Inhaltszusammenfassung zur Seite Nr. 1
PRODUCT GUIDE
MODEL 463230510
IMPORTANT: Fill out the product record information below.
Serial Number
See rating label on grill for serial number.
Date Purchased
For support and to register your
grill, please visit us at
www.charbroil.com
If you have questions or need
assistance during assembly,
please call 1-800-241-7548.
Estimated assembly time: 35-40 minutes
The following are trademarks registered by W.C. Bradley Co. in the U.S. Patent and Trademark Office: Caldera®; Charcoal2Go®; Char-
Inhaltszusammenfassung zur Seite Nr. 2
TABLE OF CONTENTS DANGER For Your Safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3 If you smell gas: Grilling Guide. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7 Use and Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8-13 1. Shut off gas to the appliance. Limited Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14 2. Extinguish any open flame. 3. Open lid. Parts List. .
Inhaltszusammenfassung zur Seite Nr. 3
WARNING CAUTION CALIFORNIA PROPOSITION 65 Using pots larger than 6 quarts in capacity could 1. Combustion by-products produced when using exceed weight limit of the this product contain chemicals known to the State of side burner shelf or side shelf, California to cause cancer, birth defects, and other reproductive harm. resulting in failure 2. This product contains chemicals, including lead of grill cart components. and lead compounds, known to the State of California to cause cancer, birth
Inhaltszusammenfassung zur Seite Nr. 4
GRILLING GUIDE – Getting Started Temperature The temperature gauge in the hood of your new grill measures air temperature. The air temperature inside your grill will never First Time Use be as hot as the temperature at the cooking surface. Read your Assembly Manual and ensure the grill is put together properly. Remove all Point-of-Purchase advertising material from Note: Since 1995, all regulators (the part that attaches to the gas all grill surfaces before first use. We recommend oper
Inhaltszusammenfassung zur Seite Nr. 5
Rotisserie Cooking GRILLING GUIDE – Grilling 101 Rotisserie cooking is best for 'round' meat, such as large roasts, whole poultry, and pork. It generally requires an accessory motor Outdoor grilling is really quite simple. You'll succeed with and spit rod that allows the meat to be turned at a constant burgers, dogs, or steaks usually on your very first try. With speed. Rotisserie cooking is best done in front of a special experience, you will learn how to work with your grill, creati
Inhaltszusammenfassung zur Seite Nr. 6
Wood Chips GRILLING GUIDE – Tips & Tricks For extra smoke flavor when grilling, try adding wood chips. Cooking on your new grill is a hands-on experience, and it is Soak the chips in water for approximately 30 minutes before recommended to remain outside with your grill while cooking. adding to a smoke box or pan. Place smoke box or pan on top of Grilling can be affected by many external conditions. In cold the cooking grate above the flame. Turn grill on high until the weather, you wi
Inhaltszusammenfassung zur Seite Nr. 7
Cooking surfaces: If a bristle brush is used to clean any of the GRILLING GUIDE – Cleaning Your Grill grill cooking surfaces, ensure no loose bristles remain on cooking Why Clean? surfaces prior to grilling. It is not recommended to clean cooking We've all heard the saying, “an ounce of prevention is worth a surfaces while grill is hot. pound of cure.” This is great advice when it comes to keeping your grill clean. Storing Your Grill • Clean cooking grates. Routine Care • Store grill in dr
Inhaltszusammenfassung zur Seite Nr. 8
LP Cylinder USE AND CARE •The LP cylinder used with your grill must meet the following requirements: •Use LP cylinders only with these required measurements: 12" DANGER (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum. • NEVER store a spare LP cylinder under or near •LP cylinders must be constructed and marked in accordance the appliance or in an enclosed area. with specifications for LP cylinders of the U.S. Department of Transportation (DOT) or for Cana
Inhaltszusammenfassung zur Seite Nr. 9
e s i w k LP Cylinder Exchange Connecting Regulator to the LP Cylinder •Many retailers that sell grills offer you the option of replacing 1.LP cylinder must be properly secured onto grill. (Refer to your empty LP cylinder through an exchange service. Use only assembly section.) those reputable exchange companies that inspect, precision fill, 2.Turn all control knobs to the OFF position. test and certify their cylinders. Exchange your cylinder only for an OPD safety feature-equipped cylinder
Inhaltszusammenfassung zur Seite Nr. 10
