, exclusions and exceptions. If your appliance  fails to operate properly  while in use under norma l household conditions within  the warranty period, return the complete appliance and accessories, freight prepaid to In US:  FANTOM,