Resumo do conteúdo contido na página número 1 
                    
                        MUSTANG SURVIVAL
MANUFACTURER'S MANUAL
MD3075 Inflatable PFD  
 Manual Inflation Model  
 Recreational: USCG Approved Type III
INFLATABLE PERSONAL FLOTATION DEVICE
WE SAVE LIVES FOR A LIVING
DO NOT REMOVE PRIOR TO SALE                                                                                                                                                                                                                                                                                          
                    
                    Resumo do conteúdo contido na página número 2 
                    
                        CONTENTS Page  1 Approval Conditions and Carriage Regulations    1 Mandatory Carriage Requirements    1 What is an Inflatable PFD?    2 Instructions for Use     2 Component Inspection Instructions     2 Readiness Checklist     3 Sizing and Fit     3 Donning Instructions     4 Inflating Your Inflatable PFD     5 Deflating the Inflatable PFD     6 Usage Below Freezing     6 Re-arming Your PFD (MD3075)     8 Repacking    9 Is Your PFD in Good and Servicable Condition?    9 Care and Maintenance Inst
                    
                    Resumo do conteúdo contido na página número 3 
                    
                        APPROVAL CONDITIONS AND CARRIAGE REQUIREMENTS This Inflatable PFD is approved by the U.S. Coast Guard (USCG) for use  as a Type III (Model MD3075) Personal Flotation Device (PFD). It is not  approved for water skiing or other high impact, high-speed activities.  This Inflatable PFD was designed to be more comfortable and less  restrictive to wear than inherently buoyant PFDs. When worn, used, and  serviced according to this owner’s manual, this Inflatable PFD can greatly  increase your chances o
                    
                    Resumo do conteúdo contido na página número 4 
                    
                        INSTRUCTIONS FOR USE This manual supplies instructional, maintenance and safety information  for model MD3075 unless specified otherwise. The model number is  listed on the underside label.  Congratulations on your Inflatable PFD purchase.  Component Inspection Instructions 1) Examine the service indicator through the window panel  (Fig. 1).  Ensure the service indicator is green. If the service indicator is red,  the mechanism has been fired or is incorrectly fitted (see Re-arming  Your PFD (p.
                    
                    Resumo do conteúdo contido na página número 5 
                    
                        n Inflatable PFD is not twisted. n Oral-inflation dust cap is in the stowed position (Fig. 6). n "Jerk to inflate" tab exits bottom of pouch. Your Inflatable PFD is ready for use if all applicable boxes are checked. NOTE: Contact your Mustang Dealer if you have any concerns  about the readiness of your Inflatable PFD. Sizing and Fit This PFD provides a minimum of 33.7 lbs of buoyancy when inflated and  is designed for wearers over 16 years of age, with a chest range of 30-52  inches (76-132 cm) 
                    
                    Resumo do conteúdo contido na página número 6 
                    
                        Deployment and Use of the PFD (Fig2, Step 3-6) Inflating then donning 1) Either pull out the bladder from fabric casing, then inflate orally, or  pull sharply on tab to inflate. 2) Put over head. 3) Tie the tie tapes at neckline Donning then inflating 1) Pull out the bladder. 2)  Put over head. 3) Pull sharply on tab to inflate or inflate orally. 4) Tie the tie tapes at neckline. Inflating Your Inflatable PFD It is recommended that the following procedures be followed to inflate  your Inflatable
                    
                    Resumo do conteúdo contido na página número 7 
                    
                        the Inflatable PFD by mouth (Fig. 4) should inflation not occur, or if  you are in a non-emergency situation. To orally inflate the Inflatable  PFD, first locate the oral inflation tube by opening the cover panel  of the Inflatable PFD. Remove the dust cap from the end of the oral  tube and blow into the tube until the Inflatable PFD is fully inflated.   Place the oral inflator dust cap back in the stowed position (Fig. 6). WARNING: Avoid double inflation (CO cylinder inflation after  2 full ora
                    
                    Resumo do conteúdo contido na página número 8 
                    
                        FIGURE 6 FIGURE 5 Oral Inator Cap In  Dust cap Dust cap  Deflate  in stowed position for  Position position deation Usage Below Freezing When the temperature is below freezing, the Inflatable PFD should  be worn partially inflated because a fully discharged cylinder may not  quickly or adequately inflate your Inflatable PFD. Under these conditions  use the oral inflator to adequately top-up the PFD, after CO inflation. 2 WARNING: CO inflation could over-pressurize and damage your  2 Inflatable
                    
                    Resumo do conteúdo contido na página número 9 
                    
                        FIGURE 7 3F Manual Inflator MD3085 Manual Inflator Cylinder Step 2 Sensor Ring Step 3 Bayonet Tab Step 4 O-Ring Step 3 Service Lever Indicator Step 4 Step 5 Service Indicator If green, unit is operable If red, stop and service unit 4) Raise, and hold, the lever into the inflator housing. Install a new  cylinder/bayonet assembly by engaging bayonet tabs in housing,  pushing in then turning clockwise 1/8 turn to a full stop (Fig. 8).  WARNING: PFD WILL ONLY INFLATE IF CYLINDER IS  TURNED TO A FULL
                    
                    Resumo do conteúdo contido na página número 10 
                    
                        6) Refold the Inflatable PFD in accordance with the Repacking section  (p. 9).  YOUR INFLATABLE PFD (MD3075) IS NOW READY FOR MANUAL USE  Repacking Gently squeeze the Inflatable PFD until all air or gas has been expelled  (Fig. 5). Do not wring or twist the Inflatable PFD. Put the oral tube dust  cap back in its stowed position on the oral inflation tube (Fig. 6). NOTE: Before following the repacking sequence, be sure to  properly re-arm your Inflatable PFD. 1)   Lay the bladder and pouch out on
                    