Straight Leak Testing Valves, Hose and Regulator 1.Turn all grill control knobs to OFF. 2.Be sure regulator is tightly connected to LP cylinder. 3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding. 4.Brush soapy solution onto areas circled below, or other similar Hold coupling nut and regulator fittings on your grill. as shown for proper connection
Inhaltszusammenfassung zur Seite Nr. 11
Safety Tips s Before opening LP cylinder valve, check the coupling nut for WARNING tightness. s When grill is not in use, turn off all control knobs and LP cylinder valve. For Safe Use of Your Grill and to Avoid Serious s Never move grill while in operation or still hot. Injury: s Use long-handled barbecue utensils and oven mitts to avoid • Do not let children operate or play near grill. burns and splatters. s Maximum load for sideburner and side shelf is 10 lbs. • Keep grill area clear an
Inhaltszusammenfassung zur Seite Nr. 12
Ignitor Lighting (continued) Burner Flame Check 8. For grills equipped with ELECTRONIC IGNITION at • Remove cooking grates and flame tamers. Light burners, rotate each burner: knobs from HI to LOW. You should see a smaller flame in Repeat steps 4 through 6 to light each burner. LOW position than seen on HI. Perform burner flame check 9. Once each burner has ignited, turn knobs to desired setting. on sideburner, also. Always check flame prior to each use. If only low flame is seen refer to "S
Inhaltszusammenfassung zur Seite Nr. 13
3. Remove carryover tubes and burners. 4. Detach electrode from burner. CAUTION NOTE: Removal/Detachment method will depend on the burner configuration. See different configurations in SPIDER ALERT! illustrations below. 5. Carefully lift each burner up and away from valve openings. We suggest three ways to clean the burner tubes. Use the one SPIDER AND WEBS INSIDE BURNER TUBE easiest for you. (A) Bend a stiff wire (a light weight coat hanger works well) into a small hook. Run the hook throug
Inhaltszusammenfassung zur Seite Nr. 14
LIMITED WARRANTY This warranty only applies to units purchased from an authorized retailer. Manufacturer warrants to the original consumer-purchaser only that this product shall be free from defects in workmanship and materials after correct assembly and under normal and reasonable home use for the periods indicated below beginning on the date of purchase*. The manufacturer reserves the right to require that defective parts be returned, postage and or freight pre-paid by the consumer for re
Inhaltszusammenfassung zur Seite Nr. 15
PARTS LIST Key Qty Description Key Qty Description A 1 FIREBOX PP 1 LEFT DOOR B 5 MAIN BURNER-TUBE BURNER QQ 1 RIGHT DOOR C 1 MAIN BURNER-BAR BURNER RR 2 HANDLE, F/ DOOR D 1 ELECTRODE, F/ TUBE BURNER SS 1 LOWER BACK PANEL E 1 ELECTRODE, F/ BAR BURNER TT 2 TANK EXCLUSION WIRE F 4 CARRY OVER TUBE UU 1 GREASE TRAY G 1 CONTROL PANEL, MAIN VV 1 GREASE PAN H 1 ELECTRONIC IGNITION MODULE WW 4 CASTER SOCKETS I 1 BUTTON, F/ IGNITION MODULE XX 2 CASTER, LOCKING J 1 SHEILD, F/ ELECTRONIC IGNITION MODULE YY
Inhaltszusammenfassung zur Seite Nr. 16
PARTS DIAGRAM N X CCC W W W W Q P C B B V B V V B B E V V O U D F F F F R DD A S T H I BB J JJ FF EE KK KK KK KK KK G CC AA Z HH M M M M M K M L L L L L L II UU Y OO LL GG SS BBB RR M L ZZ RR ZZ VV TT MM TT QQ WW PP WW NN XX YY AAA BBB 16
Inhaltszusammenfassung zur Seite Nr. 17
ASSEMBLY • Place bottom shelf between side panels with cut out hole for LP cylinder on left. Attach to left and right side panels with (4) 1/4”-20x2-3/8” machine screws and 1/4”-20 flange nuts at front, and (2) 1/4”-20x2-3/8” machine screws and 1/4”-20 1 1 flange nuts at rear. For Front Door Brace Assembly Left Side Panel Right Side Panel 1/4"-20x2-3/8" Machine Screw Qty. 6 1/4"-20 Flange Nut Qty. 6 Bottom Shelf • Place lower back panel between side panels as shown. Attach to left and right s
Inhaltszusammenfassung zur Seite Nr. 18
• Hook tank exclusion wire onto the metal taps on lower back panel, attach other ends to bottom shelf with #8-32x3/8” sheet metal screws. 3 Lower Back Panel #8-32x3/8" Sheet Metal Screws Qty. 2 Metal Tap • Place front door brace as shown. Attach to left and right side panels with 1/4"-20x2-3/8" machine screws and 1/4”-20 flange nuts. 4 1/4"-20 Flange Nut Qty. 4 1/4"-20x2-3/8" Machine Screw Qty. 4 Front Door Brace 18
Inhaltszusammenfassung zur Seite Nr. 19
• Turn assembly upside down. • Attach the two fixed casters to left leg and the two locking casters to right leg. 5 Use the provided caster wrench to fully tighten casters. Caster Wrench Locking Caster Fixed Caster Right Side Panel Left Side Panel 19
Inhaltszusammenfassung zur Seite Nr. 20
• Stand cart upright. • This step requires two people to lift and position grill head onto cart. 6 • Carefully lower the grill head onto the cart. Make sure the regulator hose is hanging outside the cart. Attach with 1/4”-20x1/2” screws. Right side panel removed for clarity Grill Head 1/4"-20x1/2" Screw Qty. 4 20
