Manual de instrucciones de Dakota Digital LED Tail Lights for 1959 Chevrolet Impala, Bel Air, Biscayne LAT-NR241

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS
LAT-NR241
LED Tail Lights for 1959 Chevrolet Impala, Bel Air, Biscayne.

MAN# 650212

Kit Includes:

Installation:

1. Remove the original bulb sockets.

2. Remove the tail light housing hardware so the housing can be removed from the car.
3. Remove the chrome trim from the tail light housing. The outer trim is snapped into place and
will need to be gently pried off with a flat blade screwdriver or similar tool.

4. Next remove the

Resumen del contenido incluido en la página 2

6. Remove the round mounting plate from the bottom of the LED assembly. It is attached with two lock nuts. Note that there are 4 different assemblies. The left and right side sets are mirrored. 7. Pass the wires through the housing where the original bulb and socket were. Set the LED assemblies into the housing so the two studs extend out the hole in the bottom of the housing. 8. Feed the wires through the larger hole in the mounting plate. Be careful when feeding the wires thr

Resumen del contenido incluido en la página 3

13. Cut off the existing light socket as it will not be used. Do not strip the wires. Trim the wires from LED assembly to appropriate length once mounted, making sure wires are routed cleanly and securely. 14. Use the supplied moisture resistant pigtail connectors* to attach the wires from the new LED assembly to the existing vehicle harness. Insert appropriate wire from vehicle harness and mating LED assembly wire into a connector and crimp following instructions below. *For the bes