                    Resumo do conteúdo contido na página número 11 
                    
                        4)   Without twisting, fold the bladder over once and place into the  centre of the pouch between the two wings (Fig.9). Ensure the  yellow inflator pulltab is positioned so it hangs out from the bottom,  TM between the Velcro closure. 5)   Position so that green indicator is visible through window. 6)  Ensure yellow pulltab is still hanging out the bottom of the pouch. TM 7)  Close Velcro at bottom of pouch. IS YOUR PFD IN GOOD AND SERVICEABLE  CONDITION? Check your Inflatable PFD between outin
                    
                    Resumo do conteúdo contido na página número 12 
                    
                         ii)  Ensure the manual pull-tab is accessible.   iii)  Visually examine your Inflatable PFD for damage or excessive  abrasion, wear, tear or contamination. Particular attention must be  paid to the stitching, straps and hardware. If in doubt, send it to your  Mustang dealer for evaluation and/or servicing. 2) Every Two (2) Months:  i)  Leak Test: The Inflatable PFD should be tested for general leakage  by orally inflating your Inflatable PFD until firm and let stand for 16  hours.  A leaking In
                    
                    Resumo do conteúdo contido na página número 13 
                    
                         iv)   Perform the Leak Test. See the Leak Test in the Every Two (2)  Months Care and Maintenance Instructions section.  v)  Ensure the service indicator is green (Fig. 1).  vi)  Record as an "Annual" inspection in permanent ink on the Care  and Storage label, in the Date Maintained column. Repack the Inflatable PFD as outlined in the Repacking section (p. 8). WARNING: If you are not confident in the self-inspection and  servicing of your Inflatable PFD in accordance with these  instructions, ta
                    
                    Resumo do conteúdo contido na página número 14 
                    
                        HOW AND WHY TO TEST YOUR PFD Inflate your Inflatable PFD and try it out in the water to: Make sure it floats you:  	 •	 Comfortably	 (when	 worn	 properly)  	 •	 Adequately	 for	 expected	 w ave	 conditions	 (body	 shapes/densities	 	 	 	 	    affect performance) Make sure it works:  	 •	 A	 flow	 of	 bubbles	 should	 not	 appear	 (see	 CARE	 AND	 	 	 	 	 	         MAINTENANCE INSTRUCTIONS for leak tests p. 9). It should            inflate quick and easily. Learn how it works by:  	 •	 Activ ati
                    
                    Resumo do conteúdo contido na página número 15 
                    
                        back of vertical. In a relaxed floating position, verify that your mouth  is well above the water’s surface. Note the effect of where you hold  your legs and how you float. 6) Get out of the water and remove the Inflatable PFD. Completely  deflate the Inflatable PFD using the oral inflator (see Deflating the  Inflatable PFD p. 5). Remove the CO cylinder/bayonet assembly  2 from the inflator.  7) Let the Inflatable PFD dry thoroughly. Re-arm & Repack the PFD (p. 6). HOW DO YOU TEST YOUR PFD USING
                    
                    Resumo do conteúdo contido na página número 16 
                    
                        WEAR YOUR PFD In approximately 80 percent of all boating fatalities, the victims were not  wearing a PFD. Most fatal accidents happen on calm sunny days. This  Inflatable PFD is much more comfortable to wear than other PFD types.  Get into the habit of wearing this Inflatable PFD. Non-swimmers and children especially should wear a hybrid or non- Inflatable PFD at all times when on or near the water. HYPOTHERMIA Prolonged exposure to cold water causes a condition known as  hypothermia - a substan
                    
                    Resumo do conteúdo contido na página número 17 
                    
                        2) Do not attempt to swim unless it is to reach a nearby craft, fellow  survivor, or a floating object on which you can lean or climb.  Swimming increases the rate of body heat loss. In cold water, drown- proofing methods that require putting your head in the water are  not recommended. Keep your head out of the water. This will greatly  lessen heat loss and increase your survival time. 3) Use the standard H.E.L.P. position when wearing an Inflatable PFD,  drawing the legs up to a seated positio
                    
                    Resumo do conteúdo contido na página número 18 
                    
                        3) Try your wearable Inflatable PFD on and adjust it until it fits  comfortably in and out of the water. 4) Mark your Inflatable PFD with your name if you are the only wearer. 5) Do not alter your Inflatable PFD. If it doesn’t fit properly, get one that  does. An altered device is no longer Coast Guard approved. 6) Your Inflatable PFD is not intended for use as a fender or kneeling  pad. 7) If your Inflatable PFD is wet, allow it to dry thoroughly before storing  it. Store it in a well-ventilate
                    
                    Resumo do conteúdo contido na página número 19 
                    
                        of the aircraft operator, one small carbon dioxide cylinder fitted into  a self-inflating jacket, plus one spare cartridge, may be carried by a  passenger or crew in checked or carry-on baggage. Please refer to the governing body’s documentation, found online at  http://hazmat.dot.gov. 17 Inflatable PFD Owner’s Manual                                                                                                                                                                                     
                    
                    Resumo do conteúdo contido na página número 20 
                    
                        WE SAVE LIVES FOR A LIVING www.mustangsurvival.com  ollt free 1.800.526.0532   email custserv@mustangsurvival.com Mustang Survival and seahorse design is a registered trademark of Mustang Survival Corp. Our commitment to quality has earned our Burnaby facilities ISO 9001 registration,   the highest of all international standards. This is our guarantee you’re receiving the ultimate  in design and manufacturing. HT-3075 (Rev 10Aug2011)