Manual do usuário Seagate CHEETAH ST336605LC/LCV

Resumo do conteúdo contido na página número 1

on the daisychain, you can leave this drive’s SCSI ID set to 0 and pro-
ceed to the next step.
 The host system’s SCSI controller usually uses SCSI ID 7.
Cheetah 73LP Installation Guide
 If you have an LC or LCV model drive, the host normally sets the ID over
Model ST373405LW/LC/LWV/LCV, ST336605LC/LCV
the I/O interface, so you don’t need to worry about this step.
SCSI interface disc drive
 Some systems provide a cable designed to connect to the J5 jumper
block on the drive to remotely set th

Resumo do conteúdo contido na página número 2

inoperable. A low level format, with verify turned on, will typically take two J2 Drive with Pin 1 hours for ST373405 models and 90 minutes for ST336605 models. HDA up, PCB down, viewed from front Pin 1 Protect against power failure or other power interruptions during the format. Reserved Positions HDA a. Turn on DC power to the host system. Delay Motor Start option (valid only if the Enable Motor Start b. Boot the system from a system floppy, CD, or from a previously installed J6 jumper